Find local power point installers in QLD

need 4 power points moved, down lower in the kitchen

Look For someone who can do Job for new 4 new power point and put new 3 pendant light in kitchen island

I need an electrician to assist me install a camera by creating a power supply.

Need a switch board replaced, it has gone direct , can’t turn the lights off even after turning the switches off

Need an electrician to put in a PowerPoint

Replace 2 ceiling lights with ceiling fan/lights. A few additional power point installations if possible.

I have new pool and needing light wired up and outdoor PowerPoint, there is an indoor power point right where we are needing the pool pump power point installed

Kitchen Powerpoint not working

Need someone to bring the bulb (buy it) and install into lighting fixture. One bulb needs replacing, all others are working. Must have a tall ladder as ceiling is 10ft tall. Bulb specifications are pictured. Fix 2 Ethernet wall plugs (the switch has fallen behind accidentally after pushing it in too hard). Switches work perfectly fine - it’s just the cable has fallen into wall 2-4cm.

Looking for a licensed electrician to complete a few small electrical jobs: Reposition one existing light switch in the garage Move the existing power point for a fridge higher up the wall (inside the house) Install two additional new power points (inside the house) All areas have easy access. Power points and switch plates are provided — just need installation only. Please include in your offer: Your license details Estimated time to complete the job Availability over the next week Located in Nambour Budget: Around $400 (flexible depending on job details)

I need a double power point installed in my dining room wall.

NBN cable is in the roof of my yoga studio and nerds to be relocated so the ntd and modem can be plugged in near a power point. It is quite long so allows some leeway. Hopefully install a cable wall plate so it’s tidy?

I’m replacing my existing hard-wired oven (20A) with a new oven that has a 10A plug. The current setup is a hard-wired 20A oven circuit (with existing cabling in place). I need a licensed electrician to: Disconnect the existing hard-wired oven connection. Install a standard 10A single power point (or double) (surface-mounted or flush, depending on what suits). Replace the 20A circuit breaker at the electrical switchboard with a 10A breaker to suit the new outlet. Test the circuit for safety and compliance (RCD, earthing, etc.) Notes: The existing cabling and circuit are already in place — just need conversion to a socket outlet. The new oven is 10A with a standard plug (comes fitted). Please bring all required parts (10A socket, 10A breaker, etc.) and include them in your quote. Location: Robina When: Flexible — ideally within the next week. Requirements: Must be a licensed electrician (please include licence number in your offer).

I would like a fan to be connected to existing plugs.. I have already removed and replaced the old fan just need new one to be connected to same spot. And I would like about 4 new power points installed in the house on various wall. Power already on the wall on other side on another room, just need more to be pulled through

One of the power points in my house has stopped working. It’s an internal wall, easy access. I need a licensed electrician to come and check it, then fix or replace the power point if needed.

We need a licensed electrician to install a double outdoor power point in our courtyard. • The outlet will be run through a brick wall from the bedroom. • Must supply and install a weatherproof (IP rated) double power point.

I'm looking to get three power points installed. Two internal and one external.

Get foxtel running and move power point

Need a power point added in one bedroom, and a power point + tv cable moved for a wall-mounted tv