Find experienced local fencing contractors in South East Perth

We had a handyman build a fence and he was going to fix the gate but has become unwell so we need someone to finish the job! We need a garden gate fitted. We will source the gate, but not the hardware to fit it, so you’ll need to source brackets, screws etc.

I am looking for a handyman or tradesperson to install a self-closing spring or hinges and a latch on a garden side gate. Job details: • Install a spring for self-closing function on garden side door • Install/adjust hinges as required • Ensure the gate closes properly and aligns correctly prefer someone with Own tools and equipment.

11m fence install. Already have the supplies.

For front fenced lawn, I need metal slate gate ( Matching slats). It will be 2 doors of approximately 1 meters by 1 meter.

I require a timber garden gate - 1800h by approx 900w - to be installed between an existing bamboo fence and brick wall of the house. There is a steel post (50mm x 50mm) concreted in, supporting the fence, which may be able to be used to swing the gate from. Width from outside of steel post to house wall - 1210mm. - Due date: Flexible

I need a gate and posts replacing. Quote to include gate and installation. - Due date: Flexible

Back Garden Fences - 2 panels need to be replaced or fixed. Please see the photos for more details. - Due date: Flexible

Install 2 x 900mmx1800mm panel and fence gate.

Build a trellis by installing 5x 90x90x2700 treated H4 Timber posts. Each post will have a stirrup at the base of the treated pine pole and the hole filled in with rapid set concrete, 8 bags of rapid set required for the job. Install 5x horizontal galvanised wires with eye bolts at the end and use anchor grips to hold them in place. - Due date: Flexible

Hi everyone I need a side gate installed to stop my dogs escaping. Doesn’t need to be anything fancy just something that will stop them escaping

The dogs dig under the fence need some dog proof wire or something installed open to suggestions

Enclosure net, brackets and all other materials have been purchased just needs to be attached to the existing fence. The enclosure doesnt enclose totally as in roof. It is fence extension brackets attached to fence and then a wire netting put along the brackets to extend fence height. Most of the fence is wood, a small part is metal and an equally small part is brick. I have all necessary attachments bought with fence extension wire. I hope this helps. Approx 20 - 25 m In my head it would take 8 hours. I am happy to work as a side kick.

Glass pool fence and fixings to be moved to new location new footings will need to be done

Relocating approx 20 mt Colorbond Fencing 90 degrees

I have a dog enclosure 2200Wx 2200L x 1800H that needs new fence meshing I bought from Bunnings. Not that much work I have all the stuff to put the mesh fencing together. I’m going overseas on the 20/02/23 I would really appreciate it if someone can help me please! - Due date: Before Monday, 20 February 2023

Install a colour bond gate at my property

Install PA gate with side panel - colorbond 1.8 high 1.7 width PA gate - approx 1m width Side panel- approx .7m width Belmont area

Colorbond fencing approx 25m x 1.8m high. Core drilled into retaining wall and ground base with 1.5m access gate quality workmanship only. Perks if you can lay 1.2m of limestone wall as well

removal of 1 x pillar and wall section and replaced with colour bond fencing to match the existing colour bond on the neighbouring property. Skip bin and fencing requirements supplied by client.

Build 9m of colourbond fence. All consumables supplied and ready, 2bags of concrete per hole. All colourbond fencing on site ready to be installed. All 4 holes dug already to around 400-500mm might need abit more depends on height alignment of rear fence. Just have ran outta time and need it done to mark my boundary.

Installation of plinths under a colorbond fence 2 plinths on the first photo and 1 plinth on each of the other 6 photos

Looking at Colour bond fence replacement. Involves removing old panels, installing new and reinforce steel fence post. Will discuss if it is a bigger job

3.2 metre section of colorbond fencing fell down and needs replacing/fixing. I dont know the cost so put $10 just to create the post.

Supply and install 50m Colorbond fence, while remove old fence.

I am looking for an experienced and reliable fencer to supply and install a Colorbond fence panel to replace a damaged section. Details are as follows The panel is less than 2 metres in length, standard height Standard Colorbond fencing required Colour to match existing fence or closest available match

I need a colour bond fence pole dug out and a new post replaced

3 metres width Colourbond gate needs to be replaced with something less expensive. The gates are damaged. This area is prone to high wind.

Provide and install colorbond gate with rougly 940 mm width. Provide and install colorbond permanent fence with 2.3 meters width. 1st photo is small gate access 2nd photo is the 2.3meter width

Needing to put a colourbond fence along the back fence - 28m all materials provided

I need my colour bond fence resprayed to the colour monument . There are 37 panels in total . One high fence on retaining wall and the rest are all ground level

1.8m high and 2.4m high colour bond supply and install.

I am in Cannington. I currently have a half done side-gate. The handyman who was doing the job got into a workplace accident and is in recovery. I was hoping that we could get your help to finish the job. It is parly finished. It is missing the panel to the right, the post and the latch to lock the fence. Would you be able to help me with this job? Some.material needs to be procured, I have one post, but the colorbond panel and latch/lock is still required.

Approximately 11-12m of hardifence has broken and needs to be replaced with hardifence or colourbond fencing

Install approx 20m colourbond fence, i already have purchased approx 14m ish plus corner posts and cement, plus bluemetal. Im after quotes, pref someone local that can do a cashie.

Install approx 30m of.colourbond fence (woodlands grey to match style in photo) with aliwall to a finished height of 1.8m above grade. Install additional approx 7m of colour bond fence (with no aliwall) to match height. Remove and dispose of existing fence.