Find trusted local electricians in Outer South West Sydney

Need a circuit put in for a 15a spa the spa and box are in close proximity between 5 to 10 meters No trenching or anything needed be done just conduit which I can supply cable and circuit breaker at the box

supply and install small air conditioner split 2 bedroom upstair and 1 living room downstair.

Looking for a licensed air conditioning installer to install a 7.0KW SPLIT SYSTEM REVERSE CYCLE, there’s already an old unit but want it replaced with a newer ac, all electrical cables and wall is ready for a new ac, just take off the old unit. I will supply the ac unit. It’s a single storey house.

Install a ceiling fan in the dining area area

I am looking for roofer for solar panel installation

one light fitting in the kitchen and take old fitting two light fittings in two bedroom

Require licensed and insured electrician to: 1. Install 3x standard white double GPO/power points. There is an existing PowerPoint close by, which needs to be dummied. Attached photos, shows where the new power points need to go (red boxes) and where the existing PowerPoint sits (Blue box) on the wall. 2. Install 3x LED downlights (i will supply the downlights) and supply/install matching wall switch. Attached photos, where the new downlights need to go (red circles).

Just to install the monitor for camera and in phone and also to change the password for alarm

Air conditioner unit when on cold setting leaks from inside unit.Doesn't happen on heat setting. It is a LG inverter V unit.

I have a fence that has a circuit created to keep my dogs within my property . The system is called ‘hidden fence’ and it relies on 2 wires that is connected back to a battery . I have had a pup chew through wire - and it needs fixing .

Requesting a Class 2 Electrician to: Reroute underground electrical line as wanting to put pool in and home line supposedly goes diagonally through backyard to private granny flat pillar (approx 30m apart). Also requesting to relocate private pillar by approx 1- 2m.

I have 24 hard wired down lights through the house and want to replace them with new ones purchased that have a power point but can also be hardwired if needed.

The current light switches are being pushed back into the wall when pressure is applied, so we need switches that are strong, secure and resistant to being pushed in, while still being suitable for everyday use.

I need to install two new power points for wall mounted tvs, and relocate the two existing tv antennas beside the power points

Bathroom light switches cover has fallen off including 1 button.

Rewiring of a bunch of 12v circuits on multiple vehicles and plant General 12v work, no license required ongoing weekly work available

I already have the Tesla Wall Connector hardware ready to go. Single storage house with roof manhole access. The installation spot in the garage is under 10 metres from the main switchboard. all necessary wiring/conduit and a 40A Type A RCBO (combined circuit breaker/RCD safety switch). Must be a licensed electrician and provide a Certificate of Electrical Safety (CCEW/COES) upon completion. Let me know your quote. Thank you

Hi, I need someone to supply and replace PLV 500kpa as per photo, the existing one is leaking water consistently. Easy access ground floor property in Ingleburn

Power point is working normally. The front cover/faceplate has come loose and needs to be secured or replaced. Photos attached.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Narellan Town Centre, to replace two faulty ceiling downlights. The Issue: Two recessed LED downlights at the front of our store have stopped working. The Job: The task is to replace the two faulty LED downlights. The scope of work includes: 1. Safely accessing the light fittings in the ceiling (a suitable ladder is required - ceiling height: 3.5 meters). 2. Diagnosing the fault for each light (e.g., failed LED unit or faulty driver). 3. Supplying and installing two new, suitable replacement LED downlights and/or drivers. 4. Ensuring the new lights' colour temperature and brightness match the other existing lights. 5. Testing the new lights to confirm they are fully operational. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools, including an A-frame ladder appropriate for a standard commercial ceiling height. - The contractor must be able to supply two standard replacement LED downlights and drivers. Location & Timing: Location: Narellan Town Centre, 326 Camden Valley Way, Narellan NSW 2567 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying two new standard LED downlight fittings. Thank you.