Find professional underfloor heating installation near you

I need the heating element on my electric Hisense oven replacing.

2 of 4 circuits not heating and return manifold is cold

I have a Hive Thermostat and monthly payment. My Hive heating is NOT working and no heating.

I would like a quotation for flushing and cleaning the central-heating system at my home in Grantham. The property has a gas boiler and 16 radiators. The system is approximately 5 years old, and all radiators are currently heating normally. I am looking for advice on whether a chemical flush or a full power flush is appropriate, together with the cost of each option.

The heating temperature is boiling hot around the whole house, might also need thermostats to be installed, also need to check other plumbing issues while there like leaking water and moisture appearing in pool area

My Grundfos Alpha 2L 15-60 130 pump. Does not turn on unless I turn on my hot water downstairs. When it eventually turns on it comes off and shows no sign off power. The pump not working is stopping my central heating from starting and running consistently. I also hear a constant buzzing from honewell diverter valve. I am happy to buy the relevant parts needed myself to sort my Central heating issue.

I have two Danfoss TP7001M mains-powered programmable thermostats controlling heating on separate floors of my duplex flat. Both thermostats suddenly stopped working. When I switch the central heating circuit off and back on at the consumer unit, both displays operate normally for approximately two minutes before going completely blank again. The circuit breaker remains ON. The flat uses a Danfoss district heating HIU. Domestic hot water is currently working. I need an experienced electrician or heating-controls specialist to investigate the common electrical supply, wiring, fused connections and thermostat control circuits, identify the cause and repair it.

The radiator is not heating up in the bathroom

Heating is down.Needs resetting.

I am looking for an experienced plumber with Hive smart heating installation experience to complete all work during a single visit. Job 1: Install Hive Smart Heating System I will be supplying a Hive smart heating system, including 6 Hive Smart Thermostatic Radiator Valves (TRVs). Scope of work: • Install and configure Hive Hub • Install and connect Hive Thermostat and Receiver to my existing boiler • Replace 6 existing radiator valve heads with 6 Hive Smart TRVs • Pair all devices with the Hive app • Set up room-by-room heating controls and schedules • Test and commission the entire system • Ensure each radiator can be controlled independently via the Hive app on my iPhone • Provide a brief demonstration before completion Please only apply if you have previous experience installing Hive thermostats and smart radiator valve systems. Job 2: Replace Kitchen and Toilet Taps • Remove existing kitchen tap • Install new kitchen tap (supplied by me) • Remove existing toilet/cloakroom tap • Install new tap (supplied by me) • Test all connections and check for leaks Requirements • Plumbing and basic electrical experience • Proven experience with Hive heating installations • Own tools and equipment • Ability to troubleshoot and fully commission the Hive system • Clean and tidy workmanship • All work to be tested and demonstrated before leaving Additional Information • Property located in Harlow, Essex • Photos of the boiler, thermostat, radiators and taps can be provided in advance • Hive equipment and replacement taps will be supplied by me unless otherwise agreed Please Include • Details of your Hive installation experience • Total labour cost for the job • Estimated duration • Any additional materials that may be required • Earliest availability Preference will be given to applicants who can complete both the Hive installation and tap replacements during a single visit.

Hive is set to off and not sending a signal to the boiler, however boiler central heating is still on, only way to turn it off is from boiler at the moment

Philip Whirpool Electric Oven and Grill, only the Grill is not heating up.

fix my floor heating， it’s making some wired noise, the pressure is fine

Replace central heating pipework Looking for a qualified plumber/heating engineer to replace all central-heating pipework in my 3-bed house using 15mm/22mm HEP₂O barrier pipe. Boiler downstairs by the front door. Approximately 7–8 radiators. I will supply and fit the radiators myself along with hep20 22mm and 15mm barrier pipe and fittings so the job is to Install the new 22mm flow/return mains and 15mm branches to each radiator, leaving connections ready for me. Upstairs, pipework only needs to go under the middle/dressing-room floor; elsewhere I want it run above floor level and accessible as itll be boxed in Any joins/tees should be positioned where a discreet access panel can be fitted, rather than buried permanently under floors/walls. Please quote for: Pipework installation only Optional price to connect the radiators, fill, bleed, balance and test the system. I have attached the floor plan

I am looking for a Panasonic heat-pump/air-source heat-pump engineer to reset and diagnose the fault with my heating system. The system is a Panasonic heating system with a UK Cylinders Elite hot-water cylinder. The Panasonic controller is currently displaying: 'H20 – Pump error'. The hot water is working normally, but the central/space heating is currently not working. Separate service - The system is also due a service, but this can be arranged for a separate date. The priority for this visit is to diagnose and resolve the current H20 pump error/heating failure.

Fridge is hot in the middle between door and top freezer drawer Leaking underneath Tried cleaning coils at back but no luck

The entire flat is using the under floor wet heating. The old thermostat is broken. Model number: UFHDIALB I ordered the same replacement. Need to replace it and seal with silicone to make it looks nice. I am available from 7pm on Wednesday. Please let me know your availability. And or if you need more information. Thx

I have checked and is in working order, all the status lights are green which indicate the hive is connected and working and the same for the boiler as we have hot water. However the thermostat still does not send signal to heat up

Cylinder Heater Maintenance and Repair Currently no hot water at the flat. Heated Element Replacement needed. • We need to install 2x titanium-coated heated elements (we will purchase from Screwfix or any recommended supplier) in our indirect unvented cylinder heater in a 1-bed flat as they corroded. Cylinder Tank Cleaning • We also need to drain the whole cylinder and scrape/clean the bottom of the cylinder tank to prevent quick scaling of the elements. Please let me know your quote and if you can do the job before Saturday or Sunday this week. Any questions, just message.

We have a range cooker and it has been broken since Christmas, we think it’s the heating element that needs replacing.