Find a local Tasker to inspect your Audi in VIC

scratch repair & paint touch up

Need to replace the Transmission Neutral Switch in Audi Q7 2012.

I need a new front grille and fog light grilles installed on my 2013 Audi S5 b8.5. A video of the grille install below. Bumper needs to come off to do this job. https://www.youtube.com/watch?v=m2zmWZXvZNw

psint my eheels gloss black

Audi Q7 2012, Q7 3.0TDI quattro, Engine: 3,0L 6 cyl Turbo Diesel, Transmission: 8spd Tiptronic. Not getting 12V to the plug connecting the thermostat. Also getting the following errors I n car. I had brought a Ancel VD700 and saw these errors showing up. P059700 Thermostat Heater Control Circuit,Open U102600 Transmission control module,Read out DTC P085100 Park/Neutral Switch Input Circuit Low P162400 Requirement - malfunction lamp on,active P275400 Transmission Fluid Cooler Control Circuit 00190 Driver exterior door handle touch sensor-Short circuit to ground 00193 Right rear exterior door handle touch sensor Short circuit to ground Looking for someone who can remove all these errors and get back the car to be working again.

Looking for someone experienced with VAG/Audi vehicles to replace the rear brake pads and rotors on my 2015 Audi S3 8V. I will supply: Rear pads Rear rotors Brake fluid The front brakes have already been replaced, but the rears weren’t completed due to the electronic parking brake, so you’ll need the correct scan tool/software to put the EPB into service mode and complete the job properly. Also looking to have the brake fluid swapped/flushed at the same time. Please only offer if you have experience with VAG/Audi brake jobs and the correct equipment for the EPB.

My car was recently repaired by auto electrician and a cooling auxiliary pump leak caused damage to cables. The leak had also gone to the Transmission Neutral Switch and the same needs to be replaced. We have another issue of Engine Coolant Thermostat Heater Control Circuit/Open error. Car: Audi Q7 (2012) Diesel

Need to completely drain the transmission fluid from Audi Q7 2012 (Diesel) and put new transmission fluid. Need to replace the Neutral Transmission Switch. Sort the power supply not coming to the Thermostat Heater and its showing Control Circuit/Open error.

We had an Auxiliary Pump leak causing wire harness damage and the gear not detecting P. This was resolved but we have another issue of Engine Coolant Thermostat Heater Control Circuit/Open error. Car: Audi Q7 (2012) Diesel

I’m looking for a quote for a timing belt replacement on my Audi A1. Vehicle details: Audi A1 8XA/8XF 1.4 TFSI Engine codes: CZCA / CZDD Currently at 97,000km Could you please let me know: • What is included in the quote (water pump, tensioners, coolant etc.) • Whether OEM or aftermarket parts are used • Warranty on parts/labour • Approximate turnaround time

My car was recently repaired by auto electrician and a cooling auxiliary pump leak caused damage to cables. The leak had also gone to the Transmission Neutral Switch and the same needs to be replaced. We have the part ready and need to get the Transmission Neutral Switch changed. Also, getting a glow sign in dash board.

Car doors not locking. Window and door mirrors not working.

Audi Q7 (2012 Model) Car initially started showing error with P not detected for some time, and eventually starting the car. Also started showing Engine Gear Malfunction error. I got a iCarsoft diagnostic tool and got the scanning done for the car and found few errors. P057100 Passive/ Abiogenesis Cruise/Brake Switch (A) Circ. -Malfunction 00658 No Signal/Communication Operating Unit 02115 Implausible Signal Lock Unit For Central Locking Car had not been switching ON for sometime now, and that could be a reason why battery looks discharged. Battery was replaced last year. Looking for a quote which can resolve this errors.

Audi Q7 not starting as it shows put gear in P or N to start. We have replaced the Automatic Transmission Neutral Safety Switch but error still coming. Also shows a coil error display in screen and shows a message that Start / Stop feature not available. Battery was replaced last year.

Audi Q7 not starting as it shows put gear in P or N to start. We have replaced the Automatic Transmission Neutral Safety Switch but error still coming. Also shows a coil error display in screen and shows a message that Start / Stop feature not available.

reverse camera not working

I need my windows tinted with ceramic tint

Looking for an experienced auto electrician or mechanic to diagnose and fix the driver-side electric window on my 2008 Audi A3. The window does not go down when pressing the switch. The car also sometimes shows that the driver door is open even when it’s closed, so it may be related to the door module or wiring.

Looking for an experienced installer to hardwire and install a Thinkware U3000 front and rear 4K dashcam with radar into my 2018 Audi Q7 Hybrid. Scope • Hardwired install with parking mode enabled • Concealed wiring (no visible cables) • Rear camera install and alignment • Radar module setup • Full testing before handover Hybrid and European vehicle experience preferred. Please include your experience with Audi or hybrid installs and availability.

I have new oil and filter but to complete the oil change I think the car needs to be lifted to get under car access. Under car access is required to remove the under engine cover, which will then give access to the engine sump plug. The oil filter is accessible from above. Can drive to you.