Find an experienced handyman in Springwood QLD

Wall section to reinstate is 3.5m long x 1.3m high. The plasterboard was removed from a brick/masonry wall. The wall-to-slab joint at the base has been pressure-injected with waterproofing membrane. The brick face has been coated with membrane paint. The area is now dry and stable. Scope required: Reinstate the wall to the original finished line. Do not bring the wall forward or box it out. The original plasterboard sat about 25mm off the brick. Install a low-profile fixing support (thin battens or furring channels) fixed to the masonry where appropriate. No drilling or fixings through the injected waterproofed base joint at the slab. Keep the bottom edge of the new sheet 10 to 15mm above the slab so it does not touch the floor. If any mechanical fixings must go through the membrane-painted brick, each fixing point must be sealed so the waterproofing remains continuous. This means sealant in the drilled hole before the fixing goes in, seal around the head, then touch up with membrane paint. Supply and install moisture resistant plasterboard. If you recommend fibre cement instead, please explain why. Tape and set joints, then sand to a paint-ready finish. Clean up and remove all rubbish. Quoting: Please include materials and labour. Please confirm your proposed fixing method. I do not want an adhesive-only dot-and-dab plasterboard install directly onto the membrane-painted brick.

Replace standard ceiling fan. I will provide fan

Install a new door and it’s hardware

I'm looking for a friendly, capable handyman to help with a small job first, with the goal of potentially retaining you for more odd jobs around the house. Initial Task: Fix/replace a broken hinge on a small side gate (garage entrance) Future Jobs (if happy with your work): Replace interior door knobs Adjust minor fittings or cabinet doors Basic maintenance and odd jobs around the house What I'm Looking For: Someone who works efficiently and with care Hourly rate preferred for future jobs Open to discussing further work The listed price is just for this first small job and inspection. I'm happy to work out additional scope and payment privately if this job goes well.

Need gutters fixed or replaced

Hi just need some help with some things around the house: - putting up blinds and curtains - building outdoor shed (flat pack sort of system) - garbage removal - plastering roof and holes Other little things around house :)

Repair hole in bedroom wall

I need someone to fix my kitchen water tap, please look at the picture

I need to install a DC ceiling fan

Also, the drawers need re-wrapping if that’s a thing. Sorry, I don’t have a photo of that.

Needing mobile rim repair for same day fix on 1 alloy wheel. Light gutter scrape.

Needing to take out old vanity and install new one Mount in place and silicone in 900mm vanity

Hi, I need a few handyman (or person) tasks done at home. I need: - Back door adjusted so that it closes properly. It doesn't latch properly when closed, and needs a shove each time. - A bedroom door that is similar. - A downpipe that needs redirecting or capping off. - A toilet roll holder that needs attaching to the wall. There's other tasks that I could find too, so happy to pay by the hour for work done.

Would like 3 ceiling fans installed in my townhouse. 2 downstairs and 1 in the master bedroom. Replacing existing light fittings downstairs and fan in master.

weathered plastic line on a rotary clothes line needs replacing and strung with durable galvanised coil. Must be able to achieve good tension. No sag

my sink has always been 'slow' to drain since 2020 when i moved in - a plumber unblocked it a week ago - but it only lasted 2 days and became 'slow' again - but now it doesn't drain at all and i have to empty it with a bucket.

The slats on one side of my timber bed frame have collapsed, causing the mattress to lean towards one side. I tried using a timber nail/screw to secure it but my tools aren’t strong enough to fully piece the frame. Need some to help secure the slats. I’ve got the nails, just need to power screw driver

Looking for a sparky to replace two celings fans. We will supply both fans we just need them installed. Budget is $200-$250 to have both fans replaced

We’ve recently moved to a new premises, we need boxes and shelving moved to proper location in garage, some racking to be re-assembled, removal and dumping of empty boxes, Two broken office desks and one stationery cupboard. Hanging of artwork (drilling holes/installing hooks), installation wall brackets and hanging of large (75") TVs x 3, plus a few other small tasks. We estimate almost a full day for at least two strong people. The TVs and shelving are too heavy for one person to lift.

Frame got cracked somehow