Find a fence installation professional in South West Perth

- Timber fence removed & disposed (6.5m) - Manor red colourbond (1.8m H) installed with plinth under for all fence length (6.5m). In photo each panel is approx 2.2m + 2.2m + 1.95m. Images marked with “X” is the one needs replacing & last image is some new fence I did which i want the future one to match. Any questions let me know - thanks

We are seeking someone to install paving, capping and footing (for fence) for around our new pool We already have selected the capping and paving Would like you come out and have a look to confirm price before accepting the task please

My colourblind fence have been installed with a gap of about 10cm from bottom of the fence to the ground. I have purchased aluminium plinths (2 off) and need someone to cut and install the plinths under the fence.

Install approx 20m of oscillot cat guard on wooden fence. Straight run, I can assist depending on time you can do it .

Looking for someone to install 2 x gates & a fixed panel section. Both gates are the kits from Oxworks & will require cutting to achieve the required width. Lok latch used as well so must know how to install

I need a wooden gate built (and installed if possible). Gate must match other gates in the strata complex to keep uniform. 1800mm h 950mm w

Replace 2 x Veranda Posts that have rotted

I am looking to get a side gate installed with a key locking mechanism the width is about 1.8m but will require a proper measurement as well as provision of the gate. I am flexible with the timing but prefer to get it done ASAP.

We have a boken fence panel that need to replaced. It is an asbestos fence.

Looking for someone experienced, reliable & attention to detail to put up approx 14-15 mts of colour fence. Next Tuesday do the hot water system install is protected. Must be sturdy & expertly installed to meet council standards. Include cost of fence & materials Thanks!

I need a grape vine trellis built - i have been unsuccessful in finding any pre made - I have a video that I would inspo from. Roughly 6 metres long, and over 2m high. Happy with something 1 metre wide. It will run along a fence line.

The wooden posts are termite damaged and need replaced and the colourbond fence needs to be drilled back to the posts

Need to repair footplate of glass pool gate and install fence or screen to garden bed

Require 1 custom size glass pool fence panel supplied and installed

Installation of Magna latch lock at fencing gate

Plastic weld mesh type to be affixed to the bottom of a metal fence to keep dog containe within the house yard. Also a small side gate to be installed at the side of the house

About 10 meters, old fence might be asbestos,

There is a gap between my garage wall and the fence. I need someone to come in bring the material and close the gap. The gap needs to be closed with colorbond of the same colour as the existing one. I have attached two images. One is the existing gap. The other one with the grey boxes is how it would look like after the job is finished. Notes: 1. It does not require a flat colorbond. 2. I don't have a preference on how it should be anchored in place either. 3. It is up to you to. It does look like there is not enough space to use a common drill to make holes in the existing fence / garage wall.

Supply and install a manually openable timber vehicle gate and side gate at a property in Coolbellup where an old extension had recently been demolished. The total width of the space is 5.5m and needs to be in line with the front of the house, vehicle portion of the gate ideally 3.6m (no greater) as eventually this will form part of a rear access to a subdivided block. The balance of the gap a timber fence and side gate nearest to the property.

Aluminium slatted installed to brick wall fence