Find experienced local fencing contractors in Windsor QLD

The glass sections are on top of a low cement rendered wall at the back of the house and the aluminium sections will run through a garden. We may also replace the current boundary aluminum fence which runs along the top of a block wall. I have no idea of the cost to put in under the budget section i'm happy to discuss this with you once you have seen the job

Small wire fencing required under house area to stop animals getting into area

A 5m section needs rebuilding with hard wood pales/posts. The new pales/posts will need painting twice - once before putting up and once after. Others areas of my back and side fences need new hardwood pales and painting these - refer to photos. I will attain the materials and paint required. I estimate this task will take @8 hours.

We are looking for an experienced installer for a residential project in Windsor, Brisbane. Scope of Work: Install a glass fence on a balcony Install glass and aluminium fencing around a swimming pool Install gates and associated hardware as required Requirements: Experience with glass and pool fence installations Own tools and transport preferred Reliable, professional, and attention to detail Familiar with Queensland pool fence compliance requirements Location: Windsor, QLD Start Date: ASAP $10 for inspection only

Looking for a handyman to install two gates all materials will be provided - both gates will need to be approximately 2m width *1.8m high. Some thing similar to attached but a little gate will be wider. I will also be able to assist.

Replace or repair chain wire fence - between 218 & 222 Lutwyche Road, Windsor

I need an 8.5 m timber fence built. I will supply all materials- timber, cement, nails etc. I require someone with insurance and who knows how to build a fence which is. 8.5 m long and 1.8 m high. It needs to match the current fence. 3 post holes need to be dug. The old fence will be removed and disposed of by us. I have attached some photos showing where the fence has fallen and needs to go and the second photo shows the rest of the fence which it will need to match.

Side timber fence between neighbouring property 50m long. Hardwood posts, pine rails x3 rows, pine timber palings 100mm wide and 1.8m high

Hello. We’d like to build a privacy screen across the pool filter as shown in photos. The screen will be made of treated pine (2.1m lengths) and to be at the same height as existing fence. Concreted posts in and palings on rails. Please include time and materials.

Brick fence has been partially knocked down. We have all the bricks .

Repair brick fence . We have all the pieces

I'd like a gate built to connect to the opening of this gate.

We have an existing fence down one side of our house but the palings are on the neighbours side. We want new palings on our side. So we need to get railings and new palings installed on our side. The fence will require two different heights due to the small concrete retaining wall down part of the fence line. 1.8m = roughly 8-9metres 2.4m = roughly 7.2metres We can buy everything and have it delivered to the house if you can provide a list.

Supply and install electric gate to match the fence. If there is enough room we would prefer a sliding gate, otherwise a swing gate.

Need supply install electric gate , fence and arbor

I would like to get my old fence removed, and replaced with an attractive high fence (1.8m) that provides reasonable sound reduction from the main road. Im interested in doing it in either block with expressed posts, hardwood sleepers, or a composite (eg modular wall). I have a ped gate, and need a swinging single driveway gate. The total span is 20m including say 3m for driveway gate and 1m for ped gate. There is an existing sturdy concrete wall that the fence can be mounted on, or mounted to the side of, where the pine fence is currently mounted.

Replace old white ant eaten fence with chain wire fence. Approximately 16 metres by 1.2 high - Due date: Flexible

I have 3 colonial wooden fence palings that need replacing on my front gate. I have the replacements but they will need to be shortened slightly so you will need to bring a saw and some galvanised nails. - Due date: Needs to be done on Saturday, 7 October 2023

I need to secure a layer of mesh over an aluminium pool fence panel to hardwood posts/wooden fence panels on either end. Will need to bring own nail gun and nails to complete job. Should only be 20-30 nails as the fence is 1200 high - Due date: Before Sunday, 10 September 2023

Attach fence rails to existing posts, attach 11 fence panels to rails, adjust picket height on 3 fence panels to continue scolloped pattern. Will pay 300 - Due date: Flexible