Find a local console repairer in Sydney

Need a twin sinks and taps plumbed, originally a single sink setup so will need a T piece to join to origanal water inlets, and install new p traps for sink wastes, theres an AC drain pipe to connect into waste also. Vanity is driled for waste pipe already T pieces and conducts and p trap needs to be suppled. Might need a 90 degrees fitting on water outlets to avoid drawers and one tap will need water pipes extended

I have the following that require rewiring: - 5 Floor Lamps - 6 Table Lamps

Water keeps flowing into the toilet bowl without flushing as shown in image. It’s a wall‑mounted dual‑flush system.

- Replace existing hot and cold shower taps with a single mixer tap - Install a water flow valve for a shower station - Potentially replacing pipes that need upgrading

Need - loose bath room taps fixed - Improved bathroom sink drainage also - toilet check

I’m looking for an experienced stone repair specialist to fix damage to my kitchen benchtop. Issues include: • Several small chips along the front edge • Visible discolouration / staining on the surface (see photos) • General patchy marks that I haven’t been able to remove with normal cleaning The benchtop appears to be engineered stone (light/white colour). I’m hoping the chips can be filled and colour-matched, and the staining treated or polished back to an even finish. Please only respond if you have experience with stone benchtop repairs and refinishing.

We have some nails that need to be pulled out and stick tape marks that need to be covered and painted over in our office in Haymarket

Poison 2 stumps and make sure they won't grow new branch. One is pine tree, around 1 meter diameter. One is black locust, around 50cm diameter. I don't have tools, you need to bring your tools or poison.

Safely and professionally. Must be certified/qualified. Scope of Works – Disconnections for Disposal 1. Safely disconnect and isolate the oven to allow for disposal. 2. Safely disconnect and isolate the gas cooktop to allow for disposal. 3. Disconnect and cap off the kitchen sink taps as required for removal. 4. Disconnect and cap off both bathroom sink taps to enable disposal of the cabinets.

We’re moving out of a rental after 8 years and are looking for an experienced painter and wall patcher / plasterer to help get the walls back to a good, presentable condition. There are various marks, small holes, dents, and scuffs across the house from general wear and tear, hanging items, and a dog (some scratching on doors). This is very much an end-of-lease tidy-up, not a full repaint. The job is for 8 hours total, focusing on getting as much done as possible in that time rather than aiming for perfection. Property details: • 3-bedroom house • House will be completely empty • Walls + some doors need attention What’s included / not included: • ✅ Paint will be supplied (matched and ready) • ✅ Drop sheets provided • ❌ You’ll need to bring your own tools (brushes, rollers, buckets, sanding tools, etc.) • I will patch what I can the day before so it has time to dry Timing: • Monday 2nd February • Ideally 9:00am – 5:00pm (or as close as possible) Important notes: • This job is based on time, not a fixed outcome • We understand that repairs and painting don’t always go perfectly from A → B • Photos of example damage will be attached to give a clear idea of the work involved Looking for someone reliable, efficient, and experienced with end-of-lease repairs.

Oven isn't working, keeps tripping the breaker. Still functions in the microwave mode but not in oven mode for more than 5 minutes. Can be fixed either this afternoon Monday 19 Jan or Tuesday 20 Jan.

Hi there! We’ve just had a new kitchen installed and are looking for an experienced painter to help with a few finishing touches. Scope of work: 1) Paint an MDF bulkhead to match existing wall colour (Dulux Natural White – low sheen Wash & Wear) 2) Ceiling needs either a full repaint or touch-ups where plaster work was done (Dulux Natural White – flat) 3) One small section beside the dishwasher requiring either a touch-up or repaint of the whole wall. 4) Paint a half-wall on the front And if you have any advice on some of our badly painted vents/sprinkler in there, we're open to that too! Trim throughout the area is Dulux Natural White – semi-gloss, if that's needed. What we’re after: -- Someone who’s comfortable with small to medium jobs -- Quality finish that blends with the existing paintwork Photos attached for reference. Thanks! Kristiana

I had two built-in in robes removed (eg one in each bedroom). The installer used liquid nails on some elements which took off the wall render where it was affixed. To install at parts of the robe they have also trimmed out the skirting board to make elements fit flush to the internal wall. It would be great to get a quote from you to 1) make good the rendering 2) paint the walls from behind the cupboards to match the new wall paint (I'm happy to supply this) 3) remove the skirting behind these areas where new robes will be coming in) 4) plaster or make good where the skirting is removed to create an even wall surface / no gaps between the walls/ flooring 5) infill a small portion of the skirting on the short wall where the new robe is going in. The removed robe was deeper and the skirting has been cut out at the front so will end prematurely. Would be great to fill this in 6) treat the skirting so it looks like a uniform finish I can send photos etc if the area. I'm not sure where you're located but I'm in Newtown, happy to do a site visit for a quote. My only constraint is I have the new robes arriving on Friday so I would really like to get this done in the next couple of weeks as my house is quite small so I keen to get the robes in and use the storage!!

Tap would not turn off - water keeps pouring out. Needs tightening.

Hi :) I’m looking for an experienced person to assemble my IKEA KLEPPSTAD double bed and also disassemble the single one first, I have in my room. Both beds are KLEPPSTAD from ikea Thanks!

I have two short cement steps under a sliding door that need to be smoothed and levelled out. They were previously tiled and now have a rough cement finish that I’d like to make even and ready for future sealing or painting. Dimensions: • Step 1: approx. 5.5 m long × 12 cm high • Step 2: approx. 2.7 m long × 12 cm high What’s required: • Lightly sand, patch, or skim-coat both steps with a fine render or levelling compound (e.g. Dunlop Fine Coat, Ardex Feather Finish, or equivalent) • Ensure smooth, even surface and clean edges along the flooring and door frame • No painting or sealing needed — just a clean, neat finish This price is for labour only. I’m happy to cover or purchase all materials — the Tasker can let me know exactly what’s needed.

Stop water flowing into bowl. Remove broken buttons. - View all the details of this offer: https://www.airtasker.com/offers/01K876JEWNAKDZXH64SVBPRW17

Looking for an experienced locksmith or handyman to install a Philips EasyKey DDL615 smart mortice lock on a timber front door. This is a retrofit job – the door currently has a DORMA mortice lock installed (photos attached). The new lock will use the same mortice cavity, but the front face holes will need to be enlarged slightly to fit the Philips lock template. Job details: • Door thickness: 40 mm (1.57 inches) • Backset: 60 mm (2.36 inches) • Door material: solid timber veneer • Current mortice: DORMA (standard Australian 60 mm backset) • New lock: Philips EasyKey DDL615 smart lock • Some minor chiselling or hole enlargement.

Hi, I’m looking for a licensed plumber to replace 4 taps total: 3 × basin taps (bathrooms) 1 × kitchen mixer tap All taps have hot and cold-water connections, and I already have the new taps ready to install. Details: Apartment is under 7 years old (modern plumbing). Straightforward replacements — no leaks or damage. Easy access under basins and kitchen sink. Please bring your own tools and plumbing tape. Photo 1: shows the new tap for bathroom Photo 2: shows the new tap and old one side by side, as a reference. Mirrors will be removed later.

Looking for someone to unlock the door of a front loading washing machine. I noticed just before I closed the door that the wash cycle had changed Manual https://commercial.appliancesonline.com.au/public/manuals/SWF7025EQWA-User-Manual.pdf