Find local power point installers near you

I want to install a motorised retractable awning which needs a power outlet. There’s an existing outdoor light on the wall. Would it be possible to tap into the existing electrical supply for the light and install a new power point nearby? I’d like the power point to be independently switched from the light. If not, can you let me know whether installing the awning is feasible and where should the electricity from? The closet PowerPoint is vertical to this wall inside 1.5m away.

2- external power points on a deck Easy access to existing points nearby

Install power points for dishwashers

Disconnect and removal of internal pendant lights x3, removal of power points, removal of external flood light, and disconnection of outdoor illuminated signage.

Hi just after a power point change over, you need to supply the power point

I need two outdoor GPOs installed , an outdoor ceiling light installed (I have the light) and install a Unifi Gate Hub which will need low voltage wire. I can supply an install guide and can help with the install of the hub/wiring guide, I just need the physical/electrical side done so you don't need to know anything about the hub to install it. You will need to supply the two outdoor GPOs and the low voltage / ethernet wiring to install the hub. The hub will be in the same room as the switch, so will need less than 10m of ethernet/low voltage wiring.

Need a licensed electrician for my pool equipment area. Work needed: * Install 4 x outdoor/weatherproof power points * Wire up pool heater/heat pump * Run new supply from the main switchboard to pool equipment area * Preferred route is through roof space / under eaves if possible (something like the yellow line in the photo) * Happy to consider a small weatherproof sub-board near the pool gear if that makes more sense Photos attached showing switchboard, equipment area and likely cable route. There’s also an existing double power point on the other side of the pool, with conduit and a cable already running toward the pool equipment area, but it’s currently disconnected. Might be worth checking if any of that can be reused.

I need an electrician to install a power point on my bedroom wall (ideally recessed) and hang a “43 Samsung tv on the wall. The power fuse box is on the other side of the wall.

We need to disconnect a power point permanently and make the wiring safe. There's no need to leave ready for plastering, blank plate, etc just disconnect and make wiring safe.

I have an old surface-mounted GPO that needs replacing. Two old rigid PVC conduits enter from above — the left is the incoming supply and the right continues to another working GPO. The downstream GPO needs to remain connected. Looking for supply and installation of a suitable 10A weatherproof surface-mounted GPO, with any conduit adjustment required for the installation. There is also an ceramic fuse that needs checking and replacing with the fuse wire. Please let me know your quote. Thanks.

Three power points in the wall needing fixing.

One PowerPoint is buzzing and needs replacing, we have a replacement. A second outdoor PowerPoint needs replacing as when one side is off it appears to still be able to be used.

Looking for a licensed electrician to supply and install 1 × double power point. The electrician will need to supply the double power point switch/socket and any other required materials for the installation. Please include parts, labour, installation and testing in your quote. I would also like an invoice/receipt after completion. Thanks!

Looking for a licensed electrician in Fraser Rise to complete the following: * Supply and install 6 x downlights & a dimer switch * Supply and install 1 x new power point * Install my BYD 7kW single-phase EV charger I already have the BYD charger. Looking for everything else to be supplied and installed, including any required cabling, safety switch/RCBO and electrical certificate.

Looking for a licensed electrician available today for a quick job in Botany. All fittings are supplied and on site. Job 1: Ceiling light replacement (x1) • Remove the existing twin fluorescent batten fitting (cover and tubes already off, wiring exposed) • Install the supplied SAL Decord SL2112/40TC LED Oyster (30W, black, dimmable, IP44) Job 2: Power point replacement (x2) • Replace 2 existing grey/silver double power points with the supplied Deta X6 Series Matt Black double power points (quick-fit base) • Same-for-same swap, no new circuits or relocation Requirements: • Must hold a current NSW electrical licence (please include your licence number in your offer) • Must be available to complete today Photos attached of the existing batten, the new light and the new power point.

When I flipped the power point button off, the lights did not turn off. Top right corner of the switch not working. Other 3 are working. See picture attached

Looking for a handyman to help with the following jobs: - Install a new power point - Install a bathroom basin set - Replace/install two door handles I’m flexible with the day and time and can accommodate any availability this week Thanks!

I need a Power Point installed in my 'office' wardrobe by an electrician Refer to pictures

Install two dual power points in wall connecting to existing power supply in wall to power two speakers

I need to relocate a power point about 50cm along the same wall