Find a professional gate installation in QLD

I need an Automatic Swing Gate mechanism & controller installed. I will supply the kit (info below). This is to replace the broken existing mechanism/controller from a different brand, which needs removing. There will likely require some drilling & fixing of mounts (hardware included - you will need tools) and setting up the gate controller/keys for open and close (instructions included). There is a power point at the gate, so no electrical qualification needed. I prefer if you have experience with installing Auto Gates and/or this type of system... please let me know. Kit information: Vantage 400 Single Swing Kit from Centsys https://www.fenceworld.com.au/shop/vantage-400-single-swing-low-voltage-23684?category=13

Need a quote to fit up a complete automatic gate opener to my front gates I have the arms/ motors solar panel and battery pack etc all new Dig small trench across gate way and bolt everything up etc

Its stuck sometimes not closing

I need this automatic dual swing gate opener system installed in my existing garage timber doors. Purchased from Big W. https://www.bigw.com.au/product/automatic-electric-gate-opener-double-swing-remote-control-kit-800kg/p/9900145661

The gate is currently rubbing on the fence due to misalignment. May involve bit of concrete work as the gate may misalign due to block moving and there were two big trees until recent.

Driveway gates not working. Mate be control box issue

I have 2 gates Filo 400 with Controller CL101 - I have approximately 8 Remotes- ECC05B0 / two wifi controllers Bidi-Wifi and an external keypad EDSWG I need them programmed. its not all working properly I would suggest factory reset on all and all keys are repaired.

Automatic gate stopped working , needing it fixed . Have a manual for the gate

Install solar automatic gate opener gate is already installed

My automatic sliding gate is currently not opening or closing properly and needs repair. The issue appears to be with the gate latch/receiver and alignment near the brick pillar. The metal catch that locks into the wall-mounted receiver is misaligned or not engaging correctly, which is preventing the gate from operating as it should.

Automatic gate has disengaged from runner and won’t open or close. I need someone to fix it and recalibrate it. I can’t even work out how to disengage the motor.

Purchased a LockMaster Swing Gate Electric Opener, to be installed on large timber and metal gate. To be attached to metal poles. Connect power cables and 250v plug

We would like to extend and change our gate to automatic gate with 4.5width and 1.5m height.. We want to keep the old fence and the new gate is similar as the fence. The current gate 2.5m width Please give me the quote. Thanks!

Need automatic gate , and fence

Solar battery operated double swing gate with new posts required

The electric gate got damaged due to side hit by small ute. Pics are attached, it is an automatic swing gate 145h x185l in mm. I have mentioned the rough price, happy if the damage be out and form the gate as normal as before, or can provide quote for the new 1× gate leaf installation

Automatic gate system needs replacing. The controller is no longer working and hence failing to open the gate. Upon inspection it was reported that the power supply and the motors also need replacing. Motors are seizing apparently. In short it looks like we need quotes for a complete system supply and installation. Price is negotiable just put a figure down as I would like a quote initially. Reposting task with photos.

Need to PVC gate and motor needs to be installed. Concrete slab for the gate tracks also need to be poured. Maybe some cutting of existing driveway to make room for the tracks so the gate is levelled.

THE GATE JUST STOPPED AFTER ALL THAT RAIN, I HAVE PURCHASED A NEW AUTOMATIC GATE OPENER JUST WANT SOMEONE TO REMOVE OLD AND INSTALL NEW

Need to replace locking bar on gate faac c720 motor

A new set of back timber gates and 3 external cupboard doors measuring 2380 x 615 x 40mm. Plus replace a slat of timber in our front fence.

Washing line posts need reshoring and line needs to be restrung. Side timber gate requires securing to wall. Front timber gate requires planing as swells when it rains.

Timber decay causing the timber gate bracket to snap. I will need help replacing the timber jamb, gate bracket and reinstall timber gate.

Timber gate in corner needs new post to attach gate with hinges. Collapsed 5 months new colour bond on the back boundary will be fixed by original contractor. Please see photos. 1st photo after the storm 2nd photo taken from inside garden, it was before the storm, in perfect condition

Remove one old double timber gate and replace. Remove one old single timber gate and replace. New gates to be made from timber. Build one small slatted fence, approx 3 metres long.

Need a timber gate for front entry to property prefer steel frame with timber slates to match existing fence

Need someone to come and fix an old pedestrian gate. It needs new hinges, replace or patch one new fence pailing and a new latch

Need to install new timber gate and side panel. See photos of old one.

Gate need for side access. It is quite a wide area. Approx 2.2 m wide. Looking to do a double gate. Will need to be different lengths as some of the gate will be on top of concrete and some covers grass.

We require the installation of a gate that will prevent access from the left side of the house to the back. We would like this gate to be made of a material that can partially obscure the view, making it more visually appealing and also attractive from the front approx 1020mm wide Require install ASAP

I am looking for someone who can install timber gate and timber fence panel at my home side access. Total length - 5M which includes 3M gate. Two gates of length 3M(2x1.5M) and one 1.2M timber panel is already available. We may just need to make another 80 CM panel to cover the whole area. Height of existing Panel and Gates are 2.1 M

1) Wooden gate has a loose plank and latch. We cannot close the gate. 2. The glass of a single swing pool gate has smashed (taken out). The fitting remain. We have fence off the gaps but cannot access the pool to clean, etc.

Fence has fallen off the hinges. Hinges look bent? Need it fixed asap as there are dogs in the yard

Front gate needs cleaning and darker wood stain varnish put on wood slats

I need a timber gate built within an existing fenceline that measure 1830 wide, 1810 high. The gate needs to be at least 1000 wide.

Timber Fence retaining wall need a repair

Looking for a skilled tradesperson to supply and install two gates on both sides of my house. • Material: Match the existing timber fence shown in photos. • Location: Spring Mountain , QLD • Side 1: Gravel ground between two houses (see photo) • Side 2: Grass/soil area with plants next to timber fence (see photo) • Please include supply of all materials, hardware, and labour in your quote. Photos attached for reference. When: Flexible, but ideally within the next weeks. Budget: Please provide your quotes — expecting around $450 including materials and labour, depending on quality and finish.

I need a gate rehung, tasker will need reversing battery drill hex bit, to remove hinges of gate, then a hammer drill to refasten the support post to brick wall.I have new drill bits and dyna bolts on site Then rehang the hinges to timber post.

Replace side gate which is timber on a metal frame. Hinges are welded to the frame which has now rusted and broken away.

Large outdoor timber gate has dropped and scraping on the concrete slab. Don’t think it’s easily rehung. Believe it needs to be removed, the base cut by a few inches and rehung. If it can just be rehung, then happy for that solution. Required to be completed before Friday evening.