Hire a trusted appliance repair service in North East Melbourne

Fisher and Paykel washing machine seal came off partially

Remove old range hood and install new Solt 90cm Canopy Rangehood Stainless Steel

Roborock Q7 Max+ Repair – “Obstacle Error” Issue Fix Needed need someone experienced with robot vacuum repairs (especially Roborock / smart vacuums) to diagnose and fix my Roborock Q7 Max+. ⚠️ Issue: * Vacuum keeps showing “obstacle error” * It stops in the same areas and refuses to continue cleaning * Sensors may be blocked or faulty, unsure * Already tried basic troubleshooting (cleaning sensors, resetting, etc.) 🔧 What I need: * Full diagnosis of the issue * Fix/repair so the robot can run normally again * Check sensors (LDS / bumper / wheels if needed) * Calibrate or reset system if required * Confirm docking/charging is functioning properly 📍 Location: South Morang (can travel or you can come to me if needed) 🧠 Looking for: * Someone with experience repairing robot vacuums (Roborock preferred) * Electronics / appliance repair background is ideal * Someone who can identify whether it’s a sensor, mapping, or hardware issue

We have a Bosch series 6 super silent machine. Recently it has been making a buzzing/humming noise intermittently during the cycle. I've tried taking out the filter, cleaning, running the hottest cycle etc but it still happens. Seems to be after it drains, like the pump is struggling to put water back in the machine.

I have a Bosch dishwasher with an E:15 error code. I have removed front door and disconnected the float sensor in the drip tray. Just need someone to diagnose where the leak is coming from repair if economical on an older machine.

Water is leaking on the floor when we do our washing

Old Brivis Wombat 120 ducted gas heater experiencing intermittent electrical/control issues. Symptoms: * Heater sometimes randomly starts during the night even when the wall controller is completely OFF. * When this happens, the system only blows cold air. * Repetitive clicking/chattering (“tick tick tick”) sound coming from inside the unit. * Occasionally attempts ignition repeatedly: ignite → flame goes out → retries multiple times → then blows cold air only. * Power reset (turning power off completely for several minutes) temporarily fixes the issue and heater works normally again for some time. * A few weeks ago there was a noticeable electrical/burning smell which triggered the smoke alarm once, although no visible smoke was seen. After leaving the unit powered off for a few days, it worked normally again. * Suspected issue may be related to PCB/control board, relay, transformer, or ignition control.

Fridge in garage tripped the safety switch. Not sure what is wrong with it

Samsung top loader was leaking before and doesn’t spin clothes properly the clothes come out a little damp than usual. Wanting it fixed by tonight or tomorrow if possible

Power trips when fridge starts • Located in Research, VIC Task includes: • Diagnose fault • Repair • Advise if replacement is more cost-effective Requirements: • Experience with fridge/compressor repair • Must bring tools • Electrician

My small Miele dishwasher is not draining/ Working and I really need it back in action as I have 3 young kids

My LG washing machine has a PE error and I think needs a new pressure sensor. I would like someone to come and fix ASAP. Please make an offer if you are interested :)

Hi, I’m looking for someone to repair my washing machine (samsung) model WW85T504DAE\SA 8.5kg Issue: • Display shows: “Check drainage – Clean drain filter (E3)” • Machine is not draining properly / cycle not completing • We have already: • Cleaned the drain filter • Checked for visible blockages What I need: • Diagnosis of the issue • Repair (likely drain pump, hose blockage, or internal issue) Please message with: • Experience with washing machine repairs

Our Asko is having issues drainage. It comes with f11 code and a water drop sogn beneath the timer

The oven fan is working but doesn’t heat up, might be a problem with the element

Washing machine isn’t drying properly keeps showing error message need someone to come urgently tomorrow before 1 or 2pm to fix see photo for error message

Haier dryer showing F32 fault status.

Occasionally throwing error - drain Doesnt clean well

EURO brand dishwasher leaking and showing error code E4. I need it repaired asap.

Reattach Solt washing machine seal and fix E30 error. Already cleaned drain filter from front of machine