Find a professional gate installation in QLD

Looking for an experienced automatic gate technician to inspect and repair a solar-powered automatic driveway gate. The gate is currently not operating correctly and needs troubleshooting to identify the issue, which may involve motor, controller, sensors, remote system, or gate mechanism. Please bring the necessary testing tools and have previous experience with solar-powered automatic gates. Please submit your genuine and reasonable offer, along with your experience and availability. If parts are required, please identify the fault and discuss the cost with me before replacing anything. Looking for someone reliable who can diagnose the problem properly rather than simply replacing components unnecessarily. Location: Warner 4500

We require an automatic gate opener for the existing double swing gate. Each side is 2m x 1.8. Electrical is in the ground per the pic

Looking for someone who can repair an automatic gate. The gate got damaged and isn’t fully closing.

My automatic gate derails after closing and does not open until I manually lift and put it back on track.

Automatic gate working intermittently need someone to take a look and repair

I need someone to install a "Slide 600 Gate Opener MGSK600" into my residential property. I will also require an electrician to disconnect the old unit and reconnect a new unit. Ideally this would be an authorised installer so that the warranty of 3 years applies

Need a quote to fit up a complete automatic gate opener to my front gates I have the arms/ motors solar panel and battery pack etc all new Dig small trench across gate way and bolt everything up etc

Its stuck sometimes not closing

I need this automatic dual swing gate opener system installed in my existing garage timber doors. Purchased from Big W. https://www.bigw.com.au/product/automatic-electric-gate-opener-double-swing-remote-control-kit-800kg/p/9900145661

Driveway gates not working. Mate be control box issue

I have 2 gates Filo 400 with Controller CL101 - I have approximately 8 Remotes- ECC05B0 / two wifi controllers Bidi-Wifi and an external keypad EDSWG I need them programmed. its not all working properly I would suggest factory reset on all and all keys are repaired.

Automatic gate stopped working , needing it fixed . Have a manual for the gate

Install solar automatic gate opener gate is already installed

My automatic sliding gate is currently not opening or closing properly and needs repair. The issue appears to be with the gate latch/receiver and alignment near the brick pillar. The metal catch that locks into the wall-mounted receiver is misaligned or not engaging correctly, which is preventing the gate from operating as it should.

Automatic gate has disengaged from runner and won’t open or close. I need someone to fix it and recalibrate it. I can’t even work out how to disengage the motor.

Purchased a LockMaster Swing Gate Electric Opener, to be installed on large timber and metal gate. To be attached to metal poles. Connect power cables and 250v plug

We would like to extend and change our gate to automatic gate with 4.5width and 1.5m height.. We want to keep the old fence and the new gate is similar as the fence. The current gate 2.5m width Please give me the quote. Thanks!

Need automatic gate , and fence

Solar battery operated double swing gate with new posts required

The electric gate got damaged due to side hit by small ute. Pics are attached, it is an automatic swing gate 145h x185l in mm. I have mentioned the rough price, happy if the damage be out and form the gate as normal as before, or can provide quote for the new 1× gate leaf installation

I need a handy man to supply and install two timber gates on timber poles. I will pay for all materials separately. The materials are available in Bunnings.

Small timber gate no longer opens correctly (we have had to remove hinge to make it workable)and seperayely an aluminium upright on glass pool fence has moved so glass pool gate no longer works

Timber fence / with a gate to separate backyard for two dogs

Hi looking for a quote please for a side timber gate installed in our yard many Thks

Timber gate on timber fence - the post has rotted at the base and no longer stands straight so the gate won't open/close properly. Need the post replaced and the gate to work.

I need an experienced fencing contractor or handyman to repair my side timber gate in Toowoomba. Please note that some of the attached photos were taken before the gate fully collapsed, so its current condition is worse than shown in some images. I am looking for a proper long-term repair, not a temporary fix. The job includes inspecting the gate, frame and posts, rehanging and realigning the gate, and replacing all worn or damaged hardware with new heavy-duty components, including hinges, latches, catches and any other fittings required. I would like a heavy-duty drop bolt (slide-down ground bolt) installed to secure the gate when closed, as well as an additional heavy-duty sliding bolt or locking bolt fitted around the middle of the gate so it can be securely locked and supported when required. Any additional support hardware needed to prevent future sagging or failure should also be installed. I would also like a suitable hold-open mechanism fitted so the gate can be secured in the open position and not swing shut in windy conditions. Please inspect the existing posts and advise whether any post movement may have contributed to the failure. I am looking for someone experienced in gate and fencing repairs who can provide a strong, reliable repair that will last, as I intend to replace the entire fence at a later date. Please quote including labour and materials and provide details of your experience with similar gate repairs.

Detach large metal gate. Remove cemented in timber gate post. Replace with metal post. Reattach gate. It already has new hinges to be re-used.

Looking for a handyman or fencer to reinstall a timber gate with steel frame that was removed on side of our house for construction in the backyard. Hole for post is still there, gate still attached to post, latch still attached to externall wall of house. One missing panel that was damaged in the removal. Have purchased extra timber panels and timber rail just incase. Location is South MacLean 4280. Space is 2.8m wide. 1.8m tall.

Looking to get a basic timber gate built and installed on the side of our house. Approx width would be 1.7m. There was a metal fence there previously so it already has some fence posts. Slight incline also. Won’t need it painted, just need it installed

A new set of back timber gates and 3 external cupboard doors measuring 2380 x 615 x 40mm. Plus replace a slat of timber in our front fence.

Washing line posts need reshoring and line needs to be restrung. Side timber gate requires securing to wall. Front timber gate requires planing as swells when it rains.

Timber decay causing the timber gate bracket to snap. I will need help replacing the timber jamb, gate bracket and reinstall timber gate.

Timber gate in corner needs new post to attach gate with hinges. Collapsed 5 months new colour bond on the back boundary will be fixed by original contractor. Please see photos. 1st photo after the storm 2nd photo taken from inside garden, it was before the storm, in perfect condition

Remove one old double timber gate and replace. Remove one old single timber gate and replace. New gates to be made from timber. Build one small slatted fence, approx 3 metres long.

Need a timber gate for front entry to property prefer steel frame with timber slates to match existing fence

Need someone to come and fix an old pedestrian gate. It needs new hinges, replace or patch one new fence pailing and a new latch

Need to install new timber gate and side panel. See photos of old one.

Gate need for side access. It is quite a wide area. Approx 2.2 m wide. Looking to do a double gate. Will need to be different lengths as some of the gate will be on top of concrete and some covers grass.

We require the installation of a gate that will prevent access from the left side of the house to the back. We would like this gate to be made of a material that can partially obscure the view, making it more visually appealing and also attractive from the front approx 1020mm wide Require install ASAP

I am looking for someone who can install timber gate and timber fence panel at my home side access. Total length - 5M which includes 3M gate. Two gates of length 3M(2x1.5M) and one 1.2M timber panel is already available. We may just need to make another 80 CM panel to cover the whole area. Height of existing Panel and Gates are 2.1 M