Find trusted local electricians in North Moreton Bay

Need mains line in to be disconnected to new barge boards can be installed and then reconnected. I believe Energex will need to remove / disconnect from pole? Will need reconnected. Please outline your process inc any indicative fees for energex (we will pay them directly)

Hello! I need to move a light switch. It's currently on the inside of my walk in robe and I need it to be on the outside instead (same wall / area). I've bought Ikea Pax wardrobes that I'm getting delivered soon. I'd like this light switch moved over the next 7 days (and I'm flexible on time / day).

Install 2x 20amp single and 1x 15amp single power point in front wall of my shed. Power board and access is all clear.

I havd a cord that my dog chewed that I’d like an electrician to solder back together for me

Need to add multiple wall sockets. Need to add some in the bedroom and most importantly 20amp power for pool heater. House is a double story build.

Have a pitboss navigator that needs electrical fixed. Have a new orger motor that needs to be fitted and it wont turn on

Qualified electrician to supply and install x2 power points. One to side of kitchen island and one to inside of pantry. Power points to be Clipsal

Our house build at Newport is nearly complete and we should move in end of August. We are going to need a lot of electrical work done and just a quick summary as follows: 1) 3 ceiling fans to be changed 2) Electricity from meter box down to the pontoon and then light and power connected to the pontoon 3) Exterior lights to be installed 4) Camera system to be installed 5) Alarm system to be installed 6) External power point 7) Internal power points 8) Hot water service timer 9) Connect electricity to the pool for pool lights and pool equipment 10) TV points. So as you can see a few days work here. Could you let me know your hourly rate/full day rate. Thanks Peter

Reconnect aircon split piping, regass and test. We are renovating. I cut the refrigerant pipes on a split, crimped the pipes and taped them up after the gas bled out. Now I want to Reconnecting the cut copper refrigerant pipes. There is sufficient piping left on the split to reconnect. Will require brazing new connectors on to reconnect to the split. It will be installed in place prior to the repair. The system will require Pressure testing with dry nitrogen afterwards to check for leaks. Evacuating the system with a vacuum pump to remove air and moisture. Recharging (regassing) the system with the correct type and amount of refrigerant specified by the manufacturer. Testing the unit to ensure correct operating pressures and temperatures. this work must be carried out by a licensed refrigeration and air conditioning technician because handling refrigerants is regulated I'll add some pics later

Installing of 4 wall power sockets and setting up tv on the wall with hidden wires ,12 down lights installed in living and kitchen area

Hi, I’d like to request the installation of three motion sensors for the existing downlights in the new single-storey home. The sensors have already been purchased from Bunnings and are certified, so installation only is required. The existing downlights and wiring are already in place, and there is easy access to the roof space. The sensors are to be installed in the following areas: * One in the hallway * One in the kitchen * One in the living room

I need to put some extra Power points

Subject: Quote Request: Electrical Cable Relocation for Island Bench - Beachmere Hi there I need to relocate the electrical cable for my kitchen island bench by approximately 2.5 m Here are the details of my current setup: • Property Type: Single storey • Cable Path: The cable currently runs under the house and comes up through the floor • Flooring Type: Particle flooring board with tile on the top • Island Bench Location: I want to move the bench from its current position to a new spot roughly 2.5 meters away. • Appliances Affected: Cook top and power points • Site Access: Easy access to underfloor – the house is approx. 90 cm above ground on stilts • Can you provide a quote for this work? Please also include an estimated timeframe for completion and any requirements for a Certificate of Electrical Safety. • I am available for a site inspection on negotiation, and I have a video with the main details Best regards, Sandra Holden

Electric stovetop has been placed in. Just needs the wiring done.

I have a new sauna installed. Just need a 15am heater installed with a plug on the wall

Run power to external power outlet in preparation for spa installation. Site is approx 40 metres from main power board and 8-10m away for swimming pool pump house. Spa being delivered early due to another cancellation, I’m not ready for it but would like to be. Budget is only specified to put a number in the box. All reasonable quotes considered.

Hi we need various electrical work done around the house. Happy to pay by the hour?

I need a licensed electrician to install either a weather proof power point next to my power box or a PowerPoint installed in my power box for an irrigation system

Brand new Thurman hot water system has been plumbed in but power is not getting to the element. Need an electrician to diagnose and fix.

I need a qualified electrician to wire a 15 amp safety switch from the DB to the other side of the garage wall where the 15Amp PowerPoint would be installed. . There may be need for a few small cutouts to get the wiring to the other side of the garage