Find a professional cat flap fitting installer in East London

Custom PVC Window Insert for Cat Flap — Fabrication & Install I need a two-piece removable window insert built from 18mm PVC foam board (e.g. Palight/Foamalux) to house a SureFlap Cat Flap Connect in a vertically sliding sash window. I'm renting so NOTHING can be permanently attached to the window frame — the insert must come out cleanly. WHAT YOU'LL DO: - Source materials: PVC board, stainless bolts (M5/M6), silicone, foam weatherstrip - Cut two panels: Piece A (755x271mm, solid) and Piece B (315x271mm, with cat flap cutout) - Cut a 165x171mm opening in Piece B for the cat flap (50mm border all sides) - Cut a 30mm shiplap overlap where the pieces join — Piece B's tab sits behind Piece A - Drill and bolt through the overlap joint (3-4 bolts) - Seal the joint with silicone, apply foam tape to edges, install in window I PROVIDE the SureFlap Cat Flap Connect unit. You source everything else. KEY DIMENSIONS: - Total insert: 1040mm W x 271mm H x 18mm thick - Visible opening: 1000mm (20mm each side sits in window grooves) - Cat flap cutout: 165 x 171mm - Shiplap overlap: 30mm HOW IT WORKS: The insert is too wide to fit in one piece, so it splits into two panels joined by a bolted shiplap overlap. Piece A angles into the left groove first, then Piece B angles into the right groove with its tab behind A. Slide together, bolt, seal. The window closes down on top to compress a foam strip. See attached diagrams for full details. IMPORTANT NOTES: 1. No permanent modification to the window — silicone is ONLY between the two panels, never on the frame 2. Precision matters — 1040mm total width must be accurate for the grooves. Please measure on-site to confirm 3. Cat flap cutout must be clean and square — the SureFlap frame clamps over it from both sides 4. Test fit before final bolting/sealing See attached diagrams for dimensions, cutout placement, cross-section, and install steps. Straightforward half-day job. Please quote materials + labour.

Cat flap fitting required

Looking for some to fit a cat flap into my upvc kitchen back door

Install microchip cat flap

Install a SureFlap Connect Cat Flap into a wooden door (relatively thick door)

Install a cat flap at the front door

SureFlap cat flap installed in UPVC door.

Installation of sureflap cat flap in wooden back door.

Hi,  I am looking for someone to fit a catflap in the wall see photos of the location.  Postcode is E17 8AG Is this something you can do?  Thanks, Patrick 

Take out the current cat flap and install a new one. New one is bigger so also requires to cut the current wooden door for fitting

I need a cat flap installed in my UVPc door

We have a sureflap microchip cat flap that needs to be installed through quite a thick wall, we have all the hardware you will need. See pictures.

Looking for quotes for a cat flap fitting in pvc back door

Install a cat flap in a glass pane

In a pvc door, can supply extra panel if easier to do it that way

Hole left in wooden door by removing cat flap, Need filling in

Install lockable cat flap in solid wood front door

I would need some help to install our cat flap onto our main door. The door in a PVC door

I have a wood front door so need a small hole cut out and a lockable cat flap installed. I haven’t purchased the cat flap yet

I need to get a cat flap installed