Find a local electronics repairer in Sydney

Need an experienced handyman to disassemble an IKEA bed and a table in the living room, carry those upstairs within my apartment, and reassemble it in the upstairs bedroom.

Jumpstart car. Car hasn’t been driven in four months and so battery has run flat. It is a well-maintained car Toyota Corolla 2014.

Downlights (install only, we supply): 8 x convert existing lustre/ceiling lights to recessed downlights (90mm cutouts, plug bases as needed) 2 x replace existing downlights in bathroom (like-for-like swap) New power points (supply and install, Clipsal Iconic): 1 x weatherproof double GPO on balcony — new point, no existing outlet (strata approval may apply, please note in quote) 1 x double GPO in kitchen, next to existing double 1 x double GPO in bathroom, next to existing double 1 x double GPO inside bathroom cabinet — new point, no existing outlet 1 x double GPO on opposite side of bedroom — new point, new cable run Full changeover — supply and install Clipsal Iconic GPOs/switches/TV/data (covers/plates included): • 2 x 1-gang switches • 2 x 2-gang switches • 2 x 3-gang switches • 3 x TV points • 2 x data points • 1 x 2-pole switch mech • 8 x double GPOs • 2 x double GPO + switch LED strips (install only, we supply): • 1 x 2m strip in toilet • 1 x 2m strip behind bed frame • 1 x 3m strip under kitchen bench • LED strips inside built-in wardrobe Must be a licensed NSW electrician and issue a Certificate of Compliance (CCEW) on completion. Please itemise your quote where possible. Flexible on dates.

Weather brush seals have worn, need replaced or alternative weather sealing solution for bi fold windows

Our shower is dripping water. The ceramic disc taps need replacing.

I have 4 old Sonos Amps which need to be disconnected, and then connect up 3 new Sonos Amps. For one of the new amps, it will be going to the wires where one has already been disconnected. All speakers are in ceiling/behind vents and all work, so just need Amp’s swapped. Thanks!

Install shower taps in bathroom. New parts provided. License plumber only. Can provide parking if your vehicle is below 1.85m.

need to change the powerpoint from 10amps to 15amps

Looking for a handyman to complete a small patch-and-paint touch-up job in our office. Scope of work: * Patch minor holes and marks from 3 TV wall mounts * Patch minor holes and marks from a board/signage area * Touch up paint the repaired areas to match the existing wall colour This is a relatively small office maintenance job. Please bring the necessary tools and materials and provide a fixed-price quote. Location: Sydney CBD Parking: Available on-site Looking for someone who can complete the work neatly and professionally.

The tap spindles are threaded so taps wont turn off. I have done a temporary fix to stop the leaking but need the job done properly .

Need to hang 3 pendant lights with shade, I have the lights and cords and shades. Change from Led downlights.

IKEA assembly 800mm Billy book case with doors and ext, 2x klepstadd wardrobes.

Looking to install new laminate over our existing benchtops. Laminate is in good condition Price is for an initial chat about the project

Hi everyone, I need someone to go to Bunnings tomorrow and purchase around a dozen key rings that are 30 mm wide. We then need someone to go to a customer's home in Wooloware and fit these off for the customer. Must be done tomorrow (Monday) I've attached a few photos. Essentially one of the Lobster clips has lost its spring and is no longer attaching. Therefore instead of replacing these individually we're just going to put key rings on each of the rings to reinforce the support for good measure. We are going to install these on the rest of the clips on this so far, as opposed to just the one I've attached few photos. Someone with handyman experience and is great with customers is required

We need a wardrobe taken apart on bottom level and then taken up one flight of stairs and rebuilt as it won’t fit up the stairs without being taken apart.

Hi! I have new shower taps I need installed, as one of the old ones is broken and coming off. Needs to be finished before 9am, as water is connected to restaurant downstairs.

Need a jumpstart now in surry hills please!

1. Build a palisade for the dog sport Mondoring. 2. Build a hurdle for the dog sport Mondoring. 3. Build the long jump for the dog sport mondioring. Mondioring Jump Measurements (FCI Standards): Hurdle (High Jump): Width: 1.5 meters wide. Height: Adjustable, ranging from 1.0m to 1.2m depending on the level (MR I, II, III). Structure: A movable panel, 60 cm high, topped with a turnstile or 3 bars. Level Requirements: 1.0m (Brevet/Level 1), 1.0m-1.1m (Level 2), 1.0m-1.2m (Level 3). Long Jump: Length: Adjustable from 3 meters to 4 meters. Width: 1.95m-2m. Structure: A frame of planks, starting at 10cm high in the front, Alloy sides or bands every 30cm. Palisade (Wall): Height: 1.7 meters to 2.3 meters, with a sloped descent on the back. Width: 1.5 meters to 1.9 meters. Structure: A vertical wall with wooden boards 10cm high and 27-30mm thick, with a slant for easy descent, supported by beams These 3 jumps we would like welded to the specific measurements according to the rule book.

Change taps in shower. I have bought the new taps