Find trusted local electricians in East Victoria Park

Need 2 power Points one outside of the house and one inside double brick wall outside inside single. Tile roof, single story house

I need someone to get these jobs done. 1) Swap one switch ( broken) 2) Swap or fix one switch 3) Fix two PowerPoint 4) Swap and fix two lights ( room and walk-in wardrobe)

Hi, I’m looking for a licensed electrician to replace a ceiling light with an LED light and modify the existing light switch into two separate switches, so I can control each light independently (turn them on/off separately). I already have the new light ready for installation. Thank you.

I need someone to get these jobs done. 1) Swap one switch ( broken) 2) Swap or fix one switch 3) Fix two PowerPoint 4) Swap and fix two lights ( room and walk-in wardrobe)

The breaker on the switchboard keeps tripping on the Evaporative AirConditioner. Can’t even switch it back on without it sparking.

Hi, I run a small online antiques and vintage lighting shop and regularly source vintage wall lights and lamps. I currently have a handful of vintage wall sconces that need rewiring to Australian standards (approximately 7 pieces to start). Most are simple single-bulb wall lights with existing wiring that just needs replacing. Ideally I’m looking to find an electrician who is comfortable working with vintage lighting and who may be interested in an ongoing working relationship, as I will likely have more pieces needing rewiring each month. Tasks would typically include: • replacing old wiring • ensuring proper earthing • fitting appropriate cable and connectors • basic safety check • converting plug-in wall lamps to hardwired sconces with mounting plate. • rewiring table lamps to Australian compliance, with Aus plugs and new flex. Happy to drop lights off locally to avoid a call out fee each time and likely each batch will be 5-10 lights. If you could contact me with the going rate per sconce etc. Thanks Penny

Install light box and connect power on shop front canopy roof. Power already there, roof approx 2.5m high. Light box 7kg on plug

I need 3 old fans replaced and some more power points.

Install of a 2.5kw system

Just had our water heater replaced and would pls like someone to take the old one away :) has been draining so no water in it. Located vic park - its not big at all.

Replace and install a 600mm oven.

I need someone to take out an old window ac unit and install a new one. Thanks Mei

Installation of a window airon Currently there is an old aircon in there which needs removing and the new one put into place. Thanks Thanks

Reinstall 2 down lights. Existing wiring and easy access due to hole in ceiling from skylight install. Need it done before Sat when ceiling is being patched up.

One of the wires (white wire next to purple ) going into the igniter connector doesn’t have any voltage. Needing this looked at/fixed please. Pitboss pellet smoker

Electrician also required to install tv plug and power point on single brick wall behind tv. New plugs requires approx 70 cm chase from the existing plug and power point directly below the existing tv. I will do plastering, repainting and clean up.

Change 2 light switches for new ones and replace old ceiling fan with new one.

Need to install 3 pendant lights in the kitchen/lounge, PowerPoint and TV switche plus one faulty fluorescent light.

Remove existing fittings • Remove 5 x light battens. Install new downlights • Install 15 x supplied 90 mm LED downlights (cut-out size: 92 mm). • Position lights in nominated locations. • Ensure all downlights are square to the room and aligned with each other. • Of the 15: • - 4 downlights will replace each of 3 existing battens. • - 3 downlights will replace 2 existing battens. Testing & setup • Test each light to confirm correct operation. • Work with the owner to connect lights to the app (the owner will have pre-tested and pre-connected them). Clean-up • Remove and dispose of all waste and packaging from the work area. • Leave the site tidy on completion. Site details • Property is a single-storey home with no ceiling insulation. • Work can be completed on any day of the week, including weekends. Supply of electrical safety certificate is required

We have a new food production machine (1.08kW, 220V, single-phase) that needs a standard 10A plug installed by licenced electrician so it can be plugged into a wall outlet.