Find a trusted local light installation service near you

Caravan skylight installation I need a qualified trade professional or someone experienced to enlarge an existing roof hatch opening and install a new skylight on my caravan. I already have the skylight unit; this is for labour, cutting, and sealing only. Job Details:Roof Material: Composite sandwich panel (Fiberglass skin with foam core). Framing/Wiring: No timber framing or structural modifications are required. No wiring or electrical connections are needed for this job (wiring will be handled later). What You Need to Provide:All necessary cutting tools (jigsaw/router) and masking materials to protect the roof skin from scratches.Premium marine/caravan grade UV-resistant polyurethane sealant (e.g., Sikaflex 291 or 252) to ensure a 100% waterproof seal.Proven experience cutting caravan composite panels and sealing external hatches.Please clean up any foam/fiberglass debris after cutting. Looking for a neat, watertight finish.

After installation of two (maybe three) downlights in ensuite bathroom (on separate switch). I will supply the actual lights.

I’m looking for someone to: * Remove the existing ceiling light * Relocate the wiring above the dining table * Install a new 3-light pendant light * Patch the old ceiling hole (Gyprock/plasterboard) * Sand and repaint the repaired area Please let me know if you can do the whole job and provide a quote. Thank you!

Hi, looking to get a pendant light installed over the island. Pictures attached of both the island and pendant light

I have had some fairy lights installed in my trees in my back yard and they are now strangling the trees, A sissor lift will be needed as some are quite high up. Im on a few acres.They will need to be re adjusted. It is quite a big job.around 12 trees.you will need to organise the sissor lif yourself and take that from the price.

I have had two skylights installed on the roof already but need the internal work done to finish the installation. Details are below. Please be clear if your quote does or doesn't include materials and give a materials estimation cost if it doesn't (I understand paying separately for materials is favoured by some AirTaskers): Skylight 1 - skylight tunnel, photo 1 - Velux VSS C04 Solar 550 x 980 on a pitched roof - Require build and painting of approx 300mm shaft depth skylight tunnel to the skylight - Standard rectangle opening, including timber frame and plaster - Ceiling is plasterboard and 2.4m height at low point of pitch as shown in photo. Skylight 2 - ceiling installation, photo 2 - Velux sun tunnel TWF0K14 with flexible shaft - Require installation in flat ceiling, easy access to tunnel via attic - Ceiling is plasterboard and standard 2.4m height

LED Light Strip Installation Need LED light strips professionally installed? How can install:
• LED strips around ceilings and rooflines
• TV backlighting
• Bedrooms, living rooms, setups, and entertainment areas
• Neat cable management for a clean finish Reliable service with quality workmanship

2 pendant lights need installation from one down light above kitchen bench

Need to install 2 up down coolum lights for our front pillars. Lights have normal plug but the pillar have only sockets with wire provided.

Hi, I’m looking for a licensed electrician to do a small lighting job in a kids bedroom. It’s a single-storey standalone house in Mermaid Waters, with access through the ceiling/roof space as required. Scope: 1. Cut 4 x 90mm ceiling holes 2. Wire and install sockets/downlight points for 4 Philips Hue downlights 3. Remove existing ceiling fan 4. Install a LIFX SuperColour Ceiling Light Model: 38cm White Trim I already have the lights. Need someone who can supply any required electrical fittings, cable, sockets, connectors, etc, unless you prefer I buy them first. Because this is a kids bedroom, I need the room properly protected before work starts — bedding, flooring, etc — and fully cleaned up afterwards, including dust and debris from cutting the ceiling holes. Must be properly licensed and able to complete the job safely and neatly. Flexible with timing. Thanks!

Licensed electrician required to install 2 x Philips Hue Akari downlights in my Melbourne CBD apartment. Scope of works: * Remove 2 existing downlights * Enlarge existing ceiling cut-outs from approximately 63mm to 90mm * Convert existing hard-wired connections to plug-base connections suitable for the new lights * Install 2 x Philips Hue Akari downlights (lights supplied by me) * Test operation and ensure installation complies with Victorian electrical requirements Details: * Apartment with plasterboard ceiling * Existing lights are currently wired directly into the electrical circuit (not plug-based) * New lights require 90mm cut-outs and plug-base connections * Looking for a neat, professional finish with clean cut-outs and no ceiling damage * Licensed electrician only * Please include any parts required (e.g. plug bases) in your quote and advise whether a Certificate of Electrical Safety will be provided

Greetings, I have a single downlight on a switch I would like changed to a pre-existing circuit in my kitchen. And 2x downlights installed in my hallway on the switch the original light that was on, that we changed to the kitchen circuit.

3x white downlights and 2x three spotlight black ceiling lights need to be installed.

Currently has downlight need heating 3in1 heating light installed

Two wall mounted lights installed on wall and connected. They will be installed ons brick wall so there will need to be some conduit run from ceiling. There is easy access to ceiling directly above proposed installation spot. There is also power and a pre existing switches that could also be used

Supply and install a new office LED light that matches existing lights (see photos). Must be licensed electrician.

I need a pendant light installed in my stairway to replace the current fixture. Will need a ladder to access etc. Photos show the stairs and pendant that we are installing. Simple job for an electrician.

Hi, I’m looking for someone to install some lights in my bedroom. It comes with a remote so i would need that to work and to be connected to the switch as well. You will need to come with your own tools since I don’t have any. The last photo is the current light I have.

Electrician required Replace 2 existing outdoor wall lights with new lights.

I have a Philips Hue light, looking to install on an exterior wall. (and remove existing spotlight). There will be lots more to do, but let’s start with one!