Find local power point installers near you

Require a twin point outdoor PowerPoint to be installed on the external brick wall of our house. House is brick veneer and there is an existing GPO on the internal wall where we want the outside point located. Photo supplied for reference.

Install 5 new power points and 13 down lights

Move power point 30cm there is a location behind tv Additional electrical will be required lights etc as stage 2

Supply and install a 32A PowerPoint in Garage for EV charging. There is already a power point in garage but that is normal 10A one which is slow for charging. The new PowerPoint has to be dedicated circuit. Added some photos as requested. Also note switchboard is also in garage.

We want to get a quote from you, there are a few things to replace: 1. To replace a power point 2. To replace a bathroom heat lamp bulb 3. To replace the light in the laundry which has lost the cover to a new light (the original cover is 20x20cm) 4. To replace the exhaust fan of a bathroom and the cover (diameter:24cm) (I guess the actual exhaust fan part is inside the roof) Please supply the materials (basic ones are good enough). Thanks.

Need to fix a power point in ceiling for projector mounting. Double story house. Theatre room is upstairs. Need to be done today.

Need to relocate 2 existing power points vertically into cabinet.

I need to get a double power point positioned on my front balcony of my unit block

Need installation of 5 -6 sets of 3 phase 5 pin wall plug point with circuit breaker and a junction box..material except wires will be provided. Can pay by the hour..

I need a double power point installed in my dining room wall.

Replace a broken Double GPO, install an extra double GPO next to an existing GPO, remove and install a new range hood.(exactly same model) These are all provided.

NBN cable is in the roof of my yoga studio and nerds to be relocated so the ntd and modem can be plugged in near a power point. It is quite long so allows some leeway. Hopefully install a cable wall plate so it’s tidy?

Need 1 outdoor power point installing and also another in the eaves outside for a plug in ceiling speaker. Existing power is 1-2 metres away in both locations

I’m replacing my existing hard-wired oven (20A) with a new oven that has a 10A plug. The current setup is a hard-wired 20A oven circuit (with existing cabling in place). I need a licensed electrician to: Disconnect the existing hard-wired oven connection. Install a standard 10A single power point (or double) (surface-mounted or flush, depending on what suits). Replace the 20A circuit breaker at the electrical switchboard with a 10A breaker to suit the new outlet. Test the circuit for safety and compliance (RCD, earthing, etc.) Notes: The existing cabling and circuit are already in place — just need conversion to a socket outlet. The new oven is 10A with a standard plug (comes fitted). Please bring all required parts (10A socket, 10A breaker, etc.) and include them in your quote. Location: Robina When: Flexible — ideally within the next week. Requirements: Must be a licensed electrician (please include licence number in your offer).

New installation so need to run thecabel and Hard‑wire IKEA KOLSTAN induction hob (7.4 kW). Provide compliance certificate. Also Supply and install 3x new standard GPOs (10 A), including cabling. Single storey, tiled roof

Needing a GPO installed on external wall. House is single storey, double brick with roof access. Refer to photos - somewhere in the marked up area ideally.

We are needing 2 double outdoor power points, and one double power point in the garage. House is a low storey brick house.

I would like a fan to be connected to existing plugs.. I have already removed and replaced the old fan just need new one to be connected to same spot. And I would like about 4 new power points installed in the house on various wall. Power already on the wall on other side on another room, just need more to be pulled through

Replace a double GPO in bathroom

We are renovating a laundry and need to move a power point from the side wall to back wall and install a new one above where the sink is going (see images)