Find trusted local electricians in Gold Coast

Hi, I need a licensed electrician to ensure my property is fully compliant with QLD rental smoke alarm legislation before leasing. Scope: 🔥 Smoke Alarms ✅ Supply & install compliant photoelectric, interconnected smoke alarms ✅ Install in all legally required locations (bedrooms, hallways, each level) ✅ Replace any outdated alarms ✅ Provide compliance confirmation for rental 💡 Lighting ✅ Check all light fittings are operational ✅ Replace bulbs where required ✅ Advise on any unsafe fittings 📍 Location: Reedy Creek, Gold Coast 📆 Required before new lease starts

Diagnose electrical fault and fix

Need to have a kitchen power point (incorporates power and hot plate switch)moved up approx 10cms and blank installed over existing spot. Power point secured to pantry cabinet wall- see photos.

Licensed and insured electrician to fix electrical fault

I need someone to check electrical fault and fix aircon pipe to go to drainage

Check electrical fault , no electricity and aircon pipe not properly installed

Electrical - replace 4 fans and a pendant light

I have tasks for a registered electrician - (1) remove living room fans and replace with the 2 new fans I have here; and (2) replace all power points and switches (1 bedroom unit)

We currently have 6 Google Nest smoke alarms installed. We need to change these for 6 new smoke alarms. We are OK to purchase the FirePro Connect 10 Year Lithium Wi-Fi Wireless Interconnect Smoke Alarm (or similar) and have them onsite ready to swap out. We are looking for a licensed electrician that can also provide a QLD compliance certificate as part of the work.

I'm looking for smoke alarm testing and replacement of batteries. It's down pimpama

Replace 2x outdoor light fittings

Remove 6 pendant lights and replace with down lights licenced and certified electrical contractor only

Hi, Looking for a certified sparky to install 2x Exhaust fan/Lights/Heat light in both our bath rooms. Exhaust fan is not working. Was going to purchase them but unsure which one is best for making it an easy job, Also looking to have a new power point installed behind the pictured bed side table. Closest power is either from the light switch pictured, or in the bathroom behind pictured door. Thanks

I have an old outdoor security light. Just need it replaced with a new one that I bought from Bunnings. Should be a quick easy job for an electrician/handyman. Photo is actual current security light. Flexible on time. Location Ormeau.

Hi, I have an outdoor fan installed when house was new .. it doesn’t work and builder is not available to fix. I believe the cable needs to be found . I have a remote for the unit but doesn’t work. Also need electrician to fix my garage light sensor. which plays up and works whenever it wants to. Cash can be $60 an hour until fixed or flat price can be negotiated. Must know what they’re doing and experienced with feedback in order to get this job. Price listed is for 2 hours, any further hours will be $60 an hour cash. I’m guessing this could easily take 5-7 hours. Cheers

Install a small chandelier type lite in our townhouse entry/atrium. Please not that the atrium is about five/six meters high. There is an existing small recessed light already there.

I need a licensed electrician to install 6x remote control ceiling fans with light over the downlight point: 4 in bedrooms, 1 in Dinning and 1 in Living room.

Bathroom light is not working, needs to be changed. Supply and install one downlight

I have FTTP NBN with the NBN fibre box (NTD) located in the garage. Currently, my router connects via ethernet to a data point downstairs (study). I want to keep this existing downstairs connection and add a second Cat6 ethernet point upstairs so I can relocate the router out of a new nursery. Scope of work: • Run one additional Cat6 ethernet cable from the NBN box in the garage to an upstairs room • Install one ethernet wall plate upstairs • Keep the existing downstairs data point active • Terminate and test the new connection House is two storey. No NBN or ISP work required. Licensed cabler required.

One ceiling fan to be replaced with a new fan purchased. The fan speed setting stopped working a while ago, and removed the control from another fan and replaced, but still did not work. So will also require the control box returned to the other fan. Hope this makes some sence? The photo is the existing fan, the new fan is similar. The existing fan has been discontinued.