Find trusted local electricians in Clontarf

Reconnect aircon split piping, regass and test. We are renovating. I cut the refrigerant pipes on a split, crimped the pipes and taped them up after the gas bled out. Now I want to Reconnecting the cut copper refrigerant pipes. There is sufficient piping left on the split to reconnect. Will require brazing new connectors on to reconnect to the split. It will be installed in place prior to the repair. The system will require Pressure testing with dry nitrogen afterwards to check for leaks. Evacuating the system with a vacuum pump to remove air and moisture. Recharging (regassing) the system with the correct type and amount of refrigerant specified by the manufacturer. Testing the unit to ensure correct operating pressures and temperatures. this work must be carried out by a licensed refrigeration and air conditioning technician because handling refrigerants is regulated I'll add some pics later

We have a 3 phase 4 string solar array on the roof of a commercial premises in Clontarf. Flat safe roof with internal roof access via hatch. Water has gotten into one of our fuse boxes and corroded the fuse and fuse holder. I need the fuse box replaced and relocated to underneath the solar panel to better protect it. I have replace all 8 fuses but the inverter is still showing String A3 Defect (Check Generator) Upon looking in the fuse holder, I can see the inside is corroded too.

Looking for an electrician to install 3 new wall lights at locations shown in the photos

Need electrons with contractor licence for conversion of one phase to three with Energex

Replacement of 4 down lights, plug in type not just bulbs. Have lights already to go

I need a licensed electrician to replace a Chandelier light. The ceiling is not high — you can stand on a table to reach the roof, and we also need to remove the existing light hanging. Thanks, Jay

Install a ceiling fan in the outside area and also fix an outside light fitting that is broken

Hi, I’m looking for a licensed electrician to install a Eufy Floodlight Cam 2 Pro at my property. There’s already an existing outdoor light installed, so this would be a replacement installation using the same wiring (I believe) Details: • Replace existing outdoor light with Eufy Floodlight Cam 2 Pro • Wiring already in place • Must be a licensed electrician (for warranty and safety compliance) • Please bring any tools or fittings needed

Retrofitting an under-sink dishwasher and need a new power point installed to supply power to the dishwasher. Have included photo where existing power points are in kitchen.

Electrician Needed Install: 2 downlights (provided) 1 double powerpoint (provided) 1 switch for downlights (provided) Cables are already run (see photos).

I have a Holden cascada and need the electrical work done to pull a trailer. I have all the parts needed to connect everything.

I need an electrician to do the following job: 1. Remove an existing light fixture and install three new DC ceiling fans: two remote-controlled and one with a wall switch for three bedrooms. Two of the bedrooms are on the older side of the house, so I'm not sure what the ceiling material is most likely asbestos. The third bedroom is an extension, so it shouldn't be a problem. I will supply all the ceiling fans. 2. Install one 2.5 kW Mitsubishi Heavy Industries air conditioner in one bedroom and one 6 kW Mitsubishi Heavy Industries air conditioner. The wall where 6kW air conditioner will be installed highly likely asbestos. You will supply the air conditioners. 3. install a light fixture in ensuite with a switch and a power point. 4. Install additional power points: 1 for dishwasher in kitchen, 1 for washmachine in the laundary. Please quote including AirTasker fees. Please don’t change the quote after acceptance.

New induction cooktop install and fit to replace existing cooktop. Inline lamp switch wire repair

Hello, I need to install 7 lights, each with its own switch, and two power outlets in a new extension of my house. Since there is no gyprock yet, it will be easy to run the cables at this stage. - 1 switch with 4 switches and other three individual switches. - it is easy to grab power from the house or there is a subfloor where cables can be passed under from the switchboard to the extension. There are 11 meters from the switchboard to the extension. I will provide the lights (downlights) that need to be installed. I require the Form 12 for artificial lighting(for the certifier). Thank you.

Electrician need to install 4 fog lights on outdoor pole and a few other things around property. Will be 6-7 hours work $50 per hour - Due date: Needs to be done on Tuesday, 9 January 2024

RankArena Aircon is leaking water somewhere from the unit all over the floor - Due date: Flexible

Electrician required to replace five light switches in an older house (1970s). All switches work - simply updating to new switches. Switches are 4 x single, 1 x dual. - Due date: Flexible

I have two old split systems in my house that need replacing. I can buy the new units I need a licensed technician to install them please - Due date: Flexible

Budget just for post. Please quote. Excavate back yard approx 3m wide x 6m long x 700mm deep at deepest point for half in ground pool, spread spoil over remainder of backyard. Electrical trench approx 6-7m total length, 600mm deep. Tight work area, will need mini- excavator. Happy for quote on total or on each trench and pool dig seperately. - Due date: Flexible

2x double external power point on separate circuits. One to be 15A for pool heater. Other can be standard. Location directly under the meter box. Earth aluminium pool fence ~2m from earth rod. Underground conduit already in place. Clamp earth wire to earth rod - Due date: Flexible