Find experienced local fencing contractors in Outer East Melbourne

Install x7 powder coated Aluminium panels and Post's in concrete on flat area out front of house

Need to fix or replace rotten garden timber stairs, pool fence posts x 5, rotten door and window and and front retaining wall

Fence between neighbour is falling over and I am unable to close/open my garden gate

Needing tree neatened up, gardening done, and current fence removed from side of house and a replacement made up in colorbond/metal Can either have a gate or just be straight fence, just need something to secure that side of the house Open to offers, have adjusted task to reflect the whole job needed

Install garden wooden fence

Garden gate needs to be restumpted / repaired.

Needing a garden post cut (see attached photos) and concreted in next to a gap in fence Posts provided just need cutting - Due date: Flexible

Complete fence on two sides of vegetable garden using existing fence panels. Will require 3-4 new wooden posts - Due date: Flexible

I need a handy man to put in a sleeper in my backyard, take some woven fence extension off my fence, repaint my fence and assist with getting the garden looking good as I am selling and it needs to be fixed - Due date: Needs to be done on Wednesday, 20 September 2023

I need to reinstall the gate. Gate used to be before my ford now I need it behind it. You can see attached pics for the same. Also I have existing gate. I don't have any material. Need to install 2 posts to hold the frame and relocate the gate which is on wall. - Due date: Flexible

See photos: the left post of the garden gate had rotten or broken at the root. Some steel support had been used to hold it. The garden door cannot be closed properly. I need the post to be replaced and concreted in. You must set the angle of the post properly so that the gate can be closed properly. The post is 12 X 12 cm, 190 cm above ground.

Supply Security Gate, hardware, uprights. fill side gaps with timber. Instal same Gap- 1.52 m.Wide, Gate width 1 m, Gate height 1.52m. Instal two uprights (red Gum?) Buried and cemented in ground. Lockable from inside. Present gate always unlocked to allow meter reader access. New gate to be past meter, to allow security of property. - Due date: Flexible

I need to build a gate to close 2 areas. In one area one line of 460, but the hight can’t be more then 80. The second area is a square (look photo for measure) - Due date: Flexible

I need a stock standard timber fence, approx 1.63 x 11.5m. Existing fence removed - Due date: Flexible

I have an assortment of star pickets and chicken wire and a gate as well as 2 round posts. The posts and star pickets are currently in the ground and will need to be removed. The posts will need to be moved to the garden area and the fencing constructed to protect the vege beds from our chooks. This is a full-day job, so I've quoted for 8hrs at $50ph + $50 for fees. If you need more, explain why in your offer and I will consider it. I would like this done in the next few weeks, asap. The area is approximately 5m X 10m (a total guess, I'm crap with those things but it's not massive)! - Due date: Flexible

2 Metal panels fixed into place and shrubs removed. - Due date: Flexible

I have had the fence replaced, but would like the original steel frame gate replaced with a wood framed one, I have the pickets, just need the frame made to fit. - Due date: Flexible

Existing Gate to be replaced with the new one ! Need someone to visit, measure and give us quote including all cost. Also need to install fencing panels - can be discussed during the time of visit - Due date: Flexible

Fit retractable fence across driveway. Please see pictures showing driveway and also retractable gate with instructions. Preference will be given to somebody who can do task Friday or Saturday this week. Thanks for considering.

Deliver and help fit three of the temporary fence panels they have around building sites. Preferably 2.1m high ones. They are going in a channel between my house and our Neighbour to stop the dog from escaping

Approx 3 palings on each fence need replacing.

Replace pine lattice. Needs to be done quick.

I have a colour bond gate and I need to relocate it further back.The gate size is 6m x 1.8m

We need to catch up proof our fence with mesh installed to the top. Fence is 14m long.

I have purchased a gate from Bunnings and need it installed to create a separate area for my dog. Requires a timber added to fill the gap. ABN preferred please.

Were looking for someone to install a dog fence in our back yard. So far one side is properly fenced but there’s two sides that would need to be secured - Due date: Flexible

I need a quote for a deer like fencing, it’s just to keep my dogs in need it about 1800 high. Wanting timber posts. Also want a per meter quote. The totally is 195meters to be done. - Due date: Flexible

Instal fence of approx 7mtrs. per picture. Old fences which were removed from the driveway are to be used (pictures and measures provided) Poles and additional fence materials as required for the job to be provided by contractor. - Due date: Flexible

Need help to install cement sheets to fence approx 2 days work,nothing strenous could do myself but lifting into place a problem for 1 person ,using 2.4 x 1.2 sheets ,payment on day $50 per hour - Due date: Flexible

Requiring to relocate the end of a pool fence to veer inwards towards the pool area. This is solely being done to meet government regulations for pool fencing being enforced. Attached is a photo depicting the position the pool fence needs to be in. As U will see the end on the right is slightly to short to reach the position of the end piece. - End piece needs to be bolted to the new position on the concrete slab - the fence piece is slightly too short. To fix that I have 2 X square metal rods that slide into the end of the fence piece. I also have brackets and self tapping metal screws to place on the end piece once it is bolted to the concrete. - to fix the additional gap created with the metal rods extending the fence I just need a singular fence Paling screwed on. I will provide all bits. Just need someone with the tools to do it

Moving 7 temporary fencing panels (2.4m x 2.1m) and 4 bases (approx 25kg each) for building site from Park Orchards to Mitcham.

Dog mesh fence with steel spke post on steep terrain approx 30mts long anda couple of gates made out of same dog mesh - Due date: Before Wednesday, 31 August 2022

My Very friendly bull mastiff cross is an excellent escape artist on an Olympic qualifying level. Need help repairing the fences, material onsite, doesn’t need new fences. Will need power tools. - Due date: Needs to be done on Saturday, 30 July 2022

I am becoming a foster carer for dogs that are in rural pounds and need my fences secured so the dog can’t escape so where they can dig under will need to be blocked and lattice on all the lower fencing so they can’t jump over either. The gate is also an issue. Can be done any day this week.

Inspect and provide required safety certification certificate of existing pool fence. - Due date: Flexible

I have a spa fence that needs to be made compliant for certification. I have an inspection report provided by Metro Pool Inspections detailing work required: 1. The spa needs a solid screen on the pool fence because the spa is within 300mm of the pool fence (perspex or similar attached to inside of fence). 2. The right hand side of the pool fence at the boundary fence needs the timber vertical secured to make the gap between the fence and the pool fence less than 100mm.  3. The left hand pool fence panel needs to be secured into position.  4. The gap under the left hand pool fence panel once secured must be less than 100mm.  5. The gate needs to be adjusted once the left hand pool fence is secured to be self closing and latching from any position including touching with the latch above 1500mm. 6. The boundary fences need to have fence extensions installed to make the fence higher than 2400mm. Work completed must result in spa being compliant. Needs to be completed by next week.

I’m looking for someone to make a steel gate frame and install. I already have 2x powder coated Decorative aluminium gate panels and 2x steel gate posts. Gate frame to be powder coated or hand painted. Approx Gate size is 3.9m x 1.6m (each panel is 1.95m x 1.6m) When quoting specify material thickness, whether frame to be powder coated or hand painted and the provide pictures of the hinges, lock etc - Due date: Flexible

Attached images are from the recommendations of the pool inspector. 1. The clear space between any adjacent vertical members shall not exceed 100mm at any point. (cover with perspex) 2. Outside of the pool fencing has climbable objects (railing) within 900mm clear span measured from the top of the fence. (Cover the railing using 60 degree surface) 3. Where spacing between adjacent vertical members is greater than 10mm, any climbable objects within the fencing shall be separated not less than 300mm. (remove the garden bed and level the ground) 4. Gate shall be self closing and self latching from any position. 5. NCZ5 from the top of the inside of the boundary fence shall be 900mm radius clear. (cover the railing with 60 degree surface) 6. Any climbable objects, steps or level change outside of fencing shall be at least 500mm apart. (remove the garden bed and level the ground up to 500mm from the fencing) Last image is some recommendations. - Due date: Before Sunday, 24 April 2022

Looking for someone to supply and install colorbond fence gate (grey color). Appox 2.9-3 M width and 1.8 M height.

Colorbond fencing, 17 meters long and 1.5 meters high, including a 3-meter manual sliding gate. Installation includes tracks and a concrete foundation.

Almost 20 meter long paling fence to be removed and new colour bond 2 meters high fence to be installed

We need to replace our existing driveway gate to a colorbond double sided gate. Dimensions: 2800w x 1400h

Please quote for removal and install new timber fence 1.95 mts or colour bond fence 2 mts high . 36 mts long

I want to replace my fence with a colour bond fence and add a rolling gate Fence is 18m long plus 3.8m gate opening. And then 1.3m last section.. See photos. Includes removal of old fence and metal gate Install new 2100 high colourbond fence (Monument colour) also install motor for gate as well as

Looking for Colorboard fencing quotes (including all materials)- Colorbond Fencing 2.3 m Height 28.5 meters Length Slipper under bottom Removal of old Timber fence - attached photos. Location - Croydon 3136

Quote for 100-125 m. Colourbond six foot fencing

I need someone to install 2 colour bond side panels to my gates. I do not have the material. The person doing the task will need to be qualified and have their own tools and materials. The side panels are to be as high as the gate fixed to the fence. There will also be an opportunity to quote for a full wood fence for the right person between my neighbour and I

Removal and disposal of rusted corrugated panels and replace with new colorbond panels.

Need 20metre colorbond fence

Need a integrated colorbond gate. Including a simple lock.

Supply and erect approx. 21m of 1.8m high colourbond fence, similar in style to that shown in photo (Quote will need to be agreed with neighbour)

I would like to book a fencer’s service around the 1st week of Dec 24 (from 2 Dec) if possible. See attached photo. Quote 1: (own private space) - New fence in red is 31.1m + 02 timber gate Quote 2: (neighbour fence share) - New fence in red is 12.4m. Quote 3: - 03 tilted posts & a couple of panels to be replaced. Total new fence length: 43.5m Type: Timber pailing or color bond

Remove old timber fence and put in new colorbond fence with sleepers. 30 meters fence plus 1 meter gate.. No neighbours. Corner block property on Scoresby Rd, Bayswater VIC 3153

I need to remove the pailing fence and replace it with a colorbond fence with two sleepers at the bottom (height to be 2.2 meters). Located in Scoresby, the fence is 33 meters long. Please check the pictures for the fence that has to be matched up with and completed. Priced to get the quote and discuss.

i think it roughly 16m of fence that needs to be replaced. A boundary fence between me and the neighbour - already have discussed with them. (No rapid set to be used on the posts)

Replace existing old metal fence with Colourbond fence with height 1.8m and length 20m

Hi, I need a colourbond fence plus a motorised gate for a driveway. The length is 6570. Posts will be fixed on concrete driveway and soil. The other one is just one plain colourbond fence of 1830wide, 1800high.

The total length of the fence (include the gate) is 32 meters, encompassing the perimeter of the yard with the following dimensions: 6.5 meters on the left side, 13.5 meters across the front, and 7 meters on the right side. Additionally, the pedestrian gate approximately 1 to 1.5 meters wide on the left side, and a manual driveway gate (3.5m) across the front. The fence height should be 1.2 meters. The current yard is a plain lawn with no existing fencing, so there will be no need for removal of an old fence. Please include in your quote the cost of all materials and disposal of any waste generated during the installation. Your proposal should cover the entire project from start to finish. Requirements: Provide all materials and tools necessary for the installation. Dispose of any construction debris and maintain a clean work area.