Find professional underfloor heating installation in Hertfordshire

We have a Char Broll Gas BBQ only a few years old. Just turned on for the first time this year and it has very low heat and is not heating fully up. New gas bottle. Might need cleaning of burners according to the instruction booklet. In Bushey WD23

Ford fiesta 2008 1.4 titanium. Put heater on full blast and on hot and it blows cold then there’s a pop ( behind the dash ) and the heat goes very very hot and can’t be controlled by the temperature switch on the control unit. If you turn the heating completely off for a few seconds the pop happens again and you get freezing cold air again until the pop happens.

oven is not working, its not heating and we can hear loud sound when we switch on the oven

Our outside lights broke a few days ago at the same time as our heating controller in our outhouse. Looking for electrician have a look.

Electrician required for connecting wires and fitting thermostat for underfloor heating installed in my launch.

An old back boiler replacement with combi boiler, 8 radiators and pipe work . Labour only. Parts will be provided. Corgi registered please

I had a heat miser put in when we did our house up. For some reason it didn't work. (was set up incorrectly). See below the current set up and what I need put back in. But I also need someone who understands how it works and the logic behind it.

Under floor heating system setup and pressure test. Connect 22 mm flow and return to manifold Connect 16mm underfloor heating pipe to manifold Install heatmiser wiring centre and wire to mains Connect pump Connect 2 port motorised valve Wire actuators x5 Wire 3 thermostats and boiler Fill system and test - Due date: Flexible

Currently using google thermosat and I wanted replace google thermostat with heatmiser thermosat. All parts are already purchased. Just need someone for installation - Due date: Flexible

Thermostat in living room has stopped working. Replacement has been bought, need the old one removed and the new one fitted. - Due date: Needs to be done on Monday, 19 December 2022

We need a person who understands Honey well under floor heating controls. We have a BDR91 receiver to be installed. - Due date: Before Sunday, 6 November 2022

Centr connection in place side finials need fixings - Due date: Flexible

Moved into new house. Heating doesn't seem to be working. Please help. - Due date: Needs to be done on Monday, 7 March 2022

⁃ Install 8m sq electric underfloor heating (polystyrene sheet, foil mat, overlay, thermostat) ⁃ Install 9.12m sq Vinyl click flooring and underlay ⁃Install 2 sets of double plug points - on both sides of the wall ⁃ Cement blocks/slabs for step into the conservatory from the outside - check electrics of the outside light on the right side Install beading after tiling Install hedgehog gutter brush with clips

Can’t turn off the air conditioning or the heater.