Find professional window and door services in North West Melbourne

I need a Brush Seal installed above the roller door of my shed to stop birds getting in.

The shop front door is closing issue . We need to push upward to close it . Seems its displaced from top side see referance image for door and upper displacement. Job to fix the door and change part as required and also service entrance door ( front door has 2 door)

3 panel shower sliding door not sliding properly, needs to be installed properly

Roller door need adjustment

Would like to add two Second hand doors to the loungeroom entry way to reduce noise.

The movwrs had to remove the fridge doors to get them into the room. I need the fridge doors put on the fridge.

Hello, I am looking to replace all internal doors for my house from flush panel doors to Corinthian Impressions doors. These are plain doors not pre-hung. 10x doors of varying sizes from 2040x620 to 2040x820 mm I need someone to: - remove the old doors, remove lock/hardware. - hang new doors, and install lock/hardware . In addition, I have a walk-in robe that needs to be framed/plastered and a swing door installed (I think 2040 x 620mm) - see pic attached. Please provide your quotes. Thanks, Fawad

My garage door's first panel from the bottom is damaged. My agent wants the door to be fully replaced by a new one and wants the door to be exactly the same as it was before.

My garage door roller door motor is playing up. I want to replace with new motor for my single garage roller door.

Need door attached to frame. You'll have to install door back on frame. This door never had hinges but I want hinges installed. I want the bottom to be flush to prevent animals getting in.

Garage door, track wheel came off the track, see attached pictures.

Need to install a door to the powder room with lift off hinges. Door and hinges will be provided.

Bifold door sticks when trying to close, possible movement? May need trimming down on base? bracket tightened? Ideally like fixed in next week, located at my grandmothers property

Hello! I got 3 wardrobles (6 doors) that need handles installed. I have purchased the handles already. The screws will need to be cut as they are too long for the door.

I’ve got a new internal door and need someone to install it. It’ll need to be trimmed to size if needed, hinges fitted properly into the door and frame, and holes done for the latch/handle. I want to reuse my current handle/lock and keys. Also need the strike plate fitted so the door closes properly and lines up nicely. Just after someone who can do it cleanly so it opens/closes smoothly and isn’t crooked or sticking. Door frame is already there.

The door is jammed because wood has expanded. May need sanding and/or realignment.

See photo Need the rollers replaced on this glass sliding door. Please quote

Our sliding wardrobe mirror door has a glass panel that has popped out on one side. Looking for someone experienced to safely reposition and secure it back in place.

Please provide a quote in your message. The renter has reported that the garage roller door is currently malfunctioning. The door needs to be manually pulled down, and when attempting to operate it via the remote control, the unit emits a continuous beeping sound without completing the closing function. This issue appears similar to one that was raised approximately five years ago, which your team previously attended to and resolved. Based on the current symptoms, it is likely a recurrence of a similar fault. From my initial review of the video provided, I believe the following may be contributing to the malfunction: Signal / Receiver Issue (most likely) The motor appears to have power; however, it may not be receiving the signal from the remote. Possible causes include: Disconnected or damaged antenna wire Fault with the receiver module (control box not communicating correctly) Interference from any added devices (e.g. WiFi/smart automation setup)

Garage door no longer responds to remote controls or wall panel control. Have tried resetting remotes & limits but still no response. Model is Steel line SD-800