Find experienced local carpenters in Forest Hill

We have a large dog and need a doggy door for him. We can't have it in the door, has to be built into the house wall (weatherboard). The job must be done professionally and finished neatly. Not sure how much it should cost, mentioned price is my best guess for the labour part. Generally would like to find a good builder/ handy man in the area to go to with all building needs, we tend to never run out of them... - Due date: Before Monday, 1 May 2023

** update: more photos to show the timber foundation and one of the corner to show the "rebated" profile of the base. Hello taskers, I need somebody to install a brand new garden shed on top of a timber foundation. The timber foundation has been set up. The edge of the timber foundation was constructed to resemble a rebated profile concrete, enough room to support the frames of the garden shed. The shed itself is a flat pack model from EasyShed with skillion roof, 3000 x 1500 mm size which I've already acquired and had it delivered. I have attached samples of the installation instruction below; nevertheless it would be advantageous if you had experience installing EasyShed. p.s. Airtasker allows only 5 attachment and no PDF is allowed. Pop rivet came with the flatpack however you will need to bring the gun. I have the angle brackets that may be used to bolt the rivet to the surface/ floor of the foundation. The floor is made out of yellow tounge. Please bring your own equipment, including off cut posts of you think the frame needs to be supported during installation. - Due date: Flexible

I need a stand to put the fridge on. Size: (approx.) 55 cm square and 40 cm high. Budget and needs to be discussed. - Due date: Flexible

Plastering required for area shown in photo. Plasterer to get all required material. Just need the gaps closed off because I will be putting a cupboard there. So nothing fancy required Please provide a quote. Needs to be done today 9th Dec - Due date: On 9th December 2022

Custom built floating shoe cabinet https://pin.it/z21ijmz

Hi, I got a new fridge and it is higher than the old one , so it does not fit in my wall cabinet. Looking for an adjustment on the cabinet to match with the fridge’s height. Thanks - Due date: Needs to be done on Tuesday, 29 November 2022

Hi Need to change he laminate at reception desk and kitchen counter urgently. Please provide a quote for supply and install. Thanks - Due date: Needs to be done on Friday, 11 November 2022

I am looking to get an internal door installed. Area size is Height approx 245 cm width is 93 cm. There will be small POP on top to get a door frame installed. I have an existing door which I plan to use. - Due date: Flexible

I have a medium/large kitchen that I believe is genuine wood veneer, although I'll need help from you confirming this! Some cupboards are in great condition, others have damage due to high use and sunlight. I want the cabinetry restored which I imagine will require a lot of sanding and oiling/varnishing. I’m looking to get this done sometime over the next few months.

I have finished building my deck and have leftover decking that I need to be returned to Bunnings for a refund. The drive is only 3 km away, 10 minutes drive. 10 pieces need to be returned. Each piece is 5.4 metres long. Task should not take longer than 30 minutes.

Already installed half way, just need to complete the remainder. Pinnacle 1.51 x 0.77 x 1.9m Grey Garden Shed

1.Remove damaged carpet measuring 105cm x 50 cm and replace with the spare carpet supplied by me 2. Remove carpet stains in some areas. - Due date: Before Tuesday, 14th Dec 2021

I require help to purchase and install this bunnings shed (1.5 x 1.5 x 2). https://www.bunnings.com.au/pinnacle-1-51-x-1-51-x-1-98m-zinc-garden-shed_p0080605 I will also need the tasker's help to purchase and pickup the shed from Bunnings - I will reimbruse this separately.

While doing the building inspection, we found a area underneath the laundry room is termites infested. Need quote for complete treatment for termites

Looking to have a bed headboard built Have a rough sketch with a few custom changes to be added with further discussion Rough size: 150cm W X 110cm H X 18cm L Light coloured wood if possible but not requirement Looking for rough prices

Kennel is 1.4mx1.4m with pallet style panels and 2 sheets of tin for roof which needs to be re-assembled.Labour and fixing screws/bolts is required.

Need to install a lifetime brand storage shed in the backyard. Need concrete base. The shed need to be assembled as well. Size is 2.4m x3m

Experienced person to install cornice in a laundry. 1800mm x 1500mm. 6 internal and 2 external corners. I have the cornice and cornice cement. Bring all other tools. Available from now.

Looking for someone who can suggest an efficient solution to extending the external screens to cover the bottom gap. Council came back with a condition and need to cover it up and provide privacy/prevent overlooking. Council will inspect again and materials don't have to be the same as on-site and the main purpose for doing this is to pass their inspection. Obviously not wanting poor quality being a new build. Believe total over 3 rooms is roughly 9.6m x 0.4

Standard installation of bench top (2.4M). - remove old bench top - cut sink hole - install new bench top