Find a local console repairer in QLD

Need someone with Toyota Techstream or an advanced Toyota-compatible diagnostic tool to disable the reverse beeps in my 2007 Toyota Prius. Currently the car makes a loud high-pitched reverse beep inside the cabin when the car is put into reverse. When reversing there are softer, continuous beeps. I would like both fully disabled if possible (including the initial single beep), not just changed from continuous to single-beep mode. The job should only take a few minutes for someone with the right equipment/software and experience. Thanks 😊 Located in Burleigh Heads.

Need licensed Qld plumber to replace 2x bathroom basins 2x bathroom taps 1x refit toilet cistern Must have ABN Basins and taps are supplied New basin: https://www.bunnings.com.au/mondella-square-flair-wall-hung-1th-basin-rh-bowl-rococo_p4822893 New taps: https://www.bunnings.com.au/mondella-cadenza-35mm-chrome-lever-handle-basin-mixer_p0670050

Unsure to budget, Cut down and remove palms inc stumps. Due to powerline within the radius, branches must be removed first then gradually shortened until the height is below powerlines & house … I don’t mind if you cut from that height whole. .. approx 50% of height is above lines/is the length that could hit the house.

Looking for a licensed plumber to remove existing taps and install new taps that I have already purchased. Scope of work: Remove and replace 8 mixer taps (including kitchen mixer tap) Install 1 water filter tap Notes: All new taps/fittings will be supplied by me. Existing taps to be removed and disposed of if possible. The filter tap will be installed by removing the old InSinkErator button and using the existing hole, so ideally no benchtop drilling required (subject to suitability upon inspection). Please include labour and any minor installation materials required in your quote. Located in Hope Island Please advise availability and confirm you are licensed.

I need the mixer removed (it has a copper bridge pipe behind that needs cutting, and all those 4 taps to get relocated to close to the floor(350mm off the floor) just leave the female threaded pipe to be out after relocation and cap it with hex plug.that drain pipe needs cutting and i nedd a new flush mount puddle flange to get installed in my drain inthe ground- certified plumber and i need invoice

I have few yakka, papaya,palm tree roots in my backyard which needs to be removed. The task involves completely remove them and dispose. I have attach the photos.

Washing machine and dish washer taps are leaking when connected and turned on. Need some to repair or replace them. Thanks

Need to be neat in gaps in floorboards approx 10 square m I have materials except no corking gun

Lights fuse keeps tripping in office switchboard. Other fuses seem fine and those circuits are working.

I need four small hedge stumps dug up/pulled out. No need to take away, just pull up / cut roots. I recon it would take maybe an hour and half. So a Spade and maybe a Pinch Bar or Mattock and some muscle. Any time is fine

Hi, We’re looking for a qualified mechanic to do a pre-purchase inspection on a 2009 Toyota RAV4 AWD located in Ipswich. The inspection would include a general mechanical check : engine / gearbox / suspension / brakes / a test drive Please bring any diagnostic tools if possible. We are available on Monday 18th, Tuesday 19th. Thank you!

Needs reseating and new valves.

I've bought some new taps that I've tried installing myself with no luck. There are two sets, one for each bathroom. Please quote.

We need a rental in Nambour ready for presentation ASAP. *Budget quoted is the hourly rate, photos are being uploaded shortly. Paint touch-ups and caulking throughout the house (3 bed, 2 bath, plus kitchen and laundry), plus outdoor paint touch-ups on Corro Trimdek panels. Not full repaints. Scope of paint and caulking work: - Wall touch-ups throughout - Skirting touch-ups - Ceiling touch-ups where needed - Door and cabinet door touch-ups - Balustrade touch-ups - Louvre window bracket touch-ups - Outdoor Colorbond cladding — clean down and spray -scratched areas - Silicone and caulking work in the bathrooms - Silicone and caulking work in the kitchen - Silicone and caulking work in the laundry Some paint/materials are already on site, but we may need to purchase more — we will cover these and the travel time to pick them up from Nambour Mitre 10 / Duke's Paint Shop. We have other small jobs that need to be completed — ideally, if we can find someone who can do all of these that would be excellent. We are also happy to pay a bonus if these works can be completed by 19 May - we can provide further details on request: Re-hanging four upper kitchen cupboard doors and fitting handles Hooking up a dishwasher and kitchen sink to existing connections Replacing one blistering vanity door in the powder room (new MDF or chipboard, fit hinges) Installing a short run of pool fencing as a balustrade out the back (less than 3.5m lineal metres) Hanging curtain rods x 5 Replacing 2 x plastic toilet seats A few items to drop at the tip — 2 tip runs max Treat Corro roof section (0.5sqm with Ferocite, silicone existing holes) Fix front gate latch Gurni small section of balcony (we have a gurni alread) Fix wobbly timber balustrade at front landing Install 4m of skirting ABN preferred. We pay well and on time for work done properly. If you take pride in a clean finish and a tidy site, this is the job for you.

Need this garden stripped bare, the fern removed and about 10 Stumps dug out from previous shrubs. Soil then turned over and mulch applied ready for replanting.

Smart Door Lock Installation – Philips DDL709-7HWS-C (Front Door) Looking for an experienced professional locksmith to install a Philips DDL709-7HWS-C smart door lock on my front door. Job Details: - Install Philips DDL709-7HWS-C smart lock - Front entry door (approx. 1.2m wide) - Ensure proper alignment, secure fitting, and full functionality - Set up basic configuration (if required) Requirements: - Proven experience installing Philips smart door locks - Must have own tools - Attention to detail is important to ensure a clean and professional finish Location: Park Ridge 4125 Timing: Preferably ASAP (flexible with date/time) Please include: - Brief description of your experience with similar installations - Any photos of previous work (if available) - Your quote Looking for someone reliable who can get this done properly the first time.

I need a quote to completely remove 3 x small trees & remaining stumps

I have two food grade 1000l IBCs that i need the tops chopped off. This will involve measuring and cutting the metal cage and the plastic container. You will need to bring your own tools such as a angle grinder/cutting tools

HI Taskers – I need two vintage lamps re-wired and checked over. They currently have American plugs so need to fix that. Also one has a bulb mount that needs to be re-mounted.

There are currently x8 door stops installed at the property, x4 plastic and x4 rubber. All are currently screwed into the doors rather than the skirting. We believe there isn’t much longevity with them being screwed into the doors, as the doors are quite thin, so could you please provide a quote to relocate the door stops and fix them to the skirting instead?