Book a professional blind repair service in South East Melbourne

Have 2 sets of blockout blinds to be put up on kitchen and bedroom, old blinds to be removed and taken away. Toilet roll holder to be drilled into wall.

I need my roller blind repaired or replaced. The blind has come off, the string is also broken so that needs replacing.

We bought blinds from Spotlight however they need to be cut to size. Need someone to measure and cut them and we will install them. Roughly 12 blinds

The Chain is loose on the Blackout blind and need to fix it.

Need to Fix railing of a Outdoor Roller Blind. Railing came off due recent wind ( only one side). Need to fix it back to the wall. Need to connect with roller plugs.

One side curtain has come off the revit and another side needs tightening. Has revits.

Need to install roller blinds

Cut blinds to size, install. I have a double roller blind set about 15mm too wide for the window frame. I need the roller, blind and bottom rail trimmed to fit. Reassemble the blind and install. All hardware on hand. Nominal size is 2724mm wide, 2110 drop.

the blind size is 240cmx180cm, i need to make it to 234cmx180 and a venetian blinds to do the same

Roman blind codes and clips broken

Manual roller blind is stuck at half way point so can no longer roll down roller blind

Easy handyman job 3 roller blinds installation brought from bunnings An internal door hinge need to be adjusted a bit, the door can not close due to the new paint.

I need string of indoor blind to be fixed. There are 2, the upper one needs to be done.

Install Large Blockout Roller Blind – Face Mount (Outside Fit) Description: I need an experienced installer to fit a large blockout roller blind to the wall above my window. The blind has been delivered directly from Shadey and still in the box– here’s the product link for reference: https://shadey.com.au/blackout-roller-blinds-jane-cross/ Blind details: Type: Blockout roller blind Mount: Face fit (outside mount) – drill into wall above window frame Width: 2940 mm Height (drop): 1625 mm Roll: Back roll (fabric sits closer to wall) Chain operation (right-hand side) Bracket colour: Black Base rail: Flat, silver No pelmet Large/long blind – may require two people to lift into place Requirements: Bring all tools required for install (drill, level, screws, wall plugs/anchors suitable for wall type) Ensure blind is perfectly level for proper blackout coverage Install securely but in a way that allows for future removal with minimal wall damage Use fixings that are strong but avoid oversized holes where possible Wall material is likely plaster, and the top of the window frame may be solid timber, but this is not confirmed — please be prepared for either Take care to avoid damaging wall, frame, or paint Location: Oakleigh Budget: $200 Photos: Ive uploaded photos of the window and surrounding area so you can see exactly where the blind will be installed. Timing: Flexible – ideally within 1 week

The cord has snapped on a blind roller cord. I need someone to replace it please. Must be metalic cord as whole house is done with metal cords

cut x6 rollerblinds to size

4 outdoor cafe blinds to be installed. Blinds already available.

Blind mechanism needs replacing on roller blind

Need a Venetian blind install 1200 wide asap

Install roller blinds, modify cabinetry under bench for dishwasher, repair of single displaced roof pointing and flashing and other small jobs. I can attach some photos on Thursday afternoon if needed.