Find a professional gate installation in Outer East Melbourne

Need to Mig Weld 4 x Romak Butt gate hinges on 5mm steel gate posts.

I have an existing side gate, currently situated in the middle of the carport, that needs to be removed and relocated to the end of the carport.

2 bedroom unit with 6 heating ducts. One duct in bedroom is not working. I'm looking for someone experienced in this area to assist me please.

Looking for a handyman or carpenter to: • Cut and convert part of existing timber fence into a side gate • Install the gate (approx 1m wide, 1.95m high) for wheelchair-friendly access • Add structural posts as needed • Supply and install a Lockwood-style double cylinder deadlock (see attached example photo) • Ensure the gate is secure and functional from both sides • Fence is approx 4.8m wide and 1.95m high • Location: Wantirna South VIC • Flexible with time, prefer weekend or weekday afternoon Photos of the fence and sample lock provided for reference.

Hi, We're hoping to put up fence at the front of our house. The ideal fence would be aesthetically pleasing and super sturdy. We want an electric sliding gate. Please look at photos for reference. I'll also give you the floor plan so taht you can approximately guess the length the fence needs to be. Material wise we can do wood or composite for front fence, 1 sliding gate and one Walkaway small swing gate. You will also need to install fencing on the sides. Check floor plan to see where the side fences end. For the side fence we can go with colourbond.

Hi there, I have two gates that need some attention: 1. Gate 1 – The hinge is broken and needs to be repaired or replaced so the gate functions properly. 2. Gate 2 – The gate is currently too tight and difficult to open. It needs to be adjusted so it opens and closes smoothly.

My side gate hinges are bent and needs re-welding. The gate has lost its alignment due to this. I am open to a long term solution that will not cost me much. Might be a fresh welding or a new hinges etc

Need a fence fixed, gate fixed and gate stopper reattached. All as per photos. Need to supply and cut wood. Nil painting required.

Colorbond fencing, 17 meters long and 1.5 meters high, including a 3-meter manual sliding gate. Installation includes tracks and a concrete foundation.

I will assist. Need some one who have done this before. I installed the wooden poles and the gates myself from an old set of gates. Left side of the gate tilted and gate cannot close properly. Hinges need to be adjusted so the gate can close properly. It is just hitting the top of the other gate by 2-3 cm. Will need to chisel,saw the pole, chisel the hinge slot,adjust, rehang. Just make the gates close easily.

Want to have remote access to pedestrian gate . Currently there is a camera doorbell installed and there is data and power to the gate. This will Need to be programmed to the dahua screen we have installed and app

Electric Swing Gate is working fine. Motor seems to be working. However doesn’t close to the end as it get stuck towards the end. It seems to be dropped and get stuck at the concrete of the driveway. If the gate can be lifted or tighten?

The hinges are pulling away from the wooden frame, with some screws or connections appearing unstable or misaligned.

1. Supply & replace front gate rotten right hand side post (not painted) and Re-position & adjust left hand side gate position + level + angle 2. Supply & install post timber + fence panel on left hand side gate ( not painted) and Adjust gate hinge, pin, lock & level position 3. Fix house wall panel come off on right hand side gate area, Remove & re-install house side gate post, Adjust both gate hinge, level, angle & lock

Install a drive way gate width as pic. Two swing gate with latch. One for 250cm width, the other for 115 width. Height is less than 180cm Post intalled as pic. Prefer metal material and wind resistant. Welcome an estimate offer.

Replacing of sliding gate guide block.

Hi there, I’m looking for a licensed plumber to inspect and identify the cause of low water pressure in my home. The issue is affecting all taps, including showers and kitchen/laundry. I’m located in Ringwood East. Ideally looking for someone available in the next few days. Please bring the tools needed to diagnose the issue — I’m happy to discuss further work or repairs depending on what you find. Let me know your availability and experience. Thanks!

I need a gate installed for my chicken house and a chicken automatic pet door cut to fit and installed along the bottom of it. It will be attached to my tin shed which is at a rental house so minimal damage to it would be preferable. I will buy the gate and chook door when job is confirmed- I’ll add extra $ if you source/ can build a cheaper gate like the one in the pics. (Also I don’t have chickens yet if you’re scared of birds). Thanks! :)

I need someone to install 2 colour bond side panels to my gates. I do not have the material. The person doing the task will need to be qualified and have their own tools and materials. The side panels are to be as high as the gate fixed to the fence. There will also be an opportunity to quote for a full wood fence for the right person between my neighbour and I

We have water coming into our laundry roof whenever it rains.We had gutters cleared but it keeps happening so don't know if there is a broken tile etc, or if our downpipes are blocked.