Find an experienced handyman in Seaford VIC

3 x rectangle holes were cut to fix plumbing 1 x behind fridge 1 x behind laundry cupboard d 1 x other Plaster kept as shown in pics Please advise on price Compete asap

Need a garden shed installed on a concrete slab- shed is 3m X 2.25m

Install plaster sheet on the small brick wall above my kitchen sink.

Install on 30m of Wire and Festoon Lighting. TImber to Timber applications, 5 Anchor Points. Support wire and fixings already purchased and provided. Ladder and tools for cutting 3mm wire cable required. Experienced person please. Pictures attached.

Need blind 1700 long installed. Also put in small hooks for curtain wire in two living room windows Have blinds and hooks at the property.

Plastering, door repairs, fence repairs, gutter clean, gate repairs and washing line Contact for details, ongoing work available

100mm x 100mm hole in plaster wall to be fixed by experienced plasterer

Hi all, looking for a patch up job to secure fencing as best as possible. Some pales are loose and fence will be replaced in the next 6 weeks. Just need some holes covered so that little dog does not continue to escape until then. About 3 holes at least showing. Does not have to be pretty, currently have an oven grill in one spot!

Awnings window wind out panel of window will not close due to frame separating. Can hopefully be repaired but may require new panel.

Hello Skilled personnel, Three areas of concern on a rooftop for a fast food store in Seaford. Chimney stacks, Box-gutters & Above toilet block leak. Chimney: on heavy rain down pour ONLY the inside-store exhaust vents above the hot plate grill plate leaks water, believed to come through the chimney stacks, most likely reason, but not definitely. (If you believe that to be true, it would require stripping back past applications of tar & black goo, etc ) Box gutters: rusted out, needs replacing 15m width approx. Toilet block in the store experiences water leaking, unidentified source. My bet it’s from the box gutter leaking. 1m porthole access to the roof, access vi rear carpark, laundromat. I’m open to other maintenance suggestions, whilst onsite. Ignore my $10 budget, please quote. Regards, Adrian.

We are renovating our fireplace and need a skilled bricklayer / mason / handyman with the right tools to grind back or remove all protruding bricks and ledges so that the surface is flush and ready for tiling. ✅ What needs to be done: • Grind/cut/remove any bricks that stick out past the main vertical face • Remove the small shelf ledges on the front • Ensure the fireplace faces are flat/flush for tiling preparation • Clean up any loose mortar where bricks were removed • Bottom hearth/step is to remain intact (do NOT remove this) Important: • Solid brick fireplace, double-sided (front and side as shown in photos) • We are NOT demolishing the fireplace, only shaving back/high spot removal • Must have grinder/brick saw • We will handle the tiling after — just need a flat surface Please include: • Your experience with brick grinding or fireplace modifications • Confirmation you have the tools for the job • Estimate or hourly rate Looking to get this done ASAP. Thanks

**install only** we do not need anything supplied. We plan on purchasing a scandia supremacy 300 log burner and need a quote to install it. It will be in a single storey room (on back wall where grey couch is) , Flued through a pitched roof that is tiled.(as per photo)

- Pick up & install VJ panels to bedroom (1 wall - approx 3.4 x 3.4cm). Please exclude cost of material from offer as we will purchase.

Holland blind repair. Chains need replacing

We are needing a fireplace rendered or venation plastered for approximately 9 square meters. Shopping for quotes

Hi I need this pillar repaired and rendered. It was vandalized. The location is just near Frankston.

Total area is 6.5m x 2.8m. Current ceiling is already off. Please supply materials.

The kitchen blinds have broken and the string mechanism has snapped as we lifted the blinds up. Assistance with fixing ASAP

Install a Hills double folding frame clothesline

The previous owners of our home had a cat door installed and we don't need it. We'd like to have it removed and the timber door to be patched up before we have painters come to paint the door on Wednesday. I'm assuming using insulation foam from a can would do the trick to fill the empty space and the patches put on the inside and outside of the door.