Find professional underfloor heating installation near you

My dryer is not heating up

I have a underfloor heating system with Heatmiser controls. One zone is not heating, although the thermostat is calling for heat.

I have an EHC Comet Combi electric boiler power control PCB that is not energising the heating elements. The boiler display shows heating demand, pump and valves operate, but there is 0 volts on all three element outputs (T2, T4, T6) relative to neutral while heating is commanded. This confirms the triac output stage on the PCB has failed. The PCB is fully removed and can be supplied loose for bench testing and repair. What I need: Component-level diagnosis Repair or replacement of the failed triac/driver section Board tested to confirm 230V outputs under load simulation Board details: Electric boiler power PCB 230V AC mains Three switched element outputs via triacs I’m based in Salford and can drop the board off locally.

Underfloor heating has been laid out on the ground floor of the house from corridor to through lounge. I need the downstairs area to be screeded before the flooring can go on. Open to offers/ suggestions.

Hot water is working. Navien Boiler Heating isn't working, possible air lock

leaking pipe under bathroom sink. support with working the central heating system (not broken just need help working it)

Plumbing repair for an electric heating tank which appear to have a leak.

Thermostat shows as heating active but not heating from mat

Service the boiler please

4 curtain poles 2 wall heaters

our downstairs radiators not heating up something to do with thermostat or the valve as upstairs works fine when you use the upstairs panel

Issue with underfloor heating. Thermostat is working, boiler is working (upstairs radiator fine and we have hot water), but looks like there might be an issue with the UFH motorised valve or pump / mixing assembly

No heat after radiator put back on

Our OTN2/OTD2 thermostat is not turning on, the problem is likely a power interruption due to depleted batteries, a tripped circuit breaker, or a wiring fault. 2 other thermostats are working perfectly fine just one isn’t and is affecting the underfloor heating

Install a Drayton Wiser HubR (Single Channel) to my Worcester 28i Junior Combi boiler. Removing the existing (broken) MT10 mechanical plug-in timer. Installing and wiring the Wiser wallplate/receiver to the boiler’s terminal block Removing the link between LS and LR on the boiler. Testing that the boiler fires via the new Hub. I have already bought the Drayton Wiser kit. I can handle the Wi-Fi/App setup myself once the unit is wired in.

Bedroom radiator valve is leaking and needs repair. Also, there is a leaking pipe connection outside the kitchen that needs fixing

The water in the my dishwasher is not heating up. Otherwise it's working fine.

Our heating stopped working and the problem was diagnosed to be one of the honeywell motor valves - the head has a issue and its not moving. (Please see pictures). I need someone to replace the motor valve and also bleed the air in the system. Please quote your price including the part that needs to be replaced.

This boiler is not working as it should and I was recommended to replace the heating elements. So looking for someone to do this... It's not heating water well or fast enough, it costs me insane amount of money (like summertime around £100 goes to just have hot water in the morning for one shower session). Now it provides barely warm water after 3 hours of heating water. I don't know price for this work so please do let me know how much materials and labour will cost!

Currently having some work done on my kitchen and I’m looking for a plumber/hesting engineer to remove the old bulky boiler filter and replace / possible slightly reposition with a smaller more compact filter.