Find trusted local electricians in Winston Hills

Power is underneath here, need to pull twin and earth to install a gpo behind tv wall mount and aerial connection, Already have GPOs, cable, aerial outlet and brush wall outlets to pull HDMI through

Supply and in install 4 downlights in a bedroom

The panel for air conditioner needs fixing. Please see photo attached. The display doesn't work..

Hi guys. I need an electrician to help me check my power line. Last night. All sudden the whole power cut off for 1 second as I can see the light flash and then turn back on. Later we found a few power points stopped working. Need someone to help me find out the cause. Please let me know if you can help.

I need my TV wall mounted with the bracket I have purchased. I will also need the power point moved up behind the TV and wires all tucked behind the TV

There are currently NINE (9) 50W x 100mm dia. gimbal halogen downlights with 12V power supplies, controlled by three (3) individual motion sensors, installed in the eaves of our single storey home. We would like quotes to remove all 9 downlights, and to replace them with 9 x LED gimballed OUTDOOR downlights of the same size, and with equivalent or preferably higher lumens. ♦️NON DIMMABLE, SINGLE COLOUR WHITEST POSSIBLE♦️ Notes: 1. ⚠️The eaves contain asbestos, so the holes already in place to flush-mount the existing downlights should be used for the replacements. 2. The motion sensors will remain assuming they're suitable.

* Supply and replace single phase consumer mains from P.O.A to switchboard to meet AS3000 standards (Current cable is under rated) * Supply and replace 80amp SPD/MPD * Supply and replace asbestos panel * Removal of existing smart meter for upgrade and reconnect once upgrade is complete * Supply and upgrade sub board in switchboard with new single phase main switch and extend all final sub circuits * re seal switchboard * Test and commission circuits and new equipment * Disconnect and reconnect of new consumer mains

Ducted air conditioning turns on but doesn’t get cold enough. Although air is coming through the vents. When it says budget I’ve allocated call out fee but understand parts will cost more. - Due date: Needs to be done on Friday, 8 December 2023

Looking to have the powerpoint moved about 3m along the same wall so that it goes behind the TV unit. Licensed electrician only - Due date: Flexible

Need a power point near dishwasher and someone to install the dishwasher properly - Due date: Flexible

one switch at bath room turn on/off is not working probabaly spring is gone - Due date: Before Sunday, 30 April 2023

Hello may I please get a quote for the following: - Install 2 ducted exhaust fans in 2 bathrooms and use the duct to connect the grill and install it in under the eave. The old fans need to be replaced as shown in the photos as they are no longer working. I already have the 2 exhaust fans, the 2 ducts and the 2 grills supplied. I also need to install 2 led downlights in one of the bathrooms, I think the bathroom might need wiring for the downlights. This bathroom will require a new double switch to replace the existing 3 in 1 IXL switch. I will supply the 2 downlights and the double switch. Note: Both fans are plug ins. Both bathrooms are wall to wall and share the same electric circuit. - Due date: Needs to be done on Friday, 14 April 2023

Ducted aircon is not turning on properly, I can feel the wind but it's not cool. I checked outside, both fans run just fine.

I need to move 2 electrical points to the back of the fence, I’ve recently installed a new pool shed and need to make it look neat and tidy. Right now it’s a bit far from the pool shed. There’s also a similar point opposite the shed which needs to be moved. - Due date: Before Sunday, 18 December 2022

Hi, We recently had to change gyprock ceiling in our lounge room due to a water leak. We need someone who can drill the hole cutouts for the downlights. (existing plug bases are still there). We will provide all material. Scope of works is: - Cutout 14 x Downlights and install downlight to existing Plug base - 6 x new GPO to be fitted to existing power outlets - Change 3 x Outdoor sensor lights - Due date: Before Tuesday, 19 July 2022

1. Adds three LEDs in the lobby 2. 1*LED mirror in the bathroom 3. 1*LED mirror in the living area 4. replace one IXL 5. relocate power and tv point to behind TV. 6. install 3*spot light - Due date: Flexible

Led light. Turns on sometimes but then automatically turns off within a minute. Other times, it doesn’t turn on. Please fix. Would appreciate this weekend. Winston hills location

Take off our old fan/light and replace with our new lights. There are three to be done. Winston Hills location.

Take down 3 light fittings and fit 3 ceiling oyster light fittings in the same place. Photo shows one of three identical light fittings to be taken down and one of three identical oyster lights to be connected in the same place. Ceiling is normal hight. You need to be an electrician to do this. Needs to be done Monday morning 28 - Due date: Needs to be done on Monday, 28th Feb 2022

Please remove ceiling fan/light and replace it with ceiling lamp which we’ve purchased. Not in a rush, anytime when convenient. Winston Hills