Find trusted local electricians in Sutherland Shire

Remove / decommission a GPO. The GPO needs to be removed to make way for a wardrobe installation. GPO is attached to a plasterboard wall. Plasterboard repair to be done by others.

Replace both lights as pictured. One oyster one spotlight. Both need to have sensors. Must be qualified electrician. Please include supply of lights in quotes. Wanting to replace with like for like. I just need workable lights, nothing fancy, just both with sensors.

Our ducted air con system has a weak fan and is hardly cooling at all. Would like someone to take a look and do a fault diagnosis and general service.

Existing sensor has failed needs to be replaced with same or similar

- 2 TV wall mount installations (including one new power point) - 1 Power point repair - 1 new Power point installation

We have 3 downlights that are strobing or flickering. Need the whole fitting replaced. Have tried replacing the bulbs and that has been unsuccessful

Need light base changed . I have the part

I am looking for a licensed electrician to wire a Vera 900mm Rectangle LED Wall Mirror with a built-in defogger. The job requires extending the electrical circuit to the mirror's location.

Need a licensed electrician to install 12 downlights in my unit. The roof is accessible. 10 downlights to be installed in the living room. Have to put in a new switch and dimmer. 2 downlights in the kitchen, can be connected to existing switch. Both fans in the living room need to be replaced. One to a new fan and one to a hanging light as pictured. Connect to existing switch. Two other fans in the room to be taken down and replace with one oyster and one other fan. Can connect to existing switch. The new fans, oyster and hanging light have already been purchased. Installer will need to supply the downlights, switch and dimmer.

Tenant reporting bulb has blown in a ceiling fan. They have apparently replaced the bulb with no luck. Fan still works fine.

My old split system unit has stopped working properly. The fan works but when I put on hot or cold setting it works for a few seconds and then trips at the fuse box. Need it fixed. House - single story.

Needing plumbing turned off for old kitchen removal and plumbing sorted for new kitchen installation as well as electrical work such as PowerPoint installation and hooking up gas cooktop and oven. Needing asap as well have an installer and remover just need licensed plumber and electrician. Will include current kitchen and new kitchen plans

I have garden lights need tracing and get them working. may need to add additional ones.

I need 38x90mm down lights changed to LED down lights/ I have the lights and plugs.8 require a small ladder the rest do not. I will be there to clean up after you and pass stuff. Also 2 x pendant lights/wire is already there just connect and fix. Must be licensed/and reliable

Electrician needed to put socket/power outlet behind the TV. Current power is on the left and right on the floor and don’t like the exposed cord look.

Replace a broken Double GPO, install an extra double GPO next to an existing GPO, remove and install a new range hood.(exactly same model) These are all provided.

Need electrician to install 2 pendant light fittings. One in study, one in dining room.

Please help me change these old light fittings with the new ones pictured.

Have 2 fans to be installed and 1 fan already installed to be relocated in another room Have remote for smaller fan instead of panel

Hello, We require an URGENT call-out from a qualified and licensed NSW Electrician to repair a critical light switch at our retail store, in Westfield Miranda. The Issue: The main light switch for our primary optometry room has completely failed. It was working fine and then suddenly stopped, leaving the room without light. This is a critical operational issue as we cannot perform eye tests in this room, impacting our business and staff. The faulty unit is a black, two-gang switch plate containing one push-button switch and one rotary dimmer. The Job: The task is to diagnose and replace the faulty switch to restore full lighting control to the room. The scope of work includes: 1. Attending the site to diagnose the fault (likely a failed switch/dimmer mechanism). 2. Supplying and installing a new, like-for-like replacement switch/dimmer mechanism that fits the existing black faceplate. 3. Re-installing the plate and testing the lights, ensuring both the on/off switch and the dimmer function correctly. Please note: The successful contractor MUST be able to source and supply the correct replacement switch/dimmer mechanism as part of their service. The cost for this part must be included in your offer. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools and diagnostic equipment. - Experience with commercial lighting controls (dimmers) is essential. Location & Timing: Location: Westfield Miranda, 600 KINGSWAY, Miranda, 2228 (exact location will be provided once the task is assigned) When: URGENT - THIS REPAIR MUST BE COMPLETED BY TOMORROW, [17th September]. Please only make an offer if you can commit to completing this job within this specific timeframe. Please provide a comprehensive quote for the complete job. Your offer should include your call-out fee, labour, and the cost of supplying the new switch/dimmer mechanism. Thank you.