Find trusted local electricians in Gold Coast

Looking for a licensed electrician to complete a job at my home. Multiple power points have been covered over when walls in bedroom have been re-sheeted. • Wiring is already in place • Need wiring located, pulled through and connected • Install Clipsal iconic power points • Cut hole in new plasterboard for the PowerPoint • Property is easily accessible single level, easy roof access if needed Also one power point to be connected in a bathroom cupboard. Wiring in place, hole needs to be cut inside a recessed mirror cabinet, wiring pulled through and connected. No cutting of tiles needed.

Removal of broken solar panel and fixing roof racks

Remove 11 old solar panels and two invertors and dispose them. Rails can stay on the roof.

Need electrician to disconnect and cancel power point which will be behind new shower area in bathroom. Two switches to be cancelled Also have other works I need quoting Changing all lights and fans Switches Disconnecting and removing old oven cook top and dishwasher and re installing new One and range hood etc Can quote me the rest on site

Replace 2x outdoor light fittings

New power point's fan's and smoke alarms

I need two power points pulled forward for a kitchen splash back installation this morning prior to midday

Install 4 x down lights and 1 x fan in patio roof, will need to be all connected and installed with switch on wall

Need to repair air conditioner…. States e2 n e3 error

Remove 6 pendant lights and replace with down lights licenced and certified electrical contractor only

I have an old outdoor security light. Just need it replaced with a new one that I bought from Bunnings. Should be a quick easy job for an electrician/handyman. Photo is actual current security light. Flexible on time. Location Ormeau.

Hi, I have an outdoor fan installed when house was new .. it doesn’t work and builder is not available to fix. I believe the cable needs to be found . I have a remote for the unit but doesn’t work. Also need electrician to fix my garage light sensor. which plays up and works whenever it wants to. Cash can be $60 an hour until fixed or flat price can be negotiated. Must know what they’re doing and experienced with feedback in order to get this job. Price listed is for 2 hours, any further hours will be $60 an hour cash. I’m guessing this could easily take 5-7 hours. Cheers

Install a small chandelier type lite in our townhouse entry/atrium. Please not that the atrium is about five/six meters high. There is an existing small recessed light already there.

I need a licensed electrician to install 6x remote control ceiling fans with light over the downlight point: 4 in bedrooms, 1 in Dinning and 1 in Living room.

Bathroom light is not working, needs to be changed. Supply and install one downlight

I have FTTP NBN with the NBN fibre box (NTD) located in the garage. Currently, my router connects via ethernet to a data point downstairs (study). I want to keep this existing downstairs connection and add a second Cat6 ethernet point upstairs so I can relocate the router out of a new nursery. Scope of work: • Run one additional Cat6 ethernet cable from the NBN box in the garage to an upstairs room • Install one ethernet wall plate upstairs • Keep the existing downstairs data point active • Terminate and test the new connection House is two storey. No NBN or ISP work required. Licensed cabler required.

One ceiling fan to be replaced with a new fan purchased. The fan speed setting stopped working a while ago, and removed the control from another fan and replaced, but still did not work. So will also require the control box returned to the other fan. Hope this makes some sence? The photo is the existing fan, the new fan is similar. The existing fan has been discontinued.

One of the LED downlights in the bathroom is faulty. I replaced the bulb, however, when I switch the light back on, the bulb flickers and then dies.

Hi, I’m renovating my laundry (pre-90s house) and found an old red/black/green electrical cable cut off inside the wall, located about 1m below two working power points. The wall is open and easily accessible. I need a licensed electrician to: test the cable to confirm if it’s still live/connected safely disconnect it at the source or properly terminate it in a junction box with connectors/blank plate ensure everything complies with current electrical standards It’s next to a copper pipe, so needs to be made safe. Jobs in highland park 4211 Please bring required materials and provide licence/insurance details. Flexible with time — sooner the better.

I have 13 internal ceiling lights that need replacing as well as a sticky wall switch. I already have purchased the lights. Flexible on date but prefer a Friday or Saturday