Find a reliable appliance technician in Balgowlah

Bosch tumble dryer needs servicing not drying properly and taking ages to dry

Was working → cleaned → now almost no flow.Shower screen removed/cleaned. Pump runs and steam comes out. most likely solenoid valve block.

Need someone help move a washing machine from Balgowlah to Neutral Bay. Also need the machine to be connected to the water main. May need a hose as well

Our oven doesn’t heat up properly. For example, I will heat it to 200 degrees plus and it still won’t cook things properly.

I need a large rangehood installed for an outdoor bbq . 1200mm wide No venting or anything Just fixing it to a Gyprock wall behind the bbq I need it installed tomorrow (Friday) I can’t get access until around midday

Single story house in Balgowlah has x3 gas heater bayonet fittings that haven't been used in ~6yrs (since split system A/C was installed). Gas is connected to the property for cooking. I want someone qualified to inspect/check the fittings to make sure they're good to start reusing as new tenant prefers using a gas heater. Must have experience.

Swap location of washing machine and tumble dryer in order that the doors of both will open. Washing machine will need longer hoses. .

I have the new rubber door seal, just need old one taken off and new one put on

Westinghouse dishwasher coming up with 'F5' error code. appears to be issue with inlet valve.

AEG model BE 4003001M, approx 7yrs old. Need to replace front control panel (as knob markings are wearing away). Already have correct replacement part. No urgency to complete work.

Miele Dishwasher has now power and needs a replacement fuse

Need my washing machine hooked up to waste trap. Currently under sink there are nipples for waste, however I would like a pipe installed that links to opening at top corner of sink.

Fix 4Ddoors Sliding Gate Motor (Gate Stuck Open / Manual Release Won’t Re-Engage) Task description: My 4Ddoors sliding gate motor has stopped working properly. The gate kept trying to close even when fully shut, so I used the manual release (red knob inside the motor housing) to open it. The gate is now open and secure, but I can’t re-engage the motor — the red release knob won’t “catch” back in. I’ve removed and replaced the motor cover, and the power is currently off. I need someone who knows 4Ddoors (or similar sliding gate systems) to: Re-engage the motor clutch correctly Check and reset the open/close limit sensors Test and recalibrate the motor operation Make sure the gate opens/closes smoothly again Model: 4Ddoors sliding gate motor (see photos attached of the unit and interior) Location: [Insert your suburb here] Gate status: Currently open but stable on the track Access: Easy street access, power available What you’ll need: Tools for adjusting the rack and limit magnets/sensors Experience with 4Ddoors or equivalent gate automation units Goal: Get the gate motor re-engaged and running normally again.

Broken oven handle needs fixing and kitchen sink tap is loose

Laundry washer install needs to be completed

I have a small electronic device, with connector for one of its AAA Zbatteries snapped off. I need this re-attached.

Our Electrolux Ultimatecare 300 dryer has started to make screeching sounds when turned on. The drum still turns but is making continuous noises.

Hi, our washing machine has a bad smell and needs to be cleaned.

Fix Dishwasher, Siemens E24

Please could you help fix our broken dishwasher. Drainage issue. Siemens dishwasher error E24