Find an experienced gas fitter in Inner South Melbourne

I have a smeg gas cooktop with one burner not igniting.The burner has gas flow, but there is no spark from the ignition electrode.The other burners are working normally.

Some burners work, some only partially light, one doesn’t stay on

I need a gas safety check done on a one-bedroom apartment as a rental provider. The only gas appliance is a gas cooktop/oven, so it's a small, straightforward job. The check needs to cover all gas installations and fittings in line with compliance with the official gas safety check record provided. Essential: You must be a licensed or registered gasfitter holding the "Gas Servicing Type A" endorsement on your Plumber's Identity Card. Please state your licence number and confirm your Type A endorsement in your bid. I may ask to see your card. What I need: Full gas safety check to AS 4575 covering the cooktop/oven and all gas fittings and pipework Written gas safety check record/certificate provided on completion Digital copy emailed to me for my records Location: Glen Iris Timing: Preferably this week. Let me know your availability.

Need to run a gas line to the outdoors so that I can hook my bbq to it.

I need a certified gas fitter to help with the following Isolate all gas fittings in a three bedroom house ready for a demolition and renovation project. The works include: - Isolation and removal of gas piping of a gas kitchen hob (isolation point to be make clear of proposed wall removal). - Isolation and removal of gas piping of an in wall gas heater (isolation point to be make clear of proposed wall removal likely in floor). - Isolation of gas heater wall/floor mounted - retention and testing of current gas water heater. - Identifying of any other gas appliances that requiring making safe before demolition. - Certification for works.

I have a gas pipe and a air duct sticking out of the wall and I’d like them removed and then pushed deeper into the wall so that I can plaster over and repaint the section

I have restaurant in bentleigh. Fryer ( natural gas) need to connect to gas line. Existing restaurant

One of the oak was not working and 2 stoves in 4 burners stove are not working resently we had deep clean in restaurant so there might be some gas supply fault or any minor issues

Gas fitter to install my supplied Beefeater natural gas conversion kit on BBQ. Existing outdoor gas line is already connected and working. Installation and testing required.

Disconnect gas bbq and move to front lawn

I bought a new Colman BBQ and I need it assembled, converted to natural gas and connected to an existing gas point. I can buy the conversion kit or you can bring it, please let me know your preference. A certificate is required to maintain warranty. I already have the BBQ but I’m flexible on date and time.

Looking for a licensed gasfitter who can: 1) Disconnects and removes the gas connection from existing cooktop. 2) Permanently caps the gas pipe beneath the cooktop. 3) Performs a gas leak test and issues any required compliance documentation.

Need approximately 10 empty Gas Bottles cut in half. Taps have also been removed. Sizes range from small to the largest being a 9 kg gas Bottle. The photos are an example of what I need done. They won’t be the exact bottles in the photos. can deliver to you

I want an assessment of cost for replacing the gas cooktop in my kitchen with an electric cooktop.

Just need 1 gas pipe capped no longer in use but just want to get rid of the old pipe.

Taking along time for gas to get up to the cooktop. Thought to be faulty regulator. Want the regulator replaced

I have a LNG connect outdoor BBQ / kitchen that I wish to move and convert back to LPG. I need the gas connection disconnected from BBQ, then terminated / closed and the BBQ converted to LPG with regulator and valves changed. I have the manufacturer supplied valves for LPG conversion.

Got two small jobs, ideally same visit: Connect a gas BBQ to an existing gas point – I've already got the conversion kit. Install a mixer tap (tap supplied) onto existing hot/cold points. All the gas, hot, cold and drainage points are already in place - photos attached. Just needs connecting/fitting. Please respond by email with: 1. Your quote 2. When this can be done or any questions you may have

Looking for a licensed plumber and electrician (or a team capable of both trades) to carry out works associated with a new kitchen installation in Mordialloc. The kitchen layout will remain largely unchanged, with the sink, oven, cooktop and dishwasher staying substantially in their current locations. Electrical works: - Disconnect existing appliances during demolition. - Supply and install a dedicated circuit from the switchboard for a new induction cooktop. - Wire and connect the induction cooktop. - Reconnect existing electric oven. - Relocate or install any required power points. - Test and provide compliance certificates. Plumbing / Gas works: - Disconnect and permanently cap the existing gas line to the cooktop. - Install and connect the new sink and mixer tap. - Reconnect dishwasher. - Carry out any minor plumbing adjustments required to suit the new cabinetry. - Test and certify works where required. The work will need to be completed in stages and coordinated with the kitchen installers: - Initial disconnects during demolition. - Rough-in after old kitchen removal. - Final fit-off after cabinets and benchtops are installed. Kitchen installation dates are currently TBA, so some flexibility will be required. Please quote only if suitably licensed and insured. Experience working alongside kitchen installers is preferred. Location: Mordialloc, VIC.

There is a copper gas pipe sticking out of the ground already, it just needs to be fitted off with a shut off valve and hose to connect my BBQ to it