Find experienced local carpenters in SA

I have an active insurance claim but they won’t fix internal damage u til I fix externals. Outside my wheelhouse, so need help. Small section of rear corner of eaves is damaged and needs replacing/repair. Will require some timber (probably less than 1m) and some eave cladding (1 sheet - I assume?). I can paint myself later. Photos attached. Feel free to ask questions or drop in to inspect. Because of sloping block roof access is easy ( can just walk on). Also have rear yard access from back street.

I need to replace 3 timber inside ceiling, each size about 1.5M long There is a clear and big space inside ceiling and I marked those damaged timber with black spray paint, so it would be easy to find and they are almost in one place I will supply the timber.

Manufacturing of timber doors and windows

Raise 2 small kitchen cabinets and complete cut out for range hood and flue holes.

I recently had a kitchen renovation and wasn't told that the rangehood ducting and concealment wasn't included. So I've had the ducting installed but it now needs to be concealed. The ducting + the old exhaust fan hol needs to be concealed. Would like it done in the coming 4 or 5 days if possible. The options would be a full white panel above the cupboards or a white box installed around the ducting and previous fan hole. However, the previous exhaust fan hole sits out a little bit from the front of the cupboards so any concealment will need to be put on an angle.

Need to replace old timber (approx 1.5m to 2m) that birds chipped away at. Timber will be pre painted, you will just need to cut to size and replace the old one for the new one.

Needing someone to put a (very small) ikea kitchen put together and installed. The room is 2.5 x 2.8m and includes the below: 4 X lower 600mmW cabinets 4 X upper 600mmW cabinets 1x 600mmW cabinet (2mH) 1 × 450mmW tall cabinet (2mH) - integrated fridge - integrated dishwasher - integrated exhaust

We have 2 double door carcasses that need fixing to the ceiling and walls above our fridge. They need to sit inside the alcove flush to celing and walls. Attached to rafters in roof and studs on walls

Small stain in white kitchen benchtop. Need stain removed, polish and resealing

Plans are ready. First fix carpentry

In order to fit my fridge into the space, need some help to: - Remove skirting board on the sides of fridge cavity. ( fridge is 880mm, fridge cavity including skirting board is 900mm) - Either build a small cabinet on top of fridge OR shorten the existing one OR move the cabinet higher. The existing cabinet has been removed but can be reused. The existing cabinet is only a few centimeters long. We were told the hinge mount could be tricky to remove since it is stick to the cavity right now( see photo) - paint the cavity if needed and move the fridge in. Please quote for labour only. Ideas welcome!

Need someone with a track saw or similar to cut and opening in a wooden box. Opening to be as square as possible and roughly 700x700mm. If it can be routed by an experienced person, would appreciate that also but not essential. Router included.

To built the flat pack cabinets as per picture and wash trough for the laundry room.

I have 12 x 3m x 1.2m VJ panels i need installed in 3 walls. There will be cutting required to go around windows and a wall mounted tv. All caulking, patching and painting will be done by me. I just need the install completed Prefer some ine who has previous experience with VJ panel installation

Kitchen cabinet door hinges needs adjusting. Nothing is broken, just hinge adjustment so the doors can close properly

4 Timbers need to be screwed on the back (each as, just follow the instructions), and 2 vents need to be swapped around on most the inside (3 screws in each vent). All material and screws are there

I have two cabinets doors that that need to be attached as the doors have fallen off again. I recently had someone fix it but it has fallen off so I am guessing the holes on the cabinets are too wide so it’s not just simply screwing the hinges again .

I Need to install the door I will be home during the day today or tomorrow and I can help to hold the door if needed. Send your offer please

I have an L shaped cupboard door thats come off, the bottom screws have snapped into the wall I just need the door back on I'm not fussed if the screws are removed or if you just put them in next to it. As long as its functional as it gets opened and closed hundreds of times a day. Otherwise if you can just put the holes in for the new screws I can reattach it myself, I just dont have the tools I need to drill the holes or remove the screws.

Repair rotting timber as pictured in outside eaves, door of house.