Find a professional local car service in VIC

Toyota Hiace ji roof van need to tint

Pre-Purchase Car Inspection – Mazda 3 / Mazda 6 Description: Looking for an experienced mechanic to carry out a thorough pre-purchase inspection on a Mazda 3 or Mazda 6. I'm currently still looking for the right one to inspect but have a few short-listed ones and am in the process of organising a time to send a mechanic out. I am looking to buy it ASAP so if you're available throughout this week and next week that'd be perfect. Key points to check: Engine, gearbox, and drivetrain condition Suspension and steering Brakes, ABS, and warning lights Service history verification and general maintenance check Signs of previous accidents or structural damage Overall mechanical condition Please bring your own tools and diagnostic equipment as I’m looking for a detailed report. I just want to make sure I buy a car that's reliable and will keep me going for a few years with minimal to no issues. Don't be afraid to shoot me a message or an offer :)

Full service Peugeot 308 2014 1.6l petrol. Spark plugs, oil, filters, brake fluid and trans fluid. I’ll supply parts

Just need old damaged bumper removed and new 1 fitted,will probably need nuts n bolts/screws I can still drive car so coming to you isn’t a problem

I need the bonnet of my Honda CR-V resprayed due to clear coat failure and fading. The paint underneath is intact but the clear coat is peeling/oxidised. No dents or major damage. Scope of work: • Sand back damaged clear coat • Proper prep work (not just spray over) • Prime if required • Base coat colour match • 2K clear coat finish I’m looking for a proper finish. Vehicle located in Berwick VIC 3806.

Business name stickers in 3 sides of the vehicle.

Can bring the vehicle to the location, need to arrange correct windscreen , tools , etc. from your end

I need the sunshade on my 2015 Audi A5 coupe replaced. I’ve got the part and tools, just don’t have the time. Should only take around 30 mins to install. This YouTube video is the exact same process so it shouldn’t be hard: https://youtu.be/px55ZwC5LDs?si=QwL72fgt8V8qNV_t

I need RWC for Renault Trafic. Open for quotes.

The regulator on the rear right hand door of my 2010 Ford Mondeo sedan has failed. The motor operates, but the windows does not go up or down. It slides freely. I have removed the door trim. Just need someone to supply and fit a new regulator.

Need someone to repair a dent and fix the front right bumper on my Toyota Camry. The bumper has come loose near the wheel and there are some scratches and panel damage. Looking for: Dent repair Bumper alignment/fixing Basic touch-up if possible Please send your quote, availability, and experience. Located in Melbourne.

Need to replace thermostat in Holden VE SSV, I'll supply the thermostat.

I need someone to come and just help fit the starter motor I have here and remove the damaged one The reason I need help is I have a bad back my neck in the part so it’s been really difficult and so I left it .. preferably someone who’s done this before but so I’m not teaching them as we go I can assist you and have all the required tools

BMW 1 Series – 2014 model Require a basic maintenance service (oil, filters, general check). Not looking to spend a great deal as the car is planned to be sold mid-year — this is mainly for upkeep rather than a full overhaul. Also need the boot lock issue investigated and repaired, including any wiring faults related to the boot lock warning/error. Looking for a practical, cost-effective solution rather than premium extras.

Regas the air conditioning on a 2009 Holden Astra. The compressor has been checked by a mechanic and is working. No diagnostics or repairs required. Job includes regas, pressure check, and confirmation that cold air is blowing after service. Budget around $130–$150.

Need an oil and oil filter change. I can supply oil and filter.

Require existing (damaged glove box to be removed and the supplied replacement glove box fitted to 2011 Volvo V60.

Bent fender front on front right of my E39. Just needs to be bent back into shape

I’m looking to install an aftermarket head unit in my Nissan Micra 2011 Ti Automatic, along with reverse and front cameras. I have already purchased the Mekede Dudu7 head unit, as well as the cameras, fascia/frame, and all required wiring for installation. According to the manufacturer’s technical support, everything needed for the installation has been provided. However, I’m happy to consult and discuss further if any additional parts or requirements are identified during the process.

Looking to do logbook service, need to be done from home, have plenty of room in garage.