Find trusted local electricians in Gold Coast

Replace existing entry/staircase pendent with 2 new pendents that I purchased second hand . Let me know price and when you could do it , cheers .

Need downlight to be installed. Have the light and plug base. Might have more to install if all good.

I need to intall 2 power point , one in each toilet

Hi, The jobs that need to be done are as follows: 1) Replace 4 ceiling fans; 2) Replace 3 downlights; 3) Replace 5 light bulbs (high ceiling); 4) Replace one switch in the electricity meter box. Four ceiling fans, three downlights, and five light bulbs have all been purchased. The switch for the electrical meter box has not yet been acquired; please include it in the quotation. Please provide a quotation for all the above.

Looking for someone to repair and rewire two large porcelain lamps, including supplying and fitting all required lamp holders, wiring and electrical components.

I just need my 20 solar panels replaced with 20 new ones I've got. And I want you to take away the old ones, they're still working fine, the new ones are better voltage. The new ones are the same size so it should just be a simple replacement. Please see the photos for the type of roof.

(Image attached- Teco one is the one need replacing) Need a licensed aircon technician to install a 2.5kW split-system replacing an old existing unit. Existing pipework and wall penetration are already in place, so ideally looking to reuse the existing pipework. New indoor/outdoor units will be supplied. Please quote for complete installation, electrical connection, commissioning and standard materials, and advise if the existing pipework isn’t suitable for reuse.

Bracket holding up solar panels has been damaged. need the bracket replaced

I need a licensed electrician to install 4 external wall lights, remove old electric cooktop and install new one.

Looking for a CEC/licensed solar electrician in Upper Coomera to swap out 1 damaged panel. Matching replacement panel is already sitting in here ready to go. Just need replacement & confirm testing string voltage.

Extending a kitchen wall and looking to lengthen switch circuit before sheeting and plastering. Must be able to come between 9.30-10.30am tomorrow 9/9. Palm location in one of the pic shows where new switch intend to be

Rinnai HFE250SSL 250L hot watee sys not working, suspect heating element or thermostat failure. need it fixed asap.

Looking for a licensed electrician to complete a few GPO installations/relocations in my home renovation in Highland Park. Wall is currently open, so access is easy. Please see attached photo for locations. Install/relocate 4 x double GPOs One includes a middle switch for LED lighting Remove existing GPO marked with ❌ I already have all the switches/GPOs Thank you 😊

Air conditioning unit stopped working, switches on but no function after that. Old style unit looking to fix for a house sale rather than replace. Need job done asap. Thanks

I have purchased a piece of equipment from China and need the wiring concerted to Aussie standards and safety check

Job Overview I need the colour-temperature selector switch adjusted on approximately 43 existing LED downlights in a two-storey home. IMPORTANT: The ground-floor ceilings are approximately 3 metres high — considerably higher than a standard residential ceiling. You will need to bring suitable ladder/access equipment for this height. The lights are already installed and fully operational. No replacement fittings or new lights are required. Scope of Work Approximately 25 downlights downstairs 18 downlights upstairs in total, including the 2 located over the staircase Change each downlight from cool white to warm white using the existing selector switch on the fitting Carefully lower each fitting enough to access the switch Change the setting and reinstall the fitting securely and flush with the ceiling Take care not to damage ceilings, paintwork, retaining clips, wiring or fittings Ceiling Height & Stair Access Ground-floor ceiling height is approximately 3 metres, NOT a standard 2.4–2.7m residential ceiling. There are also 2 downlights positioned over the staircase, which will require appropriate equipment and safe access. Please only offer if you have the appropriate ladder/access equipment for the 3m ceilings and the two staircase lights. Please quote for completing the entire job and confirm your availability.

Movex3 light switched 2 inches. Installed 2 power points directly opposite existing power points next room. Replace 6 lights with recess lights. Wire up new 2 extraction fans. Install front outside light. Replace existing back exterior light. Replace 2 fluoro lights with recess lighting.

I need someone with a demo saw / concrete saw to cut a notch into a concrete floor at Palm Beach. - Length: approx 2 metres, straight line - Width: approx 50mm - Depth: approx 30mm (deep enough to seat electrical conduit - happy to take your advice on site) - Purpose: laying electrical conduit into the slab Please bring your own saw, blades, water or dust extraction. Wet cutting or dust-controlled cutting preferred, as this is inside a finished space.

4 x Fans to be replaced 4 x Ceiling Lights to be replaced 4 x Wall light switches to be replaced 1 x electric over install Low set house easy access

Looking for a licensed electrician to inspect and repair/replace 2 x downstairs recessed ceiling lights: * 1 x toilet light – stopped working. * 1 x laundry light – was working but stopped after replacing globes. * Both are older twin E27 recessed fittings. * Existing CFL globes show signs of heat deterioration. * Inspect/test circuit, wiring, connections and fittings to identify cause. * Replace both fittings with suitable modern LED fittings if recommended. * Test and confirm safe operation on completion.