Find trusted local electricians in Miranda NSW

Tenant reporting bulb has blown in a ceiling fan. They have apparently replaced the bulb with no luck. Fan still works fine.

Need electrician to quote new lights in and out Not a big job

Need a kings 40” light bar installed on a roof rack platform on my 4x4. I have everything just need it installed may need 2 people

Need some new PowerPoints in kitchen to suit new kitchen electrical work close by already just need to install new PowerPoint in cupboard for microwave

I need an electrician to repair the power lead on my pre-lit Christmas tree. The small green plug that connects the tree lights to the transformer was pulled off. I’ve purchased a replacement plug, but it’s attached to a short length of new wire. What’s needed: Cut the damaged end off the original tree light wire Cut the new wire to remove the plug Join the new plug onto the original wire so it works with the transformer Important: The original wire must be kept, as it splits off to another connector that powers other sections of the tree. This is a low-voltage Christmas light lead.

Pool Heat Pump– Compressor Humming & Shutting Off Likely Capacitor. My pool heat pump has stopped heating properly. The fan still runs, but the compressor makes a loud humming sound for 2–3 seconds, then shuts off, and this cycle repeats. The water temp stays stuck around 23°C even though the system is set to the mid-30s. The unit is 6 years old, and based on symptoms, this is almost certainly a run/start capacitor failure on the compressor side. I need a technician who can: • diagnose the issue • replace the faulty capacitor (likely 30–80 µF depending on model) • check compressor startup and system function • ensure proper heating output

Outside light not working. Changed globe not luck. Brother thinks it might be the batten inside that needs to be replaced. He purchased batten and had someone ready to attend but they cant do for two weeks. Brother needs done before next Friday.

Hi you recently installed a light fitting for a friends neighbour . We have an external light not working . Brother thinks it might be the light batten inside that needs to be replaced. Can you please advise cost to replace the light batten. Would prefer to fix it than replace with new as there are three lights outside all the same and if one has to be replaced it would look odd. Thanks

Install missing LED lighting in ceiling coves. Rectify hot spots and discoloured LEDs in curtain coves (may be completed after opening). Repair render on shopfront, particularly around LED strip lighting. Fix wavy and rippled LED strip lighting around portals.

Need to provide pathway from nbn box outside to living room inside the house OR install fibre cable

Hello, We require an URGENT call-out from a qualified and licensed NSW Electrician to repair a critical light switch at our retail store, in Westfield Miranda. The Issue: The main light switch for our primary optometry room has completely failed. It was working fine and then suddenly stopped, leaving the room without light. This is a critical operational issue as we cannot perform eye tests in this room, impacting our business and staff. The faulty unit is a black, two-gang switch plate containing one push-button switch and one rotary dimmer. The Job: The task is to diagnose and replace the faulty switch to restore full lighting control to the room. The scope of work includes: 1. Attending the site to diagnose the fault (likely a failed switch/dimmer mechanism). 2. Supplying and installing a new, like-for-like replacement switch/dimmer mechanism that fits the existing black faceplate. 3. Re-installing the plate and testing the lights, ensuring both the on/off switch and the dimmer function correctly. Please note: The successful contractor MUST be able to source and supply the correct replacement switch/dimmer mechanism as part of their service. The cost for this part must be included in your offer. Requirements: - MUST be a fully licensed and insured NSW Electrician. - You must have your own tools and diagnostic equipment. - Experience with commercial lighting controls (dimmers) is essential. Location & Timing: Location: Westfield Miranda, 600 KINGSWAY, Miranda, 2228 (exact location will be provided once the task is assigned) When: URGENT - THIS REPAIR MUST BE COMPLETED BY TOMORROW, [17th September]. Please only make an offer if you can commit to completing this job within this specific timeframe. Please provide a comprehensive quote for the complete job. Your offer should include your call-out fee, labour, and the cost of supplying the new switch/dimmer mechanism. Thank you.

I need two points install one moved up the wall the other one on the other side of the wall

I am looking for a fully qualified and licensed electrician to properly duct my bathroom exhaust fan to the exterior of my house. The existing bathroom exhaust fan currently vents moist air directly into the roof space (roof void). I need a professional to install ducting from the fan unit to an appropriate external wall or roof vent, ensuring all moist air is expelled outside. Key Tasks for the Electrician: 1. Assess the best path for the new ducting to an external wall or the roof. 2. Install appropriate insulated flexible or rigid ducting 3. Cut a vent hole in the chosen exterior surface 4. Fit and seal a proper external vent cap/grille 5. Ensure the entire duct run is sealed correctly to prevent air leaks back into the roof space. 6. Test the fan to ensure it is working efficiently and venting air outside Please provide a quote including: -A rough estimate of how long the job will take. -The total cost for parts and labour and anything else.

Needing Light switches and power points in home to be replaced. I will provide all the power points and switches. Just need the labour. - 7 single light switches - 1 double light switch - 2 tv outlet covers - 12 double power points - 2 phone outlet covers

I need someone to clean solar panels and check why they generate very little power, I have wifi connection to the 5kw solis inverter and generated power is very little, 2 storey house located in Miranda. check attached photo

replace old front door sensor with new one plus light bulb or a 2 in 1 sensor

When the above ceiling unit of our ducted air conditioner was replaced, they had to remove the gyprock ceiling (made a square hole 1.5-1.6m x 1m approximately ) and removed the downlight also (we still have those lights and all the wiring). We just need the ceiling closed up again. This is an insurance claim so please quote us and we will get approved by GCU insurance and proceed with the job. Dr Tong Le

Hi. I need an electrician to unplug the old and install the new cooktop and oven. Both electric. No resizing required

My Electrolux dryer makes a knocking sound when it spins . I have figured out it’s the rollers rubber has worn off. I already bought the 4 rollers and tried to put them in myself. But it didn’t work so would like someone to have a look and put them in for me . Here is the Model number EDH903BEWA 9 kg heat pump dryer

We need the electricals assembled for our hot coal sauna. Experienced Professional electricians only.