Find a local floorboard profesional in NSW

We had engineered floorboards installed over an old floor vent without getting it covered/filled (big mistake) so after a few years I’ve finally put a foot through it. Need someone to come take a look, get it filled/covered and replace a few boards with the spares we have.

I have all the equipment I just need someone to lay the floorboards down on top of the underlay . They are hydbrid.

Installation of laminate floorboards, plus builders plastic and underlay below. Installing in 2 medium sized bedrooms. Open to discuss pricing

There was a leak in the flooring which has now been fixed and the panels were placed back by the plumbers. But because they were not carpenters or flooring experts they nailed down a few panels and it has created gaps. Will get new panels from Bunnings if needed but need the gaps filled up as they are a tripping hazard.

Newly installed floors there are some locations where they need repainting so lightby buffed

I would like to make my kitchen floorboards instead. It’s approximately 26-28 square metres.

Need someone who can source/find floorboards that are identical. The urine damage has gone underneath the floor boards From damaged pet urine floor boards Just 2 areas on the living room

I need a carpenter / joiner or flooring installer to lay around 30sqm of used floorboards on top of this plywood floor. The floorboards are used tongue and groove hardwood floorboards of varying lengths. The floorboards don’t need to be fixed to the floor as long as they stay in place and don’t move around when you walk on them.

Three floor boards need replacing and a strut put across for support. This is a rental and I just need the boards to be secure. I am not fussed terribly about the aesthetics. It may only require part of the end of the boards to be replaced.

Long but not deep scratch in floorboards.

I would like the yellow tongue floorboards taken up and replaced around the edge of this floor and hallway/landing. Only the boards where you can see the water staining. It's in a smallish bedroom and a smaller area outside of this bedroom. I've posted photos of the two spaces and then a few closeups of the stained areas to be replaced.

I’m converting a small storage room into a study nook and need floorboards installed to cover an exposed concrete subfloor where built-in cabinets were recently removed. The job involves three tasks: 1. Lay Floorboards ∙ Install supplied (matching) floating floorboards to match the existing light timber flooring in the adjoining area ∙ Boards need to butt up neatly to the existing flooring at the threshold ∙ The subfloor is bare concrete with some old adhesive residue from removed cabinetry – light prep/levelling will be needed before laying ∙ Please bring underlay – I don’t have any on hand 2. Install Skirting Boards ∙ Install supplied skirting boards around the perimeter of the are as shown in the photos to finish the floor edges clean 3. Patch Holes in the Wall ∙ There are a few holes and damage spots in the walls left over from the cabinet removal ∙ Please patch and prep the walls ready for painting – I will do the painting myself, so just needs to be sanded smooth and ready to go. I will supply the filler for the wall patching. This is a relatively small task for someone that knows what they are doing.

Hi, I renovated 15 yeas ago. Having carpet layed in my bedrooms. At the time the floor boards very soft in areas and the builder laid some type of tin product over parts on the floor …. I didn’t need new boards in the bedrooms. Now… I can feel a floor board is broken in another area. Hoping the carpet can be lifted and the area fixed.

Need sealant removed, properly seal cracks, sand and paint over

Looking for someone to remove lino and sand/polish floorboards.

Cost TBC once more details are given. Just to get this on the list.

I need a skilled handyman or flooring installer to replace one rotted engineered timber floorboard near a main door (see photos). Details: • Only 1 board needs replacing • I already have a matching spare board • Board is at the edge near the main door frame • Task includes carefully removing the damaged board, preparing the area, cutting/fitting the new board, and gluing it down properly • You’ll need to bring your own tools and adhesive Looking for someone experienced with timber or engineered flooring to ensure a clean, neat finish with no damage to surrounding boards or the door frame. Flexible on timing. Photos attached.

I have approximately 10-12 floorboards that need to be cut to size to fit around a cupboard. I have the measurements and boards ready. Happy to come to you if that's easier with tools etc.

These floorboards buckled after a dishwasher water leak. We have lots of spare boards that can be used to replace them. We also have the tan floor cover that needs to be glued on top to make the angled edge smooth. It's important to us that the surface becomes safe (no trip hazard) and the work is high quality.

Task is to install hybrid floor boards, floor transition for where floor boards meet carpet, skirting for Hallway and 2 bedrooms. Scotia to one wall. See attached images. I am providing: Hybrid floor boards, Scotia, floor transition. Youll need to supply skirting. But I can pay for this separately. Bedroom 1 - 3x3m (skirting) Bedroom 2 2.9x4.2m (skirting) Hallway 8.9 x 1.47 (floor boards & skirting) Kitchen wall (scotia) I dont know what they going rate is for this type of task.