Find trusted local electricians in Gold Coast

Air conditioning unit stopped working, switches on but no function after that. Old style unit looking to fix for a house sale rather than replace. Need job done asap. Thanks

Replacing macerator toilet unit in granny flat. Current unit is running a cord from unit into a fixed 240v wall switch. Need wall switch changed to a 3 pin power point before plumber can install new macerator.

Standard fluro office lights x 3 bulbs to be put into place - my need a small ladder . Office .

the unit has stopped working wont cool or heat make is Daikin

Need a licensed electrician to replace 6 existing ceiling fans in a second-floor unit in Southport, QLD. Details: Replace 6 existing ceiling fans with new DC ceiling fans with lights No new wiring required Existing fan locations and switches already in place Easy access, standard ceiling height Unit is on the second floor of a low-rise building Requirements: Must be a licensed electrician Please provide your licence number and experience with ceiling fan installations $400 Location: Southport, QLD

I have purchased a piece of equipment from China and need the wiring concerted to Aussie standards and safety check

Hey! I'm looking for a qualified electrician with experience in 230/240V electrical work (and bonus for 12V campervan systems) to: - Install my 2000W inverter - Install a double 240V power point - Inspect and safety-test the 240v inverter system (and if able to the existing 12V electrical system) - Provide appropriate compliance documentation/certificate for the completed electrical installation Some info on the existing setup: I have a Renogy R-INVT-PUH1-201235-AU 2000W 12V → 230V pure sine wave inverter with UPS function that I would like installed in the protected cavity underneath the van floor. The cavity is enclosed by the vehicle's sheet-metal floor and is not directly exposed to the road. I have already pre-run the 240V cable from the proposed inverter location to the outlet location inside the van. I would like a double 240V power point installed at the end of this cable. The existing 12V system includes a 12.8V 300Ah LiFePO4 leisure battery, DC-DC charging and associated 12V wiring/protection. The proposed inverter location is shown in the attached photo (the one with the arrows). During the job, I would like you to review the location and ensure the inverter has adequate airflow/ventilation.

Window box aircon installation

Couple of electrical conduits needing repaired or extend. One is external and had a break in it, exposured to weather, have it covered so rain doesn't get into it. Second is just the water excess from the aircon, not long enough There is a third one, water excess from another aircon, but I don't know what the hell is going on with that. PLEASE NOTE OFFER DOES NOT INCLUDED COST IN FIXING THIRD ISSUE, HAPPY FOR YOU TO COME AND INSPECT AND QUOTE. Also, of the first ones crack is pretty close to the slab to if extra work is needed to fix, happy to discuss quotes. Flexible on times and dates, not time sensitive. Cheers

Job Overview I need the colour-temperature selector switch adjusted on approximately 43 existing LED downlights in a two-storey home. IMPORTANT: The ground-floor ceilings are approximately 3 metres high — considerably higher than a standard residential ceiling. You will need to bring suitable ladder/access equipment for this height. The lights are already installed and fully operational. No replacement fittings or new lights are required. Scope of Work Approximately 25 downlights downstairs 18 downlights upstairs in total, including the 2 located over the staircase Change each downlight from cool white to warm white using the existing selector switch on the fitting Carefully lower each fitting enough to access the switch Change the setting and reinstall the fitting securely and flush with the ceiling Take care not to damage ceilings, paintwork, retaining clips, wiring or fittings Ceiling Height & Stair Access Ground-floor ceiling height is approximately 3 metres, NOT a standard 2.4–2.7m residential ceiling. There are also 2 downlights positioned over the staircase, which will require appropriate equipment and safe access. Please only offer if you have the appropriate ladder/access equipment for the 3m ceilings and the two staircase lights. Please quote for completing the entire job and confirm your availability.

Movex3 light switched 2 inches. Installed 2 power points directly opposite existing power points next room. Replace 6 lights with recess lights. Wire up new 2 extraction fans. Install front outside light. Replace existing back exterior light. Replace 2 fluoro lights with recess lighting.

I need someone with a demo saw / concrete saw to cut a notch into a concrete floor at Palm Beach. - Length: approx 2 metres, straight line - Width: approx 50mm - Depth: approx 30mm (deep enough to seat electrical conduit - happy to take your advice on site) - Purpose: laying electrical conduit into the slab Please bring your own saw, blades, water or dust extraction. Wet cutting or dust-controlled cutting preferred, as this is inside a finished space.

4 x Fans to be replaced 4 x Ceiling Lights to be replaced 4 x Wall light switches to be replaced 1 x electric over install Low set house easy access

Looking for a licensed electrician to inspect and repair/replace 2 x downstairs recessed ceiling lights: * 1 x toilet light – stopped working. * 1 x laundry light – was working but stopped after replacing globes. * Both are older twin E27 recessed fittings. * Existing CFL globes show signs of heat deterioration. * Inspect/test circuit, wiring, connections and fittings to identify cause. * Replace both fittings with suitable modern LED fittings if recommended. * Test and confirm safe operation on completion.

I need someone to inspect and repair the electrical wiring on my 4x6 box trailer. The trailer plug is damaged and the lead/wiring may need to be replaced. I do not have a replacement lead or plug, so the successful tasker will need to supply any required parts. The job includes: * Inspecting the trailer wiring and lights * Replacing the damaged plug and lead if required * Repairing any damaged wiring * Testing all indicators, brake lights and tail lights to ensure everything works correctly Please include labour and parts in your offer, or clearly state any additional parts costs.

Looking for a licensed electrician to replace a broken ceiling light fitting in my home. The existing fitting appears to be damaged/broken (see photos). I need the old fitting removed, a new standard batten holder or similar installed, and the light tested to ensure it’s safe and working.

We have quite a few light globes out + 2-3 down lights. Just needed new globes put in and wipe over the tracks please. We can supply globes after seeing which ones we need as I don’t think we have enough

Looking for someone to install 8 solar panels on my roof and a 2kw solar inverter.

Looking for someone to install our new outdoor camera security light at our rental property. We already have the camera light, just need someone to securely mount it and set it up. If it requires electrical wiring, you must be a licensed electrician. We’d also appreciate help connecting it to our Wi-Fi and making sure it’s working properly before you leave. Please let me know your experience with installing security camera lights and your availability. Thanks!

Have one power point that needs remounting, another that needs replacing.