Find a professional render repair in Sydney

Job: Cut approx 1m (or less) Channel in Brick Wall + Install Conduit + Render Back to Smooth Finish Hey everyone Always had a good Airtasker experience Just had my TV hung on the wall I need a 1 metre vertical chase (channel) cut into an internal brick wall to run TV cables (sealed power/AV leads) from the floor up to a wall-mounted TV. Scope of Work: • Cut a neat 1m channel into solid brick (approx. 20–25mm wide, 20–25mm deep). • Supply and install PVC conduit (min. 25mm diameter; larger preferred if possible for easier cable pull-through). • Secure conduit with saddles/clips inside channel. • Patch and render back over chase so the wall is flush and ready for paint. • Finish should match existing wall as close as possible please (smooth render, not a lumpy patch job). Important Notes: • Must have own tools (angle grinder with masonry blade, rotary hammer/chisel, PPE). • Dust control preferred (vacuum attachment or drop sheets). • I’ll handle final painting if required, just need it rendered smooth and ready. Job Location : Surry Hills ASAP

Rendering of the front brick fences. Reinstall letterbox supplied by owner prior to work commencing. Repair render gap in garage back window sill. Rendering of left side exposed concrete slab edge (at ground) from the rear of garage to rear of house and render repair the large holes in the wall at upstairs spa pump pipe penetrations on LHS wall. Rendering of back concrete slab edge and render repair above the rear sliding door. Repair rusted corners on the right front balcony. Repair rusted corners above the garage. Repair outside and inside rusted sections in the garage door opening and the bottom of column at garage door. Repair two rusted corners in front of front door from top to bottom. Repair of rusted corners consists of grinding out affected render and set beads. Including all equipment and all materials. Trades only offers please, no contractors or handy person.

Wall has cracked by tree roots underneath. Approx 3m Squared needs rendering repair.

render a wall inside garage

Patch repair wall in city

Wall and window frame needs to be re rendered to be square set. Cornice section also needs to be repaired. Please see photos

We’ve had electrical rough-ins completed in our kitchen, and are now looking for someone to patch and render the walls where channels have been cut for new power points, switches, and cabling. Scope of work: Patch and render wall chases and holes left from electrical rough-ins Smooth finish ready for painting Areas contained to kitchen walls Must provide all tools and materials Paint patched render white Looking for someone experienced with rendering/plaster patching. Thanks!

smasub=ng mounting kit needs to be installed

Removed my security cage today and now a need to render the side of the entry. Its 2.4 high and 20 cm wide.

Remove the cracking render from a 2.5m long windowsill up on the 1st floor. Redo a render coat on the window sill. Paint the surrounding wall to match - width of a single room, ground and first floor (will require some scaffolding) A long second crack in render above entrance doorway to paint over also.

Wall Rendering requires where Wall removed

We need 1 row of bricks laid that is roughly 2-3 metres long. Photo will show what needs to be patched up under ceiling line, the wall is obviously brick above ceiling. We’ve jackhammered for a penetration above ceiling and cracked some off below the ceiling tile line so our task is get a brick layer to lay 1 row of bricks 2-3 metres long. Then to render to cover the chips underneath ceiling tile line. It’s imperative that the work is clean and the work area is protected as there is carpet and it is a finished office building on Bridge Street in the city. Please allow in your price for parking as it’s the city and you’ll need to pay for parking. This is an urgent job, we need it done some time tomorrow if possible. I’m putting this task up again as the brick layer that was supposed to do today pulled out on us.

I’m looking for someone to render a small interior kitchen splash back measuring approximately 3.5 metres long and 600mm high. See pic the condition of the wall now.

Courtyard needs fixing. Render walls and paint, build up one flower bed with bricks, make sides of back door watertight, fix back gate, add mesh to side walls for climbing plants, add strips of timber at back wall, thorough clean up, clean the timber decking floor.

Need a small render patch done.

We have 4 floating book shelves that require to be installed into our terrace wall. A masonry drill is required (which we do not have)

Patch wall render and skim coat small section 200mm wide next to door frame

new oven installed but depth is smaller than previous so not lining up with existing kitchen. Needs to be chocked up and also needs screwed in (so it doesn't slide) and hole repairs in bathroom cement rendered wall above shaver cabinet. Hole done by Electrician to put in new light fixture

Took off roller shutter door and now wall needs to be fixed with render. I’ve put in $5 as I don’t know what the job is worth

The brick and concrete structure needs a repair and refresh.