Find experienced local carpenters in Croydon VIC

I’m looking for a tradie to replace weatherboard and basic timber planks on the out side of my house. The main issue is a damaged plank with a hole caused by age, deterioration, and what appears to be birds gradually picking at the wood. The entire plank (vertical) needs replacing/repairing. It is located on the second level which is only an attic, and access is available. See the photos.

Hi, looking to get a bathtub respray / repaired and also a bathroom bench top Thanks Travis TMC Real Estate

Cabinet changes and dishwasher installation is required.

Our cabinet doors under the sink are rotten. Need to fix these or replace all cabinet/drawer doors. Depending on the cost, open to both options.

The kitchen cabinet is fully mouldy and rotten and needs full removal ready for a brand-new cabinet installation. I require the handyman to source, order and supply the new cabinet for me. Only the sink cutout position must stay unchanged. Additionally, several sections of floorboards were damaged by water and require partial replacement. Looking for a single handyman to complete all these jobs together: cabinet removal, supply & fit new cabinet, and partial flooring replacement.

I’m looking to get a quote for repairing and resealing a timber window at my property in Croydon. The window is not cracked, but there is noticeable draught coming through. I believe the issue may be related to worn seals around the frame and possibly aged putty around the glass.

We had a full Kitchen renovation completed a couple of years ago, however we have a large cupboard between the pantry & fridge that needs shelving to allow full use of the space. We would like the shelving to be 300mm wide. The area to covered is 930mm x 600mm x 400mm. This doesn't take into account the width of the shelves themselves. We would prefer the shelves to be fixed rather than adjustable for strength . We would like 2 x matching shelves up the wall, in line with the adjacent pantry.

Custom Timber Tabletop / Desk (Tasmanian Oak or Messmate) Looking for an experienced carpenter or woodworker to build a custom tabletop/desk. Size: 150cm (L) x 75cm (W) Material: Tasmanian Oak or Messmate (open to recommendations) Thickness: Ideally around 25–33mm (happy to discuss) Finish: Smooth, sanded, and sealed (clear or natural finish preferred) Edge: Clean straight edges or slightly rounded (open to options)

My partner and I have put together the cabinet units for our kitchen install. However we need help with the levelling, fillers and fixing the cabinets to the wall etc to complete the process

Water caused small part of door frame and timber floor rotten.

Supply and remove and replace 2m of timber fascia and remove the timber finial.

have cabinets that need to be made that are a flat pack atm from china looking for a cabinet maker to properly build them for us. There are 4 in total with a drawer or top and cabinet underneath see photos

Need someone urgent A Day’s work to complete few tasks - replacements rotted beam on porch, about 3.5 meters - replace window trimming 2 , outside - install finial material is provided, need experience and tools

Looking to get quotes to get the deck re-stained. Please refer to pictures attached. The deck was oiled and 3 coat stain was applied couple of years ago. Approx size - 6M x 4M , couple of steps and one small bench. Apply sanding where necessary, pressure wash and apply 2-3 coats of oil* (Prefer Intergrain Universal Timber Oil Clear) Must have own equipment and experience with decking. Job shall not be rushed, need a gap between 2 coats. * In the quote, advise if it includes the Intergrain oil or not.

I am planning to setup a study and work desk room similar to the one in the attached image. Based on the quote, I can discuss further on the raw materials required. Thanks.

There’s an old water stain on my ceiling — it’s been there for about 10 years, around 1.5 metres long. I’ve already tried using bleach, but it didn’t work. Looking for someone to properly remove or cover the stain and match the ceiling paint colour with the surrounding area, so it looks even and clean again.

I need some one to help a Carpenter doing a reno. Installing beams, cut out a brick wall and installation of a window. Time : around 9am start to 4pm No tools or experience is required altough knowing how to use powered tools is a bonus.

I wish to find someone supply and install my kitchen, bar, WIR cabinets.

Need a section of floorboards replaced in my kitchen space. Need to be as close as possible to the existing timber floorboards. Please let me know the labour and the material costs. I have attached the pictures for reference where the floorboards needs to be installed.

We have an outdoor decking with cable railing balustrade. We want to replace the cable railing with a timber midrail/vertical slats/bottom rail. The posts are all already in place so its mounting the midrails only. I will be able to get all the materials and get it cut to size unless you want to do this yourself. The whole decking adds up to about 9m. What we need: (Cut the midrail to size) Mount the midrail top and bottom about 8cm gaps up the top, 5cm down the bottom Mount the vertical slats about 10mm gaps for privacy Ive added some suggested materials. Open to ideas and advice.