Find reliable baseboards services in NSW

Replace approx 23mtres of new skirting boards. Old skirting boards are removed and new ones already on site. Put VJ wall panelling on one wall, the wall is 11metres long and each panel is 2400 x 1200 wide and I am wanting the height of the panelling 1200 high so each panel needs to be cut on from 2400 high to 1200 high. Panels already on site. See below already removed skirting boards and the panelling I want done on 1 wall.

We are getting new wardrobes in two bedrooms and need to cut the gyprock 30cm higher in each room to accommodate the new design. We also need the skirting taken off in each room. Room 1: 2.9m x 3.6m, Room 2: 3.6m x 4.6m

I need someone to install skirting boards to my 3 bedroom apartment. I want to install PermaTimber 92 x 15mm 2.7m Antique White PVC Pencil Round - 92 x 15 x 2700 from Bunnings or similar. If you need linear dimensions i can provide or contact me for a site inspection. Approx 73 linear meters. Provide quote per linear meter and confirm on site inspection

Would like approximately 2 metres of skirting boards supplied,installed and cut to size

Our puppy has eating part of the skirting board and fence outside. We need someone to sand it and paint it please. Also a panel of a fence has fallen off and we need some light bulbs replaced if they can be done too :).

We have 2 bedrooms (roughly 3m x 3m) which require skirting boards installing. We have the required skirts. Walls are concrete. We have no tools to provide for cutting. Photos attached. One room has one door. Second room will have wardrobes in place where marked X on picture (skirting to run up to that wardrobe), and Has two doors.

Remove skirting board to fit fridge

Puppy chewed a small part of skirting board need it repaired and the small part of wall above it too

Disconnect gpos on skirting boards as part of floor work then reconnect later once skirting boards reinstalled required today before 4pm

I have the correct spare section of skirtint board needs to be cut (w mitre join) to correct size for two small corners and fixed to wall

Skirting board around fridge area were removed to fit fridge, wall needs patching/skirting boards replaced. Mesh screens on back screen doors need fixing. Small holes in house patched and painted.

Need help removing a skirting board and shortening another skirting board by cutting the edge cleanly so I can fit my fridge. Need to keep the pieces to be able to reattach later on.

I have 2 sockets that need to be moved into the wall from the skirting board as I am about to redo my flooring. The wall is concrete/brick.

Install skirting board in my garage not fussed on weather it’s PVC or aluminium or timber 18m

Install floor skirting boards and architraves around laundry door. I’ll supply the primed 80mm timbers, and you supply your nails/screws, gap filler. Total lineal metres approx

We just had new floor installed. We now need skirting boards installed. Approximately 55m linear. See pics for skirting board.

Fix toilet seat as well remove skirting board beneath kitchen island

I need a piece of skirting board installed of about 1m length. This is part of the nook where the fridge used to sit. I had to pull that piece of skirting board off to make the fridge fit. Due to selling the house I need that piece of skirting board re-installed (of course didn't keep the original piece that got removed). It needs to join an existing piece in the back of the nook. The previous carpenter unfortunately didn't do a 45 degree join for the corner but the new piece needs to be contoured to fit the existing back piece. In addition, there is another piece towards the front kitchen aisle that also didn't have a 45 degree corner join. I pulled it of before I realised that this piece not square either but tapering down (I still have that piece). In short, I need a 1 meter piece of skirting board installed that joins with a back and a front piece. I have 2.4m of skirting board of the profile required. Also have some wood glue. Everything else needed I can organise if you tell me what else is needed. I don't have the time or tools to do the job myself. I'm guessing that this should be a very simple job and shouldn't take any longer than 1/2h of work for someone who knows what he's doing. I don't require any painting to be done. Just make a new piece of skirting to join neatly with the back and front piece.

Fix skirting board that my dog damaged.

skirting boards need replacing as absent, door handles & vent replaced, door needs shaved