Find an experienced handyman in South Fremantle

Fuel is coming out of line before carby but carby bowl is bone dry

Large heavy picture to hang inside 2 anchor points. Boat oars to hang outside on brick wall. Old pond needs drain hole to remove rain. Outside door sticking and needs another ? Handle or something. Inside door ill fitting and sticking.

I need someone to remove the existing door handle and install a new Lockwood Keyless Entrance Set (photos attached). The lock needs to be installed on a side door of the house. Details: • Remove the existing door handle (photo marked with red arrow). • Install the new Lockwood Keyless Entrance Set (packaged set shown in photo). • Set new code (to be provided on install date) • Ensure it operates smoothly from both the inside and outside. • Minor adjustments to the door may be needed to fit the new lock (if necessary). Location:South Fremantle Parking: Easy parking available. Timing: Ideally within the next few days, flexible with timing. Please bring: • All necessary tools • Experience with similar lock installations

Our relocatable home has two small decks (wood) with three steps leading up to each deck. The front deck has two wooden hand rails, the, back deck has just one. Each rail fastens to a metal pole at each end with screws. The screws have rusted as have most of the metal poles where the rails join them; one of the rails has come loose at one end and this problem looks certain to spread to all of the rails as the rust slowly spreads. They rails need to be replaced. Please note that this is not exactly super urgent - I have propped up the end that's come loose and it's holding well. Each rail is 40 inches in length (102 cm). Another matter will have me asking your advice as to how to I should go about removing the rust which I've mentioned.

Need existing 40inch screen removed and new one installed.

My dog ripped up a section of carpet and I’m wanting someone to patch it please. Section to replace is approx 15cm x 40cm. I have the spare carpet to use. Based in south Fremantle. Thank you.

My plug in sink is stuck, i need someone to fix it

- putting a ladder / shelf together (I’ve done half of it but am struggling to finish the job!) - putting a mirror up - drilling 2 holes (so I can put some fairy lights up)

Bath needs repairs around the drain hole, some bubbling paint.

Looking for a handy person to do the following. Some are super quick. I've attached photos. In your offer, please specify which jobs you can do (if not all), and quote accordingly. Happy to pay extra for materials. If preferred, you can quote an hourly rate. 1. Repair window lock on sliding window in kitchen (see photo). 2. Install 6x cleats for blind cords before renting out house 3. Fix toilet door - lock does not click into place, so it opens if you push it (see photo of lock) 4. Fix reticulation. We have retic installed at the front of our house and small backyard - both have a leak. (see photo) 5. Replace cover of bathroom extractor fan which has fallen off 6. Replace 2x wooden blind covers that have fallen off (see photo) 7. Drill hooks in brick wall to hang 2 pictures (one behind couch, one in bedroom) 8. Remove aircon vent and give it a quick dust.

We have an existing bling very wide and long (over 3m), that needs to be cut into 2 separate blinds. And then installed. Some hardware will be required to make this work - i.e. brackets, rod cap, pull down chain, etc...

I need a chrome shower rod put up, it’s a 19mm metal tube and may need to be slightly trimmed to size. Also a timber curtain rod in the laundry, will also need to be cut to size

Sections of the plaster board have been removed due to damage from leaking taps. Need to be replaced.

I have an ironman bullbar needs fittkng to 2017 MQ Triton

Install our new clothesline to brick wall

I'm a designer fixing up a garage in Beaconsfield (6162)and turning it into a kids playroom. There is a strip of roof along the boundary wall that needs to be repaired or replaced and fitted with a secret gutter and downpipe. Ideally would happen this weekend or next week if you have time. I'll send some photos now to give you a bit more of an idea!

internal roller ribbon/cord snapped

Cornice is onsite ready. 145mm glass mat. Adhesive is onsite. 3 meter ceiling height. - Due date: Before Thursday, 15 February 2024

We’ve just put in a new double door jamb and need someone to repair the Gyprock bulkhead and re-render the sections above it (not sure on price - negotiable) - Due date: Flexible

Please can you come out to view the garage door and what needs to be done. Bottom slat on the garage door needs replacing/ straightening - Due date: Flexible