Find a local network troubleshooter in West London

Looking for an experienced data technician or electrician to install a point-to-point network extension in the reception area of a dental practice. The job involves running a new Ethernet line around the perimeter of the room to bridge internet from one side to the other. Scope of Work: - Remove Old Trunking: Take down a section of existing surface trunking along part of the path (houses an existing cable). - Install New Trunking: Supply and install approximately 16 metres of new, clean white PVC surface-mounted trunking along the walls. New trunking MT2 26×16mm to house both the existing cable and the new network cable. All trunking corners must be mitre-cut (cut diagonally at 45-degree angles) - Run Cable: Supply and route white Cat6 network cable through the new trunking. No drilling is required. - Install Sockets: Supply, mount, and terminate two white single RJ45 wall sockets (one on each end of the run) along with white surface mounted box so internet can be plugged in on one side and received on the other. - Test: Verify the connection works and then put trunking lids on. • Please bring all necessary material (in white) as well as tools (trunking cutters, punch-down tool, cable tester). • Please leave workspace clean and tidy.

Looking to optimise Wi-Fi signal, particularly in out room above garage (14-15 feet from house) mesh network system in place. Be grateful for a review to optimise.

I suck at home networking. A recent broadband change and the introduction of a NAS has made our WiFi so home a bit of a mess and I’m looking for someone who knows what they’re doing to sort it out

I have a Community fibre provided linksys router and I have added 3 linksys extenders to improve coverage across my 3 floor house. 2 of these 3 extenders have stopped working and just display redlights. I have used Community Fibre support to try resetting these but it has not worked. I bought a new base router (TP-link Archer550) but I cannot get this to register an internet signal from the Community Fibre modem and they have told me they cannot provide support on 3rd party equipment. I need help either getting the original equipment to work or with setting up the new TP-link router I have bought.

I need assistance setting up an extended Ethernet/network cable, connecting it to the extender, and routing it to the backrest. See images for reference.

I have started to network ethernet through the house for two locations upstairs, but fitting (pass-through) RJ45s is not working. I get green lights on the tester but computers don't see internet connection. I think it really needs 'pro level' tools to get the job done right.

I need to change the WiFi network on my HikVision CCTV camera system. I recently got a new broadband provider and need to switch the device across. I have the HikVision NVR system and app. Thanks

I've recently setup a unifi network in my home using a USW Pro 23 POE+ and 6 access points, however it is working but dropping and I am not sure I've set it up correctly

Need to set up my home office, including security using physical VPN, including wi-fi coverage across the home using repeaters, set-up home/office network