Find a reliable cooktop installation and repair service in NSW

Remove existing gas cooktop, cap the gas line and install similar sized induction cooktop. Will need to also install 30amp cable from metre box, run it under the house about 10-15m

Location: Bankstown, NSW ​Task Description: I am looking for a licensed gas plumber to replace my current Fisher & Paykel gas cooktop with a new unit. ​Please note the following details for the job: ​Safely disconnect and remove the existing Fisher & Paykel gas cooktop. ​Install and connect the new gas cooktop. ​Test the gas line and ensure the new unit is fully operational. ​Important: My oven situated underneath is also a Fisher & Paykel model, but it is not being replaced. It needs to remain in place and undisturbed during the cooktop installation. ​Dispose of the old cooktop and any packaging from the new unit. ​Please confirm you are fully licensed and can provide a compliance certificate upon completion.

My electric cooktop has cracked and needs replacing. You need to source a new one and install / replace the broken one.

Need to get the old gas cooktop removed and new one installed.

Two bathroom exhaust fans, one cooktop exhaust fan need to be replaced

Description: Need a licensed NSW electrician for kitchen appliance fit-off. All cabinets/appliances in place, circuits already run. Scope of work: 1. Install Bosch electric oven HBF134EB0A — Hardwire to existing dedicated circuit already in oven cavity. Test & commission. 2. Install Bosch ceramic cooktop PKE611BA2A 6.6kW — Hardwire to new 32A dedicated circuit. Supply + install 32A double-pole isolator switch on splashback/within 2m. Test & commission. 3. Replace rangehood GPO — Swap existing 10A GPO inside overhead cabinet with new 10A GPO with switch. Plug in rangehood + test. Already completed by previous sparky: • New safety switch/RCD installed • New dedicated circuits run for oven + cooktop • Switchboard upgraded You must provide: • NSW electrical licence # in quote • Certificate of Compliance for Electrical Work (CCoE) on completion • Fixed price quote including all parts + CCoE Location: Sydney, NSW - Willoughby Access: Easy parking, appliances on site, cabinets ready Timeframe: Flexible next few weeks. Photos attached of kitchen, oven cavity with cable, cooktop cutout, and rangehood GPO location. Budget: $450- inc GST — Please quote fixed price

Replacing like for like cooktop. Need a qualified electrician to do the job

Replace gas cooktop Provide any required complaint certificate Dispose old cooktop Share both options inclusive of all and other just labour if I provide the new cooktop.

Remove existing gas cooktop and replace it with a new one which I will provide. Measurements 59cm x 51cm

Need 1 gas stove burner to be repaired (see photo). When turned on, the fire doesn't stay lit. Other 3 works fine

Gas Cooktop Repair – Gas Valve Stuck Open One of the gas burner control valves on our cooktop has failed and is stuck in the open position. The affected burner is the top right burner. When the gas supply is turned on, gas flows continuously from this burner regardless of the knob position. For safety, the gas has been isolated at the mains. Looking for a licensed gas fitter/appliance repair technician to inspect and replace the faulty gas valve (or advise if another repair is required). Please provide a quote

I am replacing an old all-in-one electric stove with a separate ceramic cooktop and under-bench oven. There is an existing stove connection cable available in the kitchen, which I believe is connected to a 40 amp stove circuit. The new appliances are: 60 cm ceramic cooktop, approximately 6,000 W / 25 A, hardwired Under-bench oven with a standard 10 A plug

Remove current Devanti cooktop and install Bosch PKE611CA3E Electric hob, 60 cm, Black, Built in, Serie 2 https://www.bosch-home.ie/en/mkt-product/cooking-baking/induction-electric-hobs/electric-hobs/PKE611CA3E

Replace cooktop with new one Bigger size to fit the hole properly Cooktop cable needs the plug on the end to be reattached

Bought a new 5 Burner gas cooktop. Need to replace the old one. Both are 90cm gas Cooktop. Old -Cutout Size(WxDxH) 820x450(mm) New 860*490

Install freestanding oven and gas cooktop and must take away old one. *Location Marsden Park NSW 2765 Need to be licensed plumber and gas fitter

I need a certified person to come by and: 1. Uninstall existing gas cooktop 2. Cut around 20mm to make the new gas cooktop fit 3. Install new gas cooktop Please refer to images

QUOTE NEEDED We are renovating our kitchen and have removed the old kitchen. We need to disconnect the gas line to the old gas stove top as we are putting in an electric stove top. The gas connection is on the floor. We are keeping the gas heating around the rest of the house. Have put $50 in the ad but happy to pay more if required once you have a look at the job. Need done by the weekend.

I need a licensed plumber to replace an existing 60cm gas cooktop ( see attached) with a new “Devanti Gas Cooktop 60cm 4 Burner” The new cooktop is already purchased and ready to install.

We are looking at replacing our current gas cooktop with an induction cooktop. Looking for a licensed electrician to visit our unit to see if this would be feasible at a reasonable cost. If yes, will likely use same Tasker to install the induction cooktop once purchased.