Find a fence installation professional in SA

Unscrew existing good neighbour fence (2 sections) Remove rotted sleepers Replace with concrete sleepers Relay damp proof course barrier Re assemble fence Note that one bottom rail of 1 section of fence is welded to existing fence post, will need to cut to dismantle fence and allow sleeper to slide down, then re weld after

I want to install colorbond side gate. The total width is 2 meter so need single side gate and may require a panel.

Hello! I need 6 t-posts installed. Just need to go into dirt for trellis. You will need to bring sledge hammer or post driver. No holes to be dug. Also need wire run between posts (total of . Wires). You will need wire cutters/pliers. Should be simple...I just dont have the tools or the upper body strength.

The neighbour's ground is higher that ours, and this old fence is not high enough. I want to get a fence extension to provide privacy. This is not a good neighbour fence, so a standard fence topper will not work.

The fence section is 11 Metres long.

Replace 16 lineal metres and internal gate made of brush, with Good Neighbour style fence and gate with lock

Pull down a old fence and replace with new fence pluse post

I require a part of my fence to be installed with the posts as well I have everything you need to install it.

Install Screenline Fence extensions for Colorbond fences (Standard Fence Extension Kit) to my existing Colourbond fence. Extension is 300mm and fence is 22m in length. I already have the kit, all I need is to have it installed.

Looking for an experienced fencing contractor/company to supply and install new fencing and gates and modify an existing fence at a residential property in Ingle Farm SA 5098. Photos of the existing fence and overall front of the property are attached. The new front fence and gates are to match the style, profile and colour of the existing tubular/picket fence as closely as practicable. Scope: 1. Extend existing fence – approx. 10 m a. Existing overall height approximately 1.3 m. b. Existing fence is installed above 1 × 200 × 75 mm concrete sleeper. c. Add 2 additional 200 × 75 mm concrete sleepers. d. Raise/reinstall the existing fence above the new sleepers. e. Target finished overall height approximately 1.7 m. f. Existing panels to be reused where practicable. g. Include any necessary post extensions/replacement, sleeper posts/channels, footings and fixings required for the modified arrangement. 2. New front fence – approx. 7.2 m total frontage a. Supply and install approximately 1.7 m high tubular/picket fencing, matching the existing fence shown in the attached photo. b. Front fence arrangement to incorporate the driveway sliding gate and pedestrian gate below. 3. Sliding driveway gate a. Approximately 3.5 m clear opening. b. Approximately 1.7 m high, matching the fence. c. Sliding gate may run behind/overlap the pedestrian gate/fixed fence section when open. d. Please provide price for manual sliding gate, with motorised/automatic operation shown separately as an option. 4. Pedestrian gate a. Approximately 1.0 m wide × 1.7 m high. b. Match the new fence and sliding gate. c. Pedestrian gate only needs to be accessible when the sliding driveway gate is closed. d. Include hinges, latch/lock and required hardware. Please quote for complete supply and installation, including all materials, labour, posts, footings, sleepers, gate hardware, fixings and disposal of construction waste.

Need to install 2 fence poles

Hi there, was hoping for a quote for one of my gates. Essentially the two hinges have rusted off, so I think the A frame needs replacement whilst the colourbond on its probably reusable.

I’m looking for an experienced fence installer/repairer to repair an existing Colorbond fence that has been affected by strong winds. The fence is approximately: * 19.25 metres long * 1.94 metres high * Approximately 7 posts may need to be repaired/replaced The fence panels themselves are in reasonably good condition, but several of the supporting posts appear to be rusted/corroded around ground level. After the recent strong winds, the fence has become less stable and needs to be properly secured before it gets worse. Work required I would like someone to: * Inspect the complete fence and confirm which posts need replacing. * Remove the damaged/rusted posts where necessary. * Supply and install suitable replacement posts. * Concrete/set the new posts properly. * Straighten and realign the existing fence. * Reattach and secure the existing Colorbond panels/rails. * Make sure the entire fence is stable and able to withstand normal wind conditions. * Remove/dispose of old damaged posts and leave the area tidy. I would prefer to reuse the existing fence panels rather than replace the complete fence unnecessarily. The photos show the current condition, including corrosion around the bottom of at least some of the posts. Location: Elizabeth Park, SA. Please only make an offer if you have experience repairing/installing Colorbond or similar metal fencing. When making an offer, please let me know whether your price includes labour, replacement posts, concrete/fixings and removal of the old materials. I’m happy for you to inspect the fence first if needed before confirming the final cost.

- Drop bolt installation - New gate latch hardware purchased today - Lockable latch installation onto colourbond fence gate

I require temp fencing to be picked up and installed around a commercial area in the Port Augusta CBD.

We need wire installed on the back fence to train the plants we have purchased to climb up the fence. Fence is approx 7m.

14 m fence need to be removed and removed lace with color-bond 1.8 H. Located at valley view

Supply and install 15 meter colour bond fence

Hi I need a small fence piece installed to cover this gap it’s monument fence approximately 400mm wide

I need someone to come measure my gates and grab anything that fits and is sturdy and replace gate will cover expenses ontop, need done asap as have large dogs gate has to be able to hold them in there lay the challenge the gate below failed