Find local mobile mechanics near you

Need mechanic to come check my car 2008 Nissan Altima 3.5 v6 ran the orb. Reader from autozone and it said cylinder 3 misfire and spark plugs and polonium gasket I replaced all that and problem still occurred tan one again I hen said cylinder 5 so I fixed aswell and now the problem still occurs I need someone who knows and has knowledge as a mechanic please

I need control arm put on drivers side

Power steering pump leaks all the fluid out

I’ve installed an AC system in my 1974 FJ40 and need someone with mechanic knowledge to come and confirm it’s all setup correctly. All that’s remaining is the heater pipes, even though I have them in place, and to mount the AC unit up under the dash correctly. I just really want eyes on it to confirm it’s correct before running the engine, and to finish the final steps. I think it’d be no more than 2-3 hours of work. Must have mechanic knowledge and good eye for detail and proper finishes.

I'm pretty sure I accidentally overfilled my oil in my car. I had it running for about 3min. It wouldn't accelerate and started blowing large amount of white smoke. I think I killed it.

clutch and throttle position sensor replacement on 2000 jeep wrangler 4x4 manual 5 speed

Been sitting up for sometime have new stater wires battery I think it’s a small wiring problem

Bikes been sitting and needs regular service. It also doesn't start. When I attended to root cause, the battery was good, the fuel system started, but no turnover or click. I feel it's the starter. I checked all fuses as well. I did not checker starter switch.

My scooter's rear tire is flat, it might have a leak. I have an inner tube, Find someone help me fix it.

Flat rear tire to be changed. I have a new tire and tube.

Meed an ac compressor installed

Flat tire small electric bike. I already have new tire and tube.

Need motorcycle repaired .. When you first started up you got to hold it wide open for It to even start ...it wont idle and dies.. gas comes spurting out of the overflow tube that attaches to the carburetor Research not that I'm a mechanic shows it's the float and needle valve Why do that for 30 bucks when you can buy a carburetor for 42 with throttle cables and choke for 46 dollars and also a tune up of the bike and oil change And get qualified expert help on Air Tasker?

I received a moped I had shipped but I need to put on the front tire and just a couple of other parts. I've never done this before but want to make sure it's done properly before I ride it. Most of it is already together aside from the front tire and a couple of other small parts. Shouldn't take more than 30 minutes to an hour I would think so was hoping someone with mechanical knowledge or experience could help

Motorcycle stalls at idel, stop signs. Engine idles high in neutral, low in gear, then dies when trying to take off. Carburetor was rebuilt but not sure it was done correctly. 1978 cb400a hondamatic hawk.

Car want start and it's not the battery

May have put old fuel on my bike . Problems rose when I would use the choke to warm up the engine. Check engine light went on. I drained the old fuel and changed gas filter but now bike turns off when choke is back . Bike doesn’t even turn on unless with choke and pushing throttle. Most likely clogged . The carburetor screws wore out so I can’t take out the carbereutor to clean it right

I’m not sure what all need to be fixed for him to start using his bike again but pretty sure it’s just a tire and inner tube but I don’t have a car to take it to get it fixed . I don’t have the inner tube and need it done as early as possible today bc I’m taking him to the park

I’m seeking assistance with a full synthetic oil change for my 2013 Volkswagen Jetta SE with a 2.5-liter engine. I already have all the necessary supplies and an oil filter ready to go; I just need someone with the right tools and expertise to help me complete the job. Your assistance would be greatly appreciated!