Find local dishwasher installation experts in NSW

Take out old dish drawer and install the new one. Help me carry the old one outside. Based in Waterloo,free parking on surrounding roads. Must be Friday afternoon between 2pm-5pm.

Bosch F/standing dishwasher to replace Fisher & Paykel Double Dishdrawer currently installed. Item is on site

Experienced dishdrawer installer to install brand new fisher and paykel dishdrawer dishwasher into existing cabinetry, including affixing to cabinetry via drawer removal method. Plumbing connection and power already available, previous dishwasher already removed. Dishwasher has been unpacked and prepared for installation. May need service access hole in cabinetry enlarged with hole saw.

Water is not flowing into the dish drawer Fisher and Paykel single drawer dishwasher

Opening size: 750 mm (H) × 780 mm (W) × 550 mm (D) Appliance size: 410 mm (H) × 599 mm (W) × 573 mm (D) Scope of work (supply + install): Supply and install filler panels to reduce the opening from 780 mm wide to ~600 mm (either one 181 mm filler or two ~90 mm fillers, full height 750 mm). Panels to be melamine/laminate/MDF in a finish as close as possible to the existing cabinetry. Cut a 60 mm service hole in the right side panel (towards the back, ~150 mm up from base) for hoses and power cord. (Optional, preferred): Recess the rear bottom panel by ~40 mm (about 600 mm wide × 60 mm high cut-out) so dishwasher can slide in flush with cabinetry. Ensure neat finish and secure installation ready for plumber to connect appliance. Please include supply of panels, fixings, and any trim pieces in your quote.

Need someone to remove and install a new fisher and paykl Dishdrawer

I have a 10+ year old Fisher & Paykel double-drawer dishwasher. The bottom drawer works fine, but the top drawer has stopped working completely. It used to work intermittently (sometimes yes, sometimes no), so I suspect it’s a wiring issue. Looking for a technician to: Diagnose the issue onsite Advise on repair cost or if it’s worth repairing

Dishwasher not pumping out all water

We have a new dishdrawer that needs a new panel (the controls are inside the drawer and not outside. the photo shows the controls from the old dish drawer).We also need the new panel re-aligned to match the adjacent cabinets. The drawer below it has scratched and needs to be sanded back and re-painted (2pac) The green 2pac colour used here is to match Porter's Half Olive Grove

1. install a brand new Fisher & Paykel DishDrawer™ model DD60SCX9 in a apartment near Maroubra Junction 2. remove the old one.

Top drawer not draining , bottom Drawer now not washing well

My trusty dishdrawer by Fisher & Paykel (Model: DD60SI7) has been playing up recently and has the following symptoms I need someone to look at fixing: 1. Water does not always drain fully after a cycle 2. Dishes aren't cleaned properly and come out still dirty or with residue 3. Dishdrawer beeps randomly during a cycle (6 beeps following a 2 beeps per cadence) 4. Small grey part as part of the spin mechanism has come off - tried to reglue but not enough surface area Would like to keep the unit and repair it. Need someone experienced with fisher & paykel dish drawer systems.

I need 1 x Fisher and Paykel dish drawer installed. The old dishwasher is already removed and the pipes are all ready to go. Only available after 6:30pm tomorrow. Free visitor parking and no lifting or removal required from you! It should be a quick job- I had someone get it ready prior but the dish drawer was too large. My budget is $100

Dishwasher not working keeps on beeping needs servicing

I need someone (licenced plumber) to come and check my existing dishwasher set to quote for the installation, as I need to replace it the F & P double dishdrawer. Preferrably someone who has experienced as F & P apparenlty needs some specific set up . Please estimate cost and is it a free quote? I live in a unit which has a standard Smeg dishwasher already. (built-in under the benchtop, see photo)

Install waste pipes only in dishdrawer. Looking to get done today 31/12 if possible

I am experiencing a malfunction with my Fisher and Paykel DD60D9 Double DishDrawer™ Dishwasher. Over the past two weeks, it has displayed several error codes: F54, F51, and F1. The primary issue arises with the lower drawer, which fails to seal properly, resulting in water leaking into the main pan even when the drawer is empty. I have conducted preliminary checks and confirmed that the actuators and motors are functioning correctly; I removed and rotated them to test their operation. However, I have noticed that the bottom right side of the sealing mechanism does not engage properly, while the left side operates as intended. Additionally, I have cleaned the electrical plugs to remove any oxidation and thoroughly inspected all tubes and pipes for cracks or damage, but found none. Despite these efforts, the sealing issue persists, leading to ongoing leaks.

Our dishdrawer is showing an error message and not draining. Top and bottom drawers have water at the bottom so we suspect a drainage issue.

Top dish drawer not draining. Flooded about 10 cm deep. Showing E1 error message.

Dishdrawer is not powering on at all. Showing no signs of power when I looked at it. But I also noticed it appeared the dishdrawer wasn't completely closed. I'm not sure what is wrong with it. You can see in the image below the dishdrawer.